EUP2627

EUP2627 620kHz/1.25MHz Step-up DC/DC Converter DESCRIPTION The EUP2627 is a high performance current mode, PWM step-up converter with pin selectable operating frequency. With an internal 3.5A, 160mΩ MOSFET, it can generate 12V at up to 500mA output current from a 5V supply. The selectable 620kHz and 1.25MHz allows smaller inductors and faster transient response. An external compensation pin gives the user greater flexibility in setting loop compensation allowing the use of low ESR Ceramic output capacitors. Soft-start is controlled with an external capacitor, which determines the input current ramp rate during start-up. When shut down, it draws ＜ 10µA of current and can operate down to 2.5V input supply. These features along with 1.25MHz switching frequency makes it an ideal device for portable equipment and TFT-LCD displays. The EUP2627 is available in an 10-pin TDFN package. The device is specified for operation over the full -40°C to +85°C temperature range. FEATURES 90% Efficiency 3.5A, 160mΩ Power MOSFET 2.5V to 5.5V Input Range Adjustable Output Voltage up to 28V 620kHz/1.25MHz Switching Frequency Selection Adjustable Soft-Start Internal Thermal Protection Small TDFN-10 package RoHS Compliant and 100% Lead (Pb)-Free APPLICATIONS TFT-LCD Displays DSL Modems Set-Top Boxes PCMCIA Cards Portable Equipment Handheld Devices Typical Application Circuit Figure 1. DS2627 Ver1.0 July 2009 1 EUP2627 Typical Application Circuit (continued) Figure 2. Multiple-Output TFT LCD Power Supply Pin Configurations Pin Configurations Package Type TDFN-10 Pin Description PIN COMP FB SHDN GND TDFN-10 1 2 3 4.5 6.7 8 9 10 DESCRIPTION Compensation pin. Output of the internal error amplifier. Capacitor and resistor from COMP pin to ground. Voltage feedback pin. Internal reference is 1.24V NOMINAL. Connect a resistor divider from VOUT. VOUT=1.24V (1+R1/R2). SW VIN FSEL SS Shutdown control pin. Pull SHDN low to turn off the device. Analog and power ground. Power switch pin. Switch connected to the drain of the internal power MOSFET. Analog power input pin. Frequency select pin. When FSEL is connected to GND, switching frequency is set to 620kHz. When connected to VIN, switching frequency is set to 1.25MHz Soft-start control pin. Connect a capacitor to control the converter start-up DS2627 Ver1.0 July 2009 2