IRSM807-045MH

IRSM807-045MH 4A, 500V Half-Bridge Module For Small Appliance Motor Drive Applications Description IRSM807-045MH is a 4A, 500V half-bridge module designed for advanced appliance motor drive applications such as energy efficient fans and pumps. IR's technology offers an extremely compact, high performance halfbridge topology in an isolated package. This advanced IPM offers a combination of IR's low RDS(on) Trench FREDFET technology and the industry benchmark half-bridge high voltage, rugged driver in a small PQFN package. At only 8x9mm and featuring integrated bootstrap functionality, the compact footprint of this surfacemount package makes it suitable for applications that are space-constrained. IRSM807-045MH functions without a heat sink. Features          Integrated gate drivers and bootstrap functionality Suitable for sinusoidal or trapezoidal modulation Low RDS(on) Trench FREDFET Under-voltage lockout for both channels Matched propagation delay for all channels Optimized dV/dt for loss and EMI trade offs 3.3V input logic compatible Active high HIN and LIN Isolation 1500VRMS min IRSM807-045MH Standard Pack Base Part Number IRSM807-045MH 1 www.irf.com Package Type Orderable Part Number Form Quantity Tray 1300 IRSM807-045MH Tape & Reel 2000 IRSM807-045MHTR 32L PQFN 8x9 © 2014 International Rectifier August 13, 2014 IRSM807-045MH Internal Electrical Schematic VB IRSM807-045MH V+ VCC HIN LIN Vs 600V Half Bridge driver with built in bootstrap COM V- Absolute Maximum Ratings Absolute maximum ratings indicate sustained limits beyond which damage to the module may occur. These are not tested at manufacturing. All voltage parameters are absolute voltages referenced to V SS unless otherwise stated in the table. The thermal resistance rating is measured under board mounted and still air conditions. Symbol Description Min Max Unit BVDSS FREDFET Blocking Voltage --- 500 V IO @ TC=25°C DC Output Current --- 4 IOP Pulsed Output Current (Note 1) --- 35 Pd Maximum Power Dissipation per FREDFET @ TC =25°C --- 50 W VISO Isolation Voltage (1min) (Note 2) --- 1500 VRMS TJ Operating Junction Temperature -40 150 °C TL Lead Temperature (Soldering, 30 seconds) --- 260 °C TS Storage Temperature -40 150 °C VS1,2,3 High Side Floating Supply Offset Voltage VB1,2,3 - 20 VB1,2,3 +0.3 V VB1,2,3 High Side Floating Supply Voltage -0.3 500 V VCC Low Side and Logic Supply voltage -0.3 20 V VSS -0.3 VCC+0.3 V VIN Input Voltage of LIN, HIN Note 1: Pulse Width = 100µs, TC =25°C, Duty=1%. Note 2: Characterized, not tested at manufacturing. 2 www.irf.com © 2014 International Rectifier A August 13, 2014 IRSM807-045MH Recommended Operating Conditions Symbol + Description V Positive DC Bus Input Voltage VS1,2,3 High Side Floating Supply Offset Voltage VB1,2,3 Min Max Unit --- 400 V (Note 3) 400 V High Side Floating Supply Voltage VS+12 VS+20 V VCC Low Side and Logic Supply Voltage 12 16.5 V VIN Logic Input Voltage COM VCC V Fp PWM Carrier Frequency --- 20 kHz The Input/Output logic diagram is shown in Figure 1. For proper operation the module should be used within the recommended conditions. All voltages are absolute referenced to COM. The V S offset is tested with all supplies biased at 15V differential. Note 3: Logic operational for Vs from COM-8V to COM+500V. Logic state held for Vs from COM-8V to COM-VBS. Static Electrical Characteristics o (VCC-COM) = (VB-VS) = 15 V. TA = 25 C unless otherwise specified. The VIN and IIN parameters are referenced to VSS and are applicable to all six channels. The VCCUV parameters are referenced to VSS. The VBSUV parameters are referenced to VS. Symbol Description Min Typ Max Units BVDSS Drain-to-Source Breakdown Voltage 500 --- --- V TJ=25°C, ILK=250uA ILKH Leakage Current of High Side FET 10 µA TJ=25°C, VDS=500V ILKL Leakage Current of Low Side FET Plus Gate Drive IC 15 µA TJ=25°C, VDS=500V --RDS(ON) 1.5 TJ=25°C, VCC=10V, Id = 2A 1.7 Ω Drain to Source ON Resistance --- 3 --- TJ=150°C, VCC=10V, Id = 2A (Note 4) VSD Diode Forward Voltage --- 0.85 --- V VHIN/LIN Logic “1” input voltage for HIN and LIN 2.2 --- --- V VHIN/LIN Logic “0” input voltage for HIN and LIN --- --- 0.8 V VCCUV+, VBSUV+ VCC and VBS Supply Under-Voltage, Positive Going Threshold 8 8.9 9.8 V VCCUV-, VBSUV- VCC and VBS supply Under-Voltage, Negative Going Threshold 