SNS5A-5-2R0

S NS5A Non-isolated DC/DC POL converter Total output current Input voltages #of outputs 5A 5V, 12V Single output SPECIAL FEATURES ・Delivers 5A of output Current ・High efficiency ・ Low Output Ripple & Noise ・ Small size and low profile ・Cost-efficient open frame design ・ Single - in - line (SIP) & SMT package ・ Remote ON/OFF ・ Trimmable output voltage via external resistor ・ Output Over current protection ・ Over temperature protection ・ Wide Operating temperature range -40 ℃ ~85 ℃ 22.86mm× 13.97mm × 8.64mm (SIP package) ELECTRICAL SPECIFICATIONS SNS 5A - 5 SIP Packages SNS 5A - 12 SIP Packages ・Efficiency ・ Input voltage range ・Output voltage ・Voltage tolerance ・Line regulation ・Load regulation ・Switching frequency ・ *Ripple & noise ・ MTBF (MIL-HDBK-217F) 94% @ 3.3V 3.0V - 5.5V 1.0V - 3.3V ± 2.0% ± 0.3% ± 0.4% 300KHz 30mVp-p (@3.3V) 1.5 × 10 hrs 6 ・Efficiency ・ Input voltage range ・Output voltage ・Voltage tolerance ・Line regulation ・Load regulation ・Switching frequency ・ *Ripple & noise ・ MTBF( MIL-HDBK-217F) 93% @ 5.0V 10.0V - 14.0V 1.0V - 5.0V ± 2.0% ± 0.3% ± 0.4% 300KHz 50mVp-p (@5V) 1.5 × 10 hrs 6 * Ripple & noise is tested / specif ied over a 20MHz bandwidth and may be reduced with external f iltering. 39 www.powerplaza.com Ordering Information Input 3.0-5.5V 3.0-5.5V 3.0-5.5V 3.0-5.5V 3.0-5.5V 4.5-5.5V 10-14V 10-14V 10-14V 10-14V 10-14V 10-14V Output 1.0V@5A 1.5V@5A 1.8V@5A 2.0V@5A 2.5V@5A 3.3V@5A 1.0V@5A 1.5V@5A 1.8V@5A 2.5V@5A 3.3V@5A 5.0V@5A (12V Input SIP Package only) Maximum Power 5.0W 7.5W 9.0W 10.0W 12.0W 16.5W 5.0W 7.5W 9.0W 12.0W 16.5W 25.0W Ripple&Noise max 30mVp-p 30mVp-p 30mVp-p 30mVp-p 30mVp-p 30mVp-p 50mVp-p 50mVp-p 50mVp-p 50mVp-p 50mVp-p 50mVp-p Efficiency Typ. 82% 87% 88% 89% 91% 94% 78% 84% 85% 89% 91% 93% Model Number SNS5A-5-1R0 SNS5A-5-1R5 SNS5A-5-1R8 SNS5A-5-2R0 SNS5A-5-2R5 SNS5A-5-3R3 SNS5A-12-1R0 SNS5A-12-1R5 SNS5A-12-1R8 SNS5A-12-2R5 SNS5A-12-3R3 SNS5A-12-5R0 SNS DC-DC CONVERTERS 1. Typical at Ta =+25 ℃ u nder nominal line voltage and full load conditions, unless otherwise noted. All models are tested and specified with external input and output capacitors. (Cin=100 ㎌ X2 Cout=10 ㎌ ), These capacitors are necessary to accommodate Our test equitment 2. Ripple & Noise is tested / specified over a 20MHz bandwidth and may be reduced with external filtering. See I/O Filtering 3. These device have no minimum-load requirement and will regulate Under no-load conditions. Regulation specification describe the output voltage deviation as the line voltage or load is varied from its minimum value to either extreme. Pin assignment Single Output (SIP) 1. +Vout 2. Trim 3. COM 4. +Vin 5. ON/OFF Single Outpu (SMT) 1. +Vout 2. Trim 3. COM 4. +Vin 5. ON/OFF Dimensions ※ Bottom view ※ Side view NOTES 1. All dimensions are in inches (mm) 2. Weight : 3.5g or less (SIP) 2.4g or less (SMT) POWER PLAZA 40