24C16

NM24C16/17 – 16K-Bit Standard 2-Wire Bus Interface Serial EEPROM February 2000 NM24C16/17 – 16K-Bit Standard 2-Wire Bus Interface Serial EEPROM General Description The NM24C16/17 devices are 16,384 bits of CMOS non-volatile electrically erasable memory. These devices conform to all specifications in the Standard IIC 2-wire protocol and are designed to minimize device pin count, and simplify PC board layout requirements. The upper half (upper 8Kbit) of the memory of the NM24C17 can be write protected by connecting the WP pin to VCC. This section of memory then becomes unalterable unless WP is switched to VSS. This communications protocol uses CLOCK (SCL) and DATA I/O (SDA) lines to synchronously clock data between the master (for example a microprocessor) and the slave EEPROM device(s). The Standard IIC protocol allows for a maximum of 16K of EEPROM memory which is supported by the Fairchild family in 2K, 4K, 8K, and 16K devices, allowing the user to configure the memory as the application requires with any combination of EEPROMs. In order to implement higher EEPROM memory densities on the IIC bus, the Extended IIC protocol must be used. (Refer to the NM24C32 or NM24C65 datasheets for more information.) Fairchild EEPROMs are designed and tested for applications requiring high endurance, high reliability and low power consumption. Features I Extended operating voltage 2.7V – 5.5V I 400 KHz clock frequency (F) at 2.7V - 5.5V I 200µA active current typical 10µA standby current typical 1µA standby current typical (L) 0.1µA standby current typical (LZ) I IIC compatible interface – Provides bi-directional data transfer protocol I Schmitt trigger inputs I Sixteen byte page write mode – Minimizes total write time per byte I Self timed write cycle Typical write cycle time of 6ms I Hardware Write Protect for upper half (NM24C17 only) I Endurance: 1,000,000 data changes I Data retention greater than 40 years I Packages available: 8-pin DIP, 8-pin SO, and 8-pin TSSOP I Available in three temperature ranges - Commercial: 0° to +70°C - Extended (E): -40° to +85C - Automotive (V): -40° to +125°C Block Diagram VCC VSS WP H.V. GENERATION TIMING &CONTROL START STOP LOGIC CONTROL LOGIC SLAVE ADDRESS REGISTER E2PROM ARRAY SDA SCL XDEC WORD ADDRESS COUNTER R/W YDEC CK DIN DATA REGISTER DOUT DS500072-1 © 1998 Fairchild Semiconductor Corporation NM24C16/17 Rev. G 1 www.fairchildsemi.com NM24C16/17 – 16K-Bit Standard 2-Wire Bus Interface Serial EEPROM Connection Diagrams Dual-in-Line Package (N) and SO Package (M8) NC NC NC VSS 1 2 8 7 VCC NC SCL SDA DS500072-2 TSSOP Package (MT8) NC VCC NC NC 1 2 8 7 SCL SDA VSS NC DS500072-3 NM24C16 3 4 6 5 3 4 NM24C16 6 5 See Package Number N08E, M08A and MTC08 Pin Names VSS SDA SCL NC VCC Ground Serial Data I/O Serial Clock Input No Connection Power Supply Dual-in-Line Package (N) and SO Package (M8) NC NC NC VSS 1 2 8 7 VCC WP SCL SDA DS500072-4 TSSOP Package (MT8) WP VCC NC NC 1 2 8 7 SCL SDA VSS NC DS500072-5 NM24C17 3 4 6 5 3 4 NM24C17 6 5 See Package Number N08E, M08A and MTC08 Pin Names NC VSS SDA SCL WP VCC No Connection Ground Serial Data I/O Serial Clock input Write Protect Power Supply NOTE: Pins designated as "NC" are typically unbonded pins. However some of them are bonded for special testing purposes. Hence if a signal is applied to these pins, care should be taken that the voltage applied on these pins does not exceed the VCC applied to the device. This will ensure proper operation. 2 NM24C16/17 Rev. G www.fairchildsemi.com NM24C16/17 – 16K-Bit Standard 2-Wire Bus Interface Serial EEPROM Ordering Information NM 24 C XX F T LZ E XXX Package Letter N M8 MT8 None V E Blank L LZ Description 8-pin DIP 8-pin SOIC 8-pin TSSOP 0 to 70°C -40 to +125°C -40 to +85°C 4.5V to 5.5V 2.7V to 5.5V 2.7V to 5.5V and