3GPA64GB-80T-60.000

EURO QUARTZ Frequency range 60MHz to 240MHz LVPECL Output Supply Voltage 3.3 VDC Phase jitter 0.2ps typical Pull range from ±30ppm to ±150ppm DESCRIPTION GPA64 VCXOs are packaged in a 6 pad 11.4 x 9.6mm SMD package. Typical phase jitter for GPA series VCXOs is 0.2 ps. Output is LVPECL. Applications include phase lock loop, SONET/ATM, set-top boxes, MPEG , audio/video modulation, video game consoles and HDTV. GPA64 LVPECL VCXO 11.4 x 9.6 x 4.7mm SMD VCXO OUTLINE & DIMENSIONS SPECIFICATION Frequency Range: Supply Voltage: Output Logic: RMS Period Jitter 60.0MHz ~ 120MHz: 120MHz ~ 240MHz: Peak to Peak Jitter 60.0MHz ~ 120MHz: 120MHz ~ 240MHz: Phase Jitter: Initial Frequency Accuracy: Output Voltage HIGH (1): Output Voltage LOW (0): 60.0MHz to 240.0MHz 3.3 VDC ±5% LVPECL 2.5ps typical 4.7ps typical 17.5ps typical 24.5ps typical 0.2ps typical Tune to the nominal frequency with Vc= 1.65 ±0.2VDC Vdd-1.025V minimum Vdd-0.880V maximum Vdd-1.810V minimum Vdd-1.620V maximum (RL=50 to Vdd-2V) From ±30ppm to ±150ppm 1.65 ±0.35 Volts See table 50 into Vdd or Thevenin equiv. 0.5ns typ., 0.7ns max. 20% Vdd to 80% Vdd 50% ±5% (Measured at Vdd-1.3V) 10ms maximum, 5ms typical 75mA maximum at 212.5MHz 80mA maximum at 622.08MHz 2kV maximum -55° to +150°C ±2ppm per year maximum See table Fully compliant or non-compliant Pulling Range: Control Voltage Range: Temperature Stability: Output Load: Rise/Fall Times: Duty Cycle: Start-up Time: Current Consumption: Static Discharge Protection: Storage Temperature: Ageing: Enable/Disable: RoHS Status: FREQUENCY STABILITY PART NUMBERING Example: Supply Voltage 3 = +3.3V Series Designator GPA64 RoHS Status G = Compliant Blank - Non-compliant Stability over temperature range (See table) Pullability in ±ppm Pullability determinator N = minimum M = maximum T = Typical Frequency in MHz 3GPA64GB-80N-60.000 Stability Code Stability ±ppm Temp. Range A 25 0°~+70°C B 50 0°~+70°C C 100 0°~+70°C D 25 -40°~+85°C E 50 -40°~+85°C F 100 -40°~+85°C If non-standard frequency stability is required Use ‘I’ followed by stability, i.e. I20 for ±20ppm ENABLE/DISABLE FUNCTION Tristate Pad Status Not connected Below 0.3Vdd (Ref. to ground) Above 0.7Vdd (Ref. to ground) Output Status LVPECL and Complimentary LVPECL enabled Both outputs are disabled (high impedance) Both outputs are enabled EUROQUARTZ LIMITED Blacknell Lane CREWKERNE Somerset UK TA18 7HE Tel: +44 (0)1460 230000 Fax: +44 (0)1460 230001 Email: info@euroquartz.co.uk www.euroquartz.co.uk