6.9 7.7 8.5 V VCCUVH, VBSUVH VCC and VBS Supply Under-Voltage Lock-Out Hysteresis --- 0.7 --- V IQBS Quiescent VBS Supply Current VIN=0V --- 45 70 µA IQCC Quiescent VCC Supply Current VIN=0V --- 1100 3000 µA IIN+ Input Bias Current VIN=4V --- 5 20 µA IIN- Input Bias Current VIN=0V --- --- 2 µA --- 200 --- Ω RBR Internal Bootstrap Equivalent Resistor Value Note 4: Characterized, not tested at manufacturing 3 www.irf.com Conditions © 2014 International Rectifier TJ=25°C, Id = 2A TJ=25°C August 13, 2014 IRSM807-045MH Dynamic Electrical Characteristics o (VCC-COM) = (VB-VS) = 15 V. TA = 25 C unless otherwise specified. Symbol Description TON Input to Output Propagation Turn-On Delay Time Min Typ Max Units --- 0.9 1.5 µs Conditions + ID=1mA, V =50V TOFF Input to Output Propagation Turn-Off Delay Time --- 0.9 1.5 µs DT Built-in Dead Time --- 300 --- ns TFIL,IN Input Filter Time (HIN, LIN) --- 300 --- ns Min Typ Max Units --- 209 --- mJ FREDFET Avalanche Characteristics Symbol Description EAS Single Pulse Avalanche Energy (Note 5) Conditions TJ=25°C, L=9.5mH, VDD=150V, IAS=6.7A Note 5: Characterized using TO-220 packaged device Thermal and Mechanical Characteristics Symbol Description Min Typ Max Units Rth(J-CT) Total Thermal Resistance Junction to Case Top (Note 6) --- 25 --- °C/W Rth(J-CB) Total Thermal Resistance Junction to Case Bottom (Note 6) --- 1.55 --- °C/W Conditions Note 6: Calculated Qualification Information† †† Qualification Level Industrial Moisture Sensitivity Level MSL3 ††† Machine Model Class B Human Body Model Class 1C ESD RoHS Compliant Yes † †† Qualification standards can be found at International Rectifier’s web site http://www.irf.com/ Higher qualification ratings may be available should the user have such requirements. Please contact your International Rectifier sales representative for further information. ††† Higher MSL ratings may be available for the specific package types listed here. Please contact your International Rectifier sales representative for further information. 4 www.irf.com © 2014 International Rectifier August 13, 2014 IRSM807-045MH Input-Output Logic Level Table V+ Ho HIN Gate Driver IC U/V/W Lo LIN HIN LIN U,V,W HI LO V+ LO HI 0 HI HI ** LO LO * * V+ if motor current is flowing into VS, 0 if current is flowing out of VS into the motor winding ** Anti Shoot-through protection active (LO, HO are switched off) Referenced Figures VCE IC IC VCE HIN /LIN 50% HIN /LIN 90 % IC 50% VCE 90 % IC 50% HIN /LIN HIN /LIN 50% VCE 10 % IC 10 % IC tr TON Figure 1a. Input to Output propagation turn-on delay time. 5 www.irf.com tf TOFF Figure 1b. Input to Output propagation turn-off delay time. © 2014 International Rectifier August 13, 2014 IRSM807-045MH IF VDS HIN /LIN Irr trr Figure 1c. Diode Reverse Recovery. Figure 1. Switching Parameter Definitions Module Pin-Out Description Pin Name Description 1, 4, 7, 32 COM Low Side Gate Drive Return 2 VCC 15V Gate Drive Supply 3 HIN Logic Input for High Side (Active High) 5 LIN Logic Input for Low Side (Active High) 6 NC Not Connected 8, 9, 10 V- Low Side Source Connection 11 – 19 VS Phase Output 20 – 28 V+ DC Bus 29 – 30 VS Phase Output (-ve Bootstrap Cap Connection) 31 VB High Side Floating Supply (+ve Bootstrap Cap Connection) 32 - To be connected to COM 7 6 5 4 3 2 1 8 31 9 30 32 10 29 11 28 12 27 13 26 14 25 15 24 16 23 17 6 www.irf.com 18 19 20 21 Top view 22 © 2014 International Rectifier August 13, 2014 IRSM807-045MH Package Outline IRSM807-045MH (Bottom View), 1 of 2 Dimensions in mm 7 www.irf.com © 2014 International Rectifier August 13, 2014 IRSM807-045MH Package Outline IRSM807-045MH (Bottom View), 2 of 2 Dimensions in mm 8 www.irf.com © 2014 International Rectifier August 13, 2014 IRSM807-045MH Package Outline IRSM807-045MH (Top & Side View) Dimensions in mm 9 www.irf.com © 2014 International Rectifier August 13, 2014 IRSM807-045MH Top Marking IRSM807-045MH 10 www.irf.com © 2014 International Rectifier August 13, 2014 IRSM807-045MH Revision History Data and Specifications are subject to change without notice IR WORLD HEADQUARTERS: 233 Kansas St., El Segundo, California 90245, USA Tel: (310) 252-7105 TAC Fax: (310) 252-7903 Visit us at www.irf.com for sales contact information Submit Datasheet Feedback 11 www.irf.com © 2014 International Rectifier August 13, 2014