6N135M-V

8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Features • High speed 1Mbit/s • High isolation voltage between input and output (Viso=5000 Vrms ) • Guaranteed performance from 0°C to 70°C • Wide operating temperature range of -55°C to 100°C • Pb free and RoHS compliant • UL approved (No. 214129) • VDE approved (No. 132249) • SEMKO approved • NEMKO approved • DEMKO approved • FIMKO approved • CSA approved (No. 2037145) Description The 6N135, 6N136 and EL4502 devices each consist of an infrared emitting diode, optically coupled to a high speed photo detector transistor. A separate connection for the photodiode bias and output-transistor collector increase the speed by several orders of magnitude over conventional phototransistor couplers by reducing the base-collector capacitance of the input transistor. The devices are packaged in an 8-pin DIP package and available in wide-lead spacing and SMD option. Schematic 1 8 1 8 2 7 2 7 3 6 3 6 4 5 4 5 Applications • Line receivers • Telecommunication equipments • Power transistor isolation in motor drives • Replacement for low speed phototransistor photo couplers • Feedback loop in switch-mode power supplies • Home appliances • High speed logic ground isolation Everlight Electronics Co., Ltd. Document No：DPC-0000018 1 Rev.1 6N135 / 6N136 Pin Configuration 1. No Connection 2. Anode 3. Cathode 4. No Connection 5. Gnd 6. Vout 7. VB 8. VCC EL4502 Pin Configuration 1. No Connection 2. Anode 3. Cathode 4. No Connection 5. Gnd 6. Vout 7. No Connection 8. VCC http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Absolute Maximum Ratings (Ta=25°C) Parameter Input Symbol Rating Unit Forward current IF 25 mA Peak forward current (50% duty, 1ms P.W) IFP 50 mA Peak transient current (≤1μs P.W,300pps) IFtrans 1 A Reverse voltage VR 5 V Power dissipation PIN 45 mW Power dissipation PO 100 mW Emitter-Base reverse voltage 6N135 6N136 VEBR 5 V Base current 6N135 6N136 IB 5 mA Average Output current IO(AVG) 8 mA Peak Output current IO(PK) 16 mA Output voltage VO -0.5 to 20 V Supply voltage VCC -0.5 to 30 V Isolation voltage *1 VISO 5000 V rms Operating temperature TOPR -55 ~ +100 °C Storage temperature TSTG -55 ~ +125 °C Soldering temperature *2 TSOL 260 °C Output Notes *1 AC for 1 minute, R.H.= 40 ~ 60% R.H. In this test, pins 1, 2, 3, 4 are shorted together, and pins 5, 6, 7, 8 are shorted together. *2 For 10 seconds. Everlight Electronics Co., Ltd. Document No：DPC-0000018 2 Rev.1 http://www.everlight.com February 9, 2009 6N135 6N136 EL4502 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER Electrical Characteristics (TA=0 to 70°C unless specified otherwise) Input Parameter Symbol Min. Typ.* Max. Unit Forward voltage VF - 1.45 1.8 V IF = 16mA Reverse Voltage VR 5.0 - - V IR = 10μA ΔVF/ΔTA - -1.9 - mV/°C IF =16mA Symbol Min. Typ.* Max. Unit - 0.001 0.5 - 0.01 1 - - 50 - 140 200 - 0.01 1 Temperature coefficient of forward voltage Conditions Output Parameter Logic High Output Current Logic Low Supply Current Logic High Supply Current IOH ICCL ICCH IF=0mA, VO=VCC=5.5V, TA=25°C µA - 2 IF=0mA, VO=VCC=15V, TA=25°C IF=0mA, VO=VCC=15V µA IF=16mA, VO=Open, VCC=15V IF=0mA, VO=Open, VCC=15V, TA=25°C µA - Conditions IF=0mA, VO=Open, VCC=15V * Typical values at TA = 25°C Everlight Electronics Co., Ltd. Document No：DPC-0000018 3 Rev.1 http://www.everlight.com February 9, 2009 6N135 6N136 EL4502 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER Transfer Characteristics (TA=0 to 70°C unless specified otherwise) Parameter Symbol Min. Typ.* Max. 7 - 50 19 - 50 5 - - 6N136 EL4502 15 - - 6N135 - 0.18 0.4 IF = 16mA ,IO = 1.1mA, VCC=4.5V, TA=25°C 6N136 EL4502 - 0.18 0.4 IF = 16mA ,IO = 3mA, VCC=4.5V, TA=25°C 6N135 6N136 Current Transfer EL4502 Ratio 6N135 Logic Low Output Voltage CTR VOL Unit Conditions IF = 16mA ,VO = 0.4V, VCC=4.5V, TA=25°C % IF = 16mA ,VO = 0.5V, VCC=4.5V V 6N135 - - 0.5 IF = 16mA ,IO = 0.8mA, VCC=4.5V 6N136 EL4502 - - 0.5 IF=16mA ,IO=2.4mA, VCC=4.5V Switching Characteristics (TA=0 to 70°C unless specified otherwise, IF=16mA, Vcc=5V) Parameter Propagation Delay Time to Logic Low (Fig.8) Propagation Delay Time to Logic High (Fig.8) Common Mode Transient Immunity at Logic High (Fig.9)*3 Common Mode Transient Immunity at Logic Low (Fig.9)*3 Symbol 6N135 TPHL 6N136 EL4502 6N135 6N136 EL4502 TPLH 6N135 6N136 EL4502 Typ.