PIR42-21C/L415/TR8

Technical Data Sheet 1.8mm Round Subminiature Infrared LED PIR42-21C/L415/TR8 Features ․Compatible with infrared and vapor phase reflow solder process. ․Low forward voltage ․Good spectral matching to Si photodetector ․Pb free ․The product itself will remain within RoHS compliant version. Descriptions ․PIR42-21C/L415/TR8 is an infrared emitting diode in miniature SMD package which is molded in a water clear plastic with spherical top view lens. ․The device is spectrally matched with silicon photodiode and phototransistor. Applications ․Infrared applied system Device Selection Guide LED Part No. Chip Material Lens Color PIR42-21C/L415/TR8 GaAlAs Water clear Everlight Electronics Co., Ltd. http:\\www.everlight.com Device No：DIR-0000696 Prepared date：20-Mar-2012 Ver.:1 Release Date:04/24/2012 　 Rev 1 Page: 1 of 8 Prepared by：Darren Yu 狀態:Approved(正式發行) PIR42-21C/L415/TR8 Package Dimensions Notes: 1.All dimensions are in millimeters 2.Tolerances unless dimensions ±0.1mm Absolute Maximum Ratings (Ta=25℃) Parameter Symbol Rating Continuous Forward Current IF 65 Units mA Reverse Voltage VR 5 V Operating Temperature Topr -40 ~ +85 ℃ Storage Temperature Tstg -40 ~ +100 ℃ Soldering Temperature Tsol 260 ℃ Power Dissipation at(or below) 25℃Free Air Temperature Pd 170 mW Notes: *1:Soldering time≦5 seconds. Everlight Electronics Co., Ltd. http:\\www.everlight.com Device No：DIR-0000696 Prepared date：20-Mar-2012 Ver.:1 Release Date:04/24/2012 　 Rev 1 Page: 2 of 8 Prepared by：Darren Yu 狀態:Approved(正式發行) PIR42-21C/L415/TR8 Electro-Optical Characteristics (Ta=25℃) Parameter Symbol Condition Min. Typ. Max. Units Radiant Intensity Ie IF=20mA 7 11 -- mW/sr Peak Wavelength λp IF=20mA 720 730 740 nm Spectral Bandwidth Δλ IF=20mA -- 24 -- nm Forward Voltage VF IF=20mA 1.5 1.95 2.3 V Reverse Current IR VR=5V -- -- 10 μA 2θ1/2 IF=20mA -- 30 -- deg View Angle Everlight Electronics Co., Ltd. http:\\www.everlight.com Device No：DIR-0000696 Prepared date：20-Mar-2012 Ver.:1 Release Date:04/24/2012 　 Rev 1 Page: 3 of 8 Prepared by：Darren Yu 狀態:Approved(正式發行) PIR42-21C/L415/TR8 Typical Electro-Optical Characteristics Curves Fig.1 Forward Current vs. Ambient Temperature Fig.2 Spectral Distribution 140 100 IF= 2 0 m A 100 IF= 2 0 m A T a = 2 5 °C T a = 2 5 °C 120 80 80 100 60 60 80 60 40 40 40 20 20 20 0 0 6 70 0 6 9 0 7 1 0 7 3 0 7 5 0 7 7 0 7 9 0 8 1 0 8 3 0 -4 0 -2 0 0 20 40 60 670 690 710 730 750 770 790 810 830 80 100 Fig.3 Relative Intensity vs. Forward Current Everlight Electronics Co., Ltd. http:\\www.everlight.com Device No：DIR-0000696 Prepared date：20-Mar-2012 Ver.:1 Release Date:04/24/2012 　 Rev 1 Page: 4 of 8 Prepared by：Darren Yu 狀態:Approved(正式發行) PIR42-21C/L415/TR8 Typical Electro-Optical Characteristics Curves Fig.4 Relative Radiant Intensity vs. Angular Displacement Precautions For Use 1. Over-current-proof Customer must apply resistors for protection , otherwise slight voltage shift will cause big current change ( Burn out will happen ). 2. Storage 2.1 Do not open moisture proof bag before the products are ready to use. 2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less. 2.3 The LEDs should be used within a year. 2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less. 2.5 The LEDs should be used within 168 hours (7 days) after opening the package. 2.6 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the storage time, baking treatment should be performed using the following conditions. Baking treatment : 60±5℃ for 24 hours. Everlight Electronics Co., Ltd. http:\\www.everlight.com Device No：DIR-0000696 Prepared date：20-Mar-2012 Ver.:1 Release Date:04/24/2012 　 Rev 1 Page: 5 of 8 Prepared by：Darren Yu 狀態:Approved(正式發行) PIR42-21C/L415/TR8 3. Soldering Condition 3.1 Pb-free solder temperature profile 3.2 Reflow soldering should not be done more than two times. 3.3 When soldering, do not put stress on the LEDs during heating. 3.4 After soldering, do not warp the circuit board. 4.Soldering Iron Each terminal is to go to the tip of soldering iron temperature less than 280℃ for 3 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder. 5.Repairing Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Everlight Electronics Co., Ltd. http:\\www.everlight.com Device No：DIR-0000696 Prepared date：20-Mar-2012 Ver.:1 Release Date:04/24/2012 　 Rev 1 Page: 6 of 8 Prepared by：Darren Yu 狀態:Approved(正式發行) PIR42-21C/L415/TR8 Package Dimensions 1.Reel Dimensions 2.Carrier Tape Dimensions:(Quantity: 1000pcs/reel) Unit: mm Everlight Electronics Co., Ltd. http:\\www.everlight.com Device No：DIR-0000696 Prepared date：20-Mar-2012 Ver.:1 Release Date:04/24/2012 　 Rev 1 Page: 7 of 8 Prepared by：Darren Yu 狀態:Approved(正式發行) PIR42-21C/L415/TR8 Packing Procedure L abel A lu m in u m m o is tu e - p r o o f b a g D e s ic c a n t L abel Label Form Specification Notes 1. Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification. 2. When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. 3. These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s consent. EVERLIGHT ELECTRONICS CO., LTD. Office: No 6-8,Zhonghua Rd., Shulin Dist., New Taipei City 23860, Taiwan, R.O.C Tel: 886-2-2685-6688 Fax: 886-2-2685-6897 http://www.everlight.com Everlight Electronics Co., Ltd. http:\\www.everlight.com Device No：DIR-0000696 Prepared date：20-Mar-2012 Ver.:1 Release Date:04/24/2012 　 Rev 1 Page: 8 of 8 Prepared by：Darren Yu 狀態:Approved(正式發行)