PVN012APBF

Series PVN012APbF Microelectronic Power IC HEXFET® Power MOSFET Photovoltaic Relay Single-Pole, Normally-Open, 0-20V, 4.0A AC / 6.0A DC General Description The PVN012A Series Photovoltaic Relay at 50 milliohms features the lowest possible on-state resistance in a miniature package — lower than a comparable reed relay. The PVN012A is a single-pole, normally open solidstate relay. It utilizes a HEXFET® MOSFET output switch, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED) which is optically isolated from the photovoltaic generator. These units exceed the performance capabilities of electromechanical relays in life, sensitivity, stable onresistance, miniaturization, magnetic insensitivity and ruggedness. They are ideally suited for switching high currents or low level signals without distortion or injection of electrical noise. Series PVN012A relays are packaged in a 6-lead molded DIP package with either thru-hole or surface mount (gull-wing) terminals. They are available in standard plastic shipping tubes or on tape-and-reel. Please refer to part identification information. Features ƒ ƒ ƒ ƒ ƒ ƒ ƒ ƒ 50mΩ On-Resistance Bounce-free Operation 4.0 - 6.0 Amp Capacity Linear AC/DC Operation 4,000 VRMS I/O Isolation Solid-State Reliability UL Recognized ESD Tolerance: 4000V Human Body Model 500V Machine Model Applications ƒ Portable Electronics ƒ Computers and Peripheral Devices ƒ Audio Equipment ƒ Power Supplies and Power Distribution Part Identification ƒ Instrumentation PVN012APbF PVN012ASPbF PVN012AS-TPbF thru-hole surface-mount surface-mount, tape and reel (HEXFET is the registered trademark for International Rectifier Power MOSFETs) 1 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback May 12, 2015 Series PVN012APbF Electrical Specifications (-40°C ≤ TA ≤ +85°C unless otherwise specified) INPUT CHARACTERISTICS Limits Minimum Control Current (see figure 1) Maximum Control Current for Off-State Resistance @ TA = +25°C Control Current Range (Caution: current limit input LED, see figure 6) Maximum Reverse Voltage OUTPUT CHARACTERISTICS Operating Voltage Range Maximum Continuous Load Current @ 40°C, 10mA Control (see figure 1) A Connection B Connection C Connection Maximum Pulsed Load Current @ 25°C,10mA Control (100 mS @ 10% duty cycle) A Connection B Connection C Connection Typical Thermal Resistance (Tthja, Junction-to-Ambient) A Connection B Connection C Connection Maximum On-State Resistance @25°C, 10mA Control 100mA pulsed load, (see figs. 3 & 4) A Connection B Connection C Connection Maximum Off-State Leakage @ TA=+25°C, ±20VDC Maximum Turn-On Time @TA=+25°C (see figure 7), for 1A, 20 VDC load, 10mA Control Maximum Turn-Off Time @TA=+25°C (see figure 7), for 1A, 20 VDC load, 10mA Control Typical Output Capacitance @ 20VDC (see figure 2) GENERAL CHARACTERISTICS Minimum Dielectric Strength, Input-Output Minimum Insulation Resistance, Input-Output Maximum Capacitance, Input-Output, Vd =0V, f = 1MHz Maximum Pin Soldering Temperature Ambient Temperature Range: Operating Storage Units 5.0 0.4 5.0 to 25.0 mA mA mA 6.0 V Limits Units 0 to ±20 V(DC or AC peak) 4.0 4.5 6.0 A (DC or AC) A (DC) A (DC) 8.0 9.0 15.0 A (DC or AC) A (DC) A (DC) 85.1 122.9 89.7 (oC/W) (oC/W) (oC/W) 50 25 15 1.0 3.0 0.5 400 mΩ mΩ mΩ µA ms ms pF Limits Units 4000 1012 1.0 +260 -40 to +85 -40 to +100 VRMS Ω pF °C International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. 2 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback May 12, 2015 Series PVN012APbF Connection Diagrams 1200 "A" Connection I LED = 10mA 4.0 "A" Connection 1000 Typical Capacitance (pF) Max. Load Current (A) 5.0 I LED = 5mA 3.0 2.0 1.0 800 600 400 200 0.0 0 0 20 40 60 80 0 100 5 10 15 20 V DD Drain to Drain Voltage Ambient Temperature (°C) Figure 1. Current Derating Curves* Figure 2. Typical Output Capacitance * Derating of ‘B’ and ‘C’ connections at +85°C will be 70% of that specified at +40°C and is linear from +40°C to +85°C. 2.5 250 "A" Connection 10mA Control ID = 1A Rd-on (Normalized to 25° oC) 200 Voltage Drop (mV) 150 100 50 0 -50 -100 I LED = 10mA 100mS Pulsed, 25°C "A" Connection -150 -200 1.5 1 0.5 0 -250 -10 -8 -6 -4 -2 0 2 4 6 8 10 Load Current (A) Figure 3. Linearity Characteristics 3 2 www.irf.com © 2015 International Rectifier -50 -25 0 25 50 75 100 125 Ambient Temperature (°C) Figure 4. Typical Normalized On-Resistance Submit Datasheet Feedback May 12, 2015 Series PVN012APbF 20 100 CAUTION:provide current limiting so that 25mA maximum steady state control current rating is not exceeded. 16 Input Current (mA) ID-OFF/ ID-OFF 25 °oC 10 1 12 Min. device and +85°C limit 8 TYPICAL Max.device and -40°C limit 4 0 0.1 -35 -15 5 25 45 65 85 0 105 0.5 1 1.5 2 LED Forward Voltage Drop (V DC) Ambient Temperature (°C) Figure 5. Typical Normalized Off-State Leakage Figure 6. Input Characteristics (Current Controlled) Delay Time (milliseconds) 10 ton 1 ILED tdly 90% 0.1 toff ID (10mS Pulse Width, 20V/1A Load) 0.01 5 10 15 20 25 10% tdelay toff ton LED Current (mA) Figure 7. Typical Delay Times 4 www.irf.com © 2015 International Rectifier Figure 8. Delay Time Definitions Submit Datasheet Feedback May 12, 2015 Series PVN012APbF Case Outlines 01-2008 01 01-2009 01 Note: For the most current drawing please refer to IR website at: http://www.irf.com/package/ 5 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback May 12, 2015 Series PVN012APbF Qualification information Qualification level Moisture Sensitivity Level RoHS compliant † Industrial †† (per JEDEC JESD47I guidelines) PVN012APbF N/A PVN012ASPbF MSL4 PVN012AS-TPbF (per JEDEC J-STD-020E & JEDEC J-STD-033C ††) Yes † Qualification standards can be found at International Rectifier’s web site: http://www.irf.com/product-info/reliability †† Applicable version of JEDEC standard at the time of product release Revision History Date 5/11/2015 Comments • Added Qualification Information Table on page 6 • Updated data sheet with new IR corporate template IR WORLD HEADQUARTERS: 101 N. Sepulveda Blvd., El Segundo, California 90245, USA Data and specifications subject to change without notice To contact International Rectifier, please visit http://www.irf.com/whoto-call/ 6 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback May 12, 2015