* Max. - 0.35 1.5 - - 2.0 - 0.35 0.8 - - 1.0 RL=1.9KΩ - 0.5 1.5 RL=4.1KΩ, TA=25°C - - 2.0 - 0.3 0.8 - - 1.0 1,000 - - CMH 6N135 6N136 EL4502 Min. Unit Conditions RL=4.1KΩ, TA=25°C µs RL=4.1KΩ RL=1.9KΩ, TA=25°C µs RL=4.1KΩ RL=1.9KΩ, TA=25°C RL=1.9KΩ V/µs IF = 0mA , VCM=10Vp-p, RL=4.1KΩ, TA =25°C 1,000 - - IF = 0mA , VCM=10Vp-p, RL=1.9KΩ, TA =25°C 1,000 - - IF = 16mA , VCM=10Vp-p, RL=4.1KΩ, TA =25°C 1,000 - - CML V/µs IF = 16mA , VCM=10Vp-p, RL=1.9KΩ, TA=25°C * Typical values at TA = 25°C Everlight Electronics Co., Ltd. Document No：DPC-0000018 4 Rev.1 http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Typical Performance Curves Everlight Electronics Co., Ltd. Document No：DPC-0000018 5 Rev.1 http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Figure 8 Switching Time Test Circuit & Waveform Figure 9 Transient Immunity Test Circuit & Everlight Electronics Co., Ltd. Document No：DPC-0000018 6 Rev.1 http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Note: *3 Common mode transient immunity in logic high level is the maximum tolerable (positive) dVcm/dt on the leading edge of the common mode pulse signal VCM, to assure that the output will remain in a logic high state (i.e., VO > 2.0V). Common mode transient immunity in logic low level is the maximum tolerable (negative) dVcm/dt on the trailing edge of the common mode pulse signal, VCM, to assure that the output will remain in a logic low state (i.e., VO < 0.8V). Order Information Part Number 6N13XY(Z)-V or EL4502Y(Z)-V Note X Y Z V = Part No. (X = 5 or 6) = Lead form option (S, S1, M or none) = Tape and reel option (TA, TB or none) = VDE (optional) Option Description Packing quantity None Standard DIP-8 45 units per tube M Wide lead bend (0.4 inch spacing) 45 units per tube S (TA) Surface mount lead form + TA tape & reel option 1000 units per reel S (TB) Surface mount lead form + TB tape & reel option 1000 units per reel S1 (TA) Surface mount lead form (low profile) + TA tape & reel option 1000 units per reel S1 (TB) Surface mount lead form (low profile) + TB tape & reel option 1000 units per reel Everlight Electronics Co., Ltd. Document No：DPC-0000018 7 Rev.1 http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Package Drawing (Dimensions in mm) Standard DIP Type Option M Type Everlight Electronics Co., Ltd. Document No：DPC-0000018 8 Rev.1 http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Option S Type Option S1 Type Everlight Electronics Co., Ltd. Document No：DPC-0000018 9 Rev.1 http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Recommended pad layout for surface mount leadform Device Marking EL 6N136 YWWV EL 4502 YWWV Notes 4502 6N136 Y WW V denotes Device Number denotes 1 digit Year code denotes 2 digit Week code denotes VDE (optional) Everlight Electronics Co., Ltd. Document No：DPC-0000018 10 Rev.1 http://www.everlight.com February 9, 2009 6N135 6N136 EL4502 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER Tape & Reel Packing Specifications Option TA Option TB Direction of feed from reel Direction of feed from reel Tape dimensions Dimension No. A B Do D1 E F Dimension(mm) 10.4±0.1 10.0±0.1 1.5±0.1 1.5±0.1 1.75±0.1 7.5±0.1 Dimension No. Po P1 P2 t W K Dimension(mm) 4.0±0.1 12.0±0.1 2.0±0.1 0.4±0.1 16.0+0.3/ -0.1 4.5±0.1 Everlight Electronics Co., Ltd. Document No：DPC-0000018 11 Rev.1 http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 Solder Reflow Temperature Profile 260 °C (peak,10 Sec Max) >255 °C ( 30s Max ) 217°C 1-3 °C/Sec Max 200°C 60 – 140 Sec 150°C 70 – 170 Sec 1-3 °C/Sec Max TIME (S) Everlight Electronics Co., Ltd. Document No：DPC-0000018 12 Rev.1 http://www.everlight.com February 9, 2009 8 PIN DIP HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER 6N135 6N136 EL4502 DISCLAIMER 1. Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification. 2. When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. 3. These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s consent. Everlight Electronics Co., Ltd. Document No：DPC-0000018 13 Rev.1 http://www.everlight.com February 9, 2009