PVT322APBF

Series PVT322APbF Microelectronic Power IC HEXFET® Power MOSFET Photovoltaic Relay Dual Pole, Normally Open, 0-250V, 170mA AC/DC General Description The PVT322A Series Photovoltaic Relay is a dualpole, normally open solid-state relay that can replace electromechanical relays in many applications. It utilizes International Rectifier’s HEXFET power MOSFET as the output switch, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED) which is optically isolated from the photovoltaic generator. Features HEXFET Power MOSFET output Bounce-free operation 4,000 VRMS I/O isolation Linear AC/DC operation Solid-State Reliability UL Recognized Series PVT322A Relays are packaged in an 8-pin, molded DIP package with either thru-hole or surface mount (gull-wing) terminals. It is available in standard plastic shipping tubes or on tape-and-reel. Please refer to Part Identification information opposite. Applications On/Off Hook switch Part Identification Tip and Ring Line switching PVT322APbF PVT322ASPbF PVT322AS-TPbF General switching thru-hole Surface-mount Surface-mount, Tape and Reel (HEXFET is the registered trademark for International Rectifier Power MOSFETs) 1 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015 Series PVT322APbF Electrical Specifications (-40°C ≤ TA ≤ +85°C unless otherwise specified) INPUT CHARACTERISTICS Limits Units Minimum Control Current (See figure1) Maximum Control Current for Off-State Resistance @TA=+25°C 2.0 0.4 mA mA Control Current Range (Caution: current limit input LED, see figure 5) 2.0 to 25 mA 6.0 V Maximum Reverse Voltage OUTPUT CHARACTERISTICS Operating Voltage Range Maximum Load Current @ TA=+40°C 5mA Control (See figure 1) (single and dual channel operation) Maximum Peak Load Current (10ms maximum duration) (single and dual channel operation) Maximum On-State Resistance @TA=+25°C For 50mA Pulsed load, 5mA Control (see figure 3) Maximum Off-State Leakage @TA=+25°C, ±250V (see figure 4) Maximum Turn-On Time @TA=+25°C (see figure 6) For 50mA, 100 VDC load, 5mA Control Maximum Turn-Off Time @TA=+25°C (see figure 6) For 50mA, 100 VDC load, 5mA Control Maximum Output Capacitance @ 50VDC GENERAL CHARACTERISTICS Minimum Dielectric Strength, Input-Output Minimum Dielectric Strength, Pole-to-Pole Minimum Insulation Resistance, Input-Output, @TA=+25°C, 50%RH, 100VDC Maximum Capacitance, Input-Output Maximum Pin Soldering Temperature (10 seconds maximum) Ambient Temperature Range: Operating Storage International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. 2 www.irf.com © 2015 International Rectifier Limits Units 0 to ±250 V(DC or AC peak) 170 mA 500 mA 8 1.0 3.0 Ω µA ms 0.5 ms 50 pF Limits Units 4000 1000 V RMS V DC 1012 1.0 +260 -40 to +85 -40 to +100 Ω pF °C Connection Diagram Submit Datasheet Feedback June 02, 2015 Series PVT322APbF 200 250 200 ILED = 5 mA 150 150 100 50 100 -3.0 -2.5 -2.0 -1.5 -1.0 -0.5 0.5 2 mA 50 1.0 1.5 2.0 2.5 3.0 -50 -100 -150 0 0 20 40 60 80 100 -200 -250 3 Figure 1. Typical Current Derating Curve Figure 2. Linearity Characteristics Figure 3. Typical Normalized On-Resistance Figure 4. Typical Normalized Off-State Leakage www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015 LED Current (mA) Series PVT322APbF Delay Time (milliseconds) Figure 5. Input Characteristics (Current Controlled) Figure 7. Delay Time Definitions 4 www.irf.com © 2015 International Rectifier Figure 6. Typical Delay Times Figure 8. Typical Output Capacitance Submit Datasheet Feedback June 02, 2015 Series PVT322APbF Note: For the most current drawing please refer to IR website at: http://www.irf.com/package/ 5 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015 Series PVT322APbF Qualification information Qualification level Moisture Sensitivity Level RoHS compliant † Industrial †† (per JEDEC JESD47I guidelines) PVT322APbF N/A PVT322ASPbF MSL4 PVT322AS-TPbF (per JEDEC J-STD-020E & JEDEC J-STD-033C ††) Yes † Qualification standards can be found at International Rectifier’s web site: http://www.irf.com/product-info/reliability †† Applicable version of JEDEC standard at the time of product release Revision History Date 6/2/2015 Comments • Added Qualification Information Table on page 6 • Updated data sheet with new IR corporate template IR WORLD HEADQUARTERS: 101 N. Sepulveda Blvd., El Segundo, California 90245, USA Data and specifications subject to change without notice To contact International Rectifier, please visit http://www.irf.com/whoto-call/ 6 www.irf.com © 2015 International Rectifier Submit Datasheet Feedback June 02, 2015