PVR1300N

Series PVR13NPbF Microelectronic Power IC HEXFET® Power MOSFET Photovoltaic Relay Dual-Pole, Normally-Open, 0-100V AC/DC, 360mA General Description The PVR13 Series AC/DC Relay is a dual-pole, normally open, solid-state replacement for electromechanical relays used for general purpose switching of analog signals. It utilizes International Rectifier’s HEXFET power MOSFETs as the output switches, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED), which is optically isolated from the photovoltaic generator. The PVR13 Series overcomes the limitations of both conventional electromechanical and reed relays by offering the solid state advantages of long life, fast operating speed, low pick up power, bounce-free operation, low thermal offset voltages and miniature package. These advantages allow product improvement and design innovations in many applications such as process control, multiplexing, automatic test equipment and data acquisition. The PVR13 can switch analog signals from thermocouple level to 100 Volts peak AC or DC polarity. Signal frequencies into the RF range are easily controlled and switching rates up to 450Hz are achievable. The extremely small thermally generated offset voltages allow increased measurement accuracies. These relays are packaged in 16-pin, molded DIP packages and available with thru-hole leads, in plastic shipping tubes. ƒ ƒ ƒ ƒ ƒ ƒ ƒ Bounce-Free Operation 1010 Off-State Resistance 1,000 V/µsec dv/dt 0.2 µV Thermal Offset 5 mA Input Sensitivity 1,500 VRMS I/O Isolation Solid-State Reliability Part Identification Applications ƒ ƒ ƒ ƒ Features Process Control Data Acquisition Test Equipment Multiplexing and Scanning PVR1300NPbF PVR1301NPbF (HEXFET is the registered trademark for International Rectifier Power MOSFETs) 1 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015 Series PVR13NPbF Electrical Specifications (-40°C ≤ TA ≤ +85°C unless otherwise specified) INPUT CHARACTERISTICS Units Minimum Control Current A Connection (see figure 1) For 400 Continuous Load Current For 360 Continuous Load Current For 250 Continuous Load Current Minimum Turn-Off Current 2.0 5.0 5.0 10 DC mA@25°C mA@40°C mA@85°C µA(DC) Minimum Turn-Off Voltage 0.6 V(DC) 2.0 to 25 mA(DC) 6.0 V(DC) ±100 V(peak) 360 420 660 mA (peak) mA(DC) mA(DC) Maximum T(on) @ 12mA Control, 100 mA Load, 100 VDC 150 µs Maximum T (off) @ 12mA Control, 100 mA Load, 100 VDC 125 µs 5 3.0 1.5 108 1010 Ω Ω Ω Ω Ω Control Current Range (Caution: current limit input LED. See figure 6) Maximum Reverse Voltage OUTPUT CHARACTERISTICS Units Operating Voltage Range Maxiumum Load Current 40°C ILED = 5mA (see figure 1) AC (A Connection) DC (B Connection) DC (C Connection) Response Time @25°C (see figures 7 and 8) Maximum On-state Resistance 25°C (Pulsed) (fig. 2) 50 mA Load, 5mA Control AC (A Connection) DC (B Connection) DC (C Connection) Minimum Off-state Resistance 25°C @ 80 VDC PVR1300 @ 80 VDC PVR1301 Maximum Thermal Offset Voltage @ 5.0mA Control Minimum Off-State dv/dt Typical Output Capacitance (see figure 9) 0.2 µvolts 1000 V/µs 12 pF @ 50VDC GENERAL CHARACTERISTICS Units Dielectric Strength: Input-Output 1500 V RMS Insulation Resistance: Input-Output @ 500VDC 12 10 Ω Maximum Capacitance: Input-Output 1.0 pF Maximum Lead Soldering Temperature (1.6mm below seating plane for 10 sec.) 260 °C Operating -40 to +85 °C Storage -40 to +100 Ambient Temperature Range: International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. 2 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015 Series PVR13NPbF Max. Load Current (mA) 800 C Connection 700 600 B Connection 500 400 A Connection 300 200 100 ILED = 5mA 0 0 20 40 60 80 100 Ambient Temperature (°C) Ambient Temperature (°C) Figure 1. Current Derating Curve Figure 2. Typical Normalized On-Resistance 550 500 450 400 350 300 250 200 150 100 50 0 25 oC 40 oC 60 oC 85 oC Pulsed, 25ºC I LED = 5mA, Forced Air A Connection 0.0 0.5 1.0 1.5 2.0 2.5 Load Current (mA) 600 Load Current (mA) 5 mA Control lD = 50 mA Rd(on) (Normalized to 25oC) 900 1.3 1.2 1.1 1.0 0.9 0.8 0.7 0.6 0.5 0.4 0.3 0.2 0.1 0.0 25 oC 40 oC 60 oC Pulsed, 25ºC o 85 85ºC C I LED = 5mA, Forced Air C Connection 0.0 0.5 1.0 1.5 2.0 2.5 VDD (Volts) VDD (Volts) Figure 3. Typical On-Characteristic A Connection Figure 4. Typical On-Characteristic C Connection 3 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015 IDOff/IDOff 25°C Input Current (mA) Series PVR13NPbF LED Forward Voltage Drop (Volts DC) Ambient Temperature (°C) Figure 5. Typical Normalized Off-State Leakage Figure 6. Input Characteristics (Current Controlled) Delay Time (µS) 1000 Ton Tdly 100 Toff 10 0 5 10 15 20 ILED (mA) Figure 7.Typical Delay Times 4 www.irf.com © 2015 International Rectifier Figure 8. Delay Time Definitions Submit Datasheet Feedback June 02, 2015 Series PVR13NPbF Typical Capacitance (pF) 220 200 180 160 140 120 100 80 60 C Connection 40 20 0 A Connection 0 10 20 30 40 50 VDD Drain-to-Drain Voltage Figure 9. Typical Output Capacitance Wiring Diagram 5 www.irf.com © 2015 International Rectifier Schematic Diagram Submit Datasheet Feedback June 02, 2015 Series PVR13NPbF Case Outline 01-2012 00 Note: For the most current drawing please refer to IR website at: http://www.irf.com/package/ 6 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015 Series PVR13NPbF Qualification information† Industrial †† (per JEDEC JESD47I guidelines) Qualification level Moisture Sensitivity Level RoHS compliant PVR1300NPbF PVR1301NPbF N/A Yes † Qualification standards can be found at International Rectifier’s web site: http://www.irf.com/product-info/reliability †† Applicable version of JEDEC standard at the time of product release Revision History Date 6/2/2015 Comments • Added Qualification Information Table on page 7 • Updated data sheet with new IR corporate template IR WORLD HEADQUARTERS: 101 N. Sepulveda Blvd., El Segundo, California 90245, USA Data and specifications subject to change without notice To contact International Rectifier, please visit http://www.irf.com/whoto-call/ 7 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015