FMB5551

FMB5551 FMB5551 NPN General Purpose Amplifier SuperSOT-6 Surface Mount Package • This device is designed for general purpose high voltage amplifiers and gas discharge display driving. • Sourced from process 16. • See MMBT5551 for characteristics. C2 E1 C1 B2 E2 pin #1 B1 SuperSOTTM-6 Mark: .3S Dot denotes pin #1 Absolute Maximum Ratings Ta=25°C unless otherwise noted Symbol VCEO VCBO VEBO IC PC TJ TSTG RθJA Parameter Collector-Emitter Voltage Collector-Base Voltage Emitter-Base Voltage Collector Current (DC) Collector Dissipation (Ta=25°C) * Junction Temperature Storage Temperature Range Thermal Resistance, Junction to Ambient Value 160 180 6 600 0.7 150 - 55 ~ 150 180 Units V V V mA W °C °C °C/W * Pd total, for both transistors. For each transistor, Pd = 350mW. Electrical Characteristics Ta=25°C unless otherwise noted Symbol Off Characteristics BVCEO BVCBO BVEBO ICBO IEBO hFE Parameter Test Condition IC = 1mA I C = 10µ A I E = 1 0 µA VCB = 120V VCB = 120V, T = 100°C VEB = 4V VCE = 5V, IC = 1mA VCE = 5V, IC = 10mA VCE = 5V, IC = 50mA IC = 10mA, IB = 1mA IC = 50mA, IB = 5mA IC = 10mA, IB = 1mA IC = 50mA, IB = 5mA VCB = 10V, f = 1MHz VCB = 0.5V, f = 1MHz VCE = 10V, IC = 10mA f = 100MHz VCE = 5V, IC = 200µA f = 1MHz, RS = 2kΩ, B = 200Hz VCE = 10V, IC = 1mA f = 1KHz 50 100 80 80 30 Min. 160 180 6 50 50 50 Typ. Max. Units V V V nA µA nA Collector-Emitter Voltage Collector-Base Voltage Emitter-Base Voltage Collector Cut-off Current Emitter Cut-off Current DC Current Gain On Characteristics 250 0.15 0.2 1 1 TYPICAL 6 20 300 8 250 pF pF MHz dB V V VCE(sat) VBE(sat) Collector-Emitter Saturation Voltage Base-Emitter Saturation Voltage Small Signal Characteristics Cob Cib fT NF hFE Output Capacitance Input Capacitance Current gain Bandwidth Product Noise Figure Small Signal Current Gain ©2004 Fairchild Semiconductor Corporation Rev. A1, August 2004 FMB5551 Package Dimensions SuperSOTTM-6 Dimensions in Millimeters ©2004 Fairchild Semiconductor Corporation Rev. A1, August 2004 TRADEMARKS The following are registered and unregistered trademarks Fairchild Semiconductor owns or is authorized to use and is not intended to be an exhaustive list of all such trademarks. ACEx™ FAST® ActiveArray™ FASTr™ Bottomless™ FPS™ CoolFET™ FRFET™ CROSSVOLT™ GlobalOptoisolator™ DOME™ GTO™ EcoSPARK™ HiSeC™ E2CMOS™ I2C™ EnSigna™ i-Lo™ FACT™ ImpliedDisconnect™ FACT Quiet Series™ Across the board. Around the world.™ The Power Franchise® Programmable Active Droop™ ISOPLANAR™ LittleFET™ MICROCOUPLER™ MicroFET™ MicroPak™ MICROWIRE™ MSX™ MSXPro™ OCX™ OCXPro™ OPTOLOGIC® OPTOPLANAR™ PACMAN™ POP™ Power247™ PowerSaver™ PowerTrench® QFET® QS™ QT Optoelectronics™ Quiet Series™ RapidConfigure™ RapidConnect™ µSerDes™ SILENT SWITCHER® SMART START™ SPM™ Stealth™ SuperFET™ SuperSOT™-3 SuperSOT™-6 SuperSOT™-8 SyncFET™ TinyLogic® TINYOPTO™ TruTranslation™ UHC™ UltraFET® VCX™ DISCLAIMER FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems 2. A critical component is any component of a life support which, (a) are intended for surgical implant into the body, device or system whose failure to perform can be or (b) support or sustain life, or (c) whose failure to perform reasonably expected to cause the failure of the life support when properly used in accordance with instructions for use device or system, or to affect its safety or effectiveness. provided in the labeling, can be reasonably expected to result in significant injury to the user. PRODUCT STATUS DEFINITIONS Definition of Terms Datasheet Identification Advance Information Product Status Formative or In Design First Production Definition This datasheet contains the design specifications for product development. Specifications may change in any manner without notice. This datasheet contains preliminary data, and supplementary data will be published at a later date. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. This datasheet contains final specifications. Fairchild Semiconductor reserves the right to make changes at any time without notice in order to improve design. This datasheet contains specifications on a product that has been discontinued by Fairchild semiconductor. The datasheet is printed for reference information only. Preliminary No Identification Needed Full Production Obsolete Not In Production ©2004 Fairchild Semiconductor Corporation Rev. I11