BGSX22G2A10E6327XTSA1

SP001646670 BGSX22G2A10 DPDT Antenna Cross Switch Features  RF CMOS DPDT antenna cross switch with power handling capability of up to 36.5 dBm  Suitable for multi-mode LTE and WCDMA multi antenna applications  Ultra-low insertion loss and harmonics generation  0.1 to 6.0 GHz coverage  High port-to-port-isolation  No decoupling capacitors required if no DC applied on RF lines  General Purpose Input-Output (GPIO) Interface  Small form factor 1.15mm x 1.55mm  No power supply blocking required  High EMI robustness  RoHS and WEEE compliant package Description The BGSX22G2A10 RF MOS switch is specifically designed for LTE and WCDMA triple antenna applications. This DPDT offers low insertion loss and low harmonic generation paired with high isolation between RF ports. The switch is controlled via a GPIO interface. The on-chip controller allows power-supply voltages from 2.3V to 3.4V. The switch features direct-connect-to-battery functionality and DC-free RF ports. Unlike GaAs technology, external DC blocking capacitors at the RF Ports are only required if DC voltage is applied externally. The BGSX22G2A10 RF Switch is manufactured in Infineon’s patented MOS technology, offering the performance of GaAs with the economy and integration of conventional CMOS including the inherent higher ESD robustness. The device has a very small size of only 1.15 x 1.55mm2 and a maximum thickness of 0.6mm. Datasheet Summary www.infineon.com Please read the Important Notice and Warnings at the end of this document page 1 of 2 V 1.4 2017-07-12 BGSX22G2A10 DPDT Antenna Cross Switch Block diagram and ordering information Block diagram and ordering information Figure 1 BGSX22G2A10 Block diagram Table 1 Ordering Information Type Package Marking BGSX22G2A10 ATSLP-10-2 XB Trademarks All referenced product or service names and trademarks are the property of their respective owners. Edition 2017-07-12 Published by Infineon Technologies AG 81726 München, Germany © 2017 Infineon Technologies AG. All Rights Reserved. Do you have a question about this document? Email: erratum@infineon.com Document reference ifx1 IMPORTANT NOTICE The information given in this document shall in no event be regarded as a guarantee of conditions or characteristics (“Beschaffenheitsgarantie”) . With respect to any examples, hints or any typical values stated herein and/or any information regarding the application of the product, Infineon Technologies hereby disclaims any and all warranties and liabilities of any kind, including without limitation warranties of non-infringement of intellectual property rights of any third party. In addition, any information given in this document is subject to customer’s compliance with its obligations stated in this document and any applicable legal requirements, norms and standards concerning customer’s products and any use of the product of Infineon Technologies in customer’s applications. The data contained in this document is exclusively intended for technically trained staff. It is the responsibility of customer’s technical departments to evaluate the suitability of the product for the intended application and the completeness of the product information given in this document with respect to such application. For further information on the product, technology, delivery terms and conditions and prices please contact your nearest Infineon Technologies office (www.infineon.com). WARNINGS Due to technical requirements products may contain dangerous substances. For information on the types in question please contact your nearest Infineon Technologies office. Except as otherwise explicitly approved by Infineon Technologies in a written document signed by authorized representatives of Infineon Technologies, Infineon Technologies’ products may not be used in any applications where a failure of the product or any consequences of the use thereof can reasonably be expected to result in personal injury.