3GDW62G-F-80N-60.000

EURO QUARTZ Frequency range 750kHz to 800MHz LVDS Output Supply Voltage 3.3 VDC Phase jitter 2.35ps typical Pull range from ±30ppm to ±150ppm GDW62 LVDS VCXO 11.4 x 9.6 x 2.5mm 6 pad SMD VCXO DESCRIPTION GDW62 VCXOs are packaged in a 6 pad 11.4 x 9.6mm SMD package. Typical phase jitter for GDW series VCXOs is 2.35ps. Output is LVDS. Applications include phase lock loop, SONET/ATM, set-top boxes, MPEG , audio/video modulation, video game consoles and HDTV. SPECIFICATION Frequency Range: Supply Voltage: Output Logic: RMS Period Jitter: Peak to Peak Jitter: Phase Jitter: Initial Frequency Accuracy: Output Voltage HIGH (1): Output Voltage LOW (0): Pulling Range: Control Voltage Range: Temperature Stability: Output Load: Rise/Fall Times: Duty Cycle: Start-up Time: Current Consumption: Static Discharge Protection: Storage Temperature: Ageing: Enable/Disable: RoHS Status: OUTLINE & DIMENSIONS 750kHz to 800.0MHz 3.3 VDC ±5% LVDS 4.3ps typical 27.0ps typical 2.35ps typical Tune to the nominal frequency with Vc= 1.65 ±0.2VDC 1.4 Volts typical 1.1 Volts typical From ±30ppm to ±150ppm 1.65 ±1.35 Volts See table 50 into Vdd or Thevenin equiv. 0.5ns typ., 0.7ns max. 20% Vdd to 80% Vdd 50% ±5% (Measured at Vdd-1.3V) 10ms maximum, 5ms typical 55mA typical, 60mA maximum (At 202.50MHz) 2kV maximum -55° to +150°C ±2ppm per year maximum See table Fully compliant or non compliant FREQUENCY STABILITY Stability Code Stability ±ppm Temp. Range A 25 0°~+70°C B 50 0°~+70°C C 100 0°~+70°C D 25 -40°~+85°C E 50 -40°~+85°C F 100 -40°~+85°C If non-standard frequency stability is required Use ‘I’ followed by stability, i.e. I20 for ±20ppm PART NUMBERING Example: 3GDW62G-B-80N-60.000 ENABLE/DISABLE FUNCTION Tristate Pad Status Not connected Below 0.3Vdd (Ref. to ground) Above 0.7Vdd (Ref. to ground) Output Status LVDS and Complimentary LVDS enabled Both outputs are disabled (high impedance) Both outputs are enabled Supply Voltage 3 = +3.3V Series Designator GPW62 RoHS Status G = RoHs compliant Blank = RoHS non-compliant Stability over temperature range (See table) Pullability in ±ppm Pullability determinator N = minimum M = maximum T = Typical Frequency in MHz EUROQUARTZ LIMITED Blacknell Lane CREWKERNE Somerset UK TA18 7HE Tel: +44 (0)1460 230000 Fax: +44 (0)1460 230001 Email: info@euroquartz.co.uk www.euroquartz.co.uk