FSA880UMX

FSA880 / FSA881 — USB Port 2:1 Switch with Accessory and Charger Detection November 2011 FSA880 / FSA881 – USB Port 2:1 Switch with Accessory and Charger Detection Features Switch Type 2:1 USB Automatic switching with Available Switch Mechanism Interrupt USB Data Cable Chargers (CDP, DCP, Travel Adapter, Accessory Detection Car Kit-CEA-936-A) Factory-Mode Cables USB FS and HS 2.0 Compliant Battery Charging 1.1 Compliant USB Charging Charger Detect, DCD, OVT (28V) UART RxD and TxD VBAT 3.0 to 4.4V Programmability I2 C ESD 15kV IEC 61000-4-2 Air Gap Operating -40°C to 85°C Temperature 16-Lead UMLP Package 1.8x2.6x0.55mm, 0.4mm Pitch FSA880 – Active LOW JIG Option FSA881 – Active HIGH FSA880UMX Ordering Information FSA881UMX Description The FSA88x is a high-performance switch featuring automatic switching and accessory detection for a USB port. The FSA88x allows sharing of a common USB port to pass USB data, as well as factory programmability. In addition, the FSA88x integrates accessory detection of devices such as USB chargers and factory data cables. The FSA88x can be programmed for manual switching or automatic switching of data paths. VBUS_IN has 28V over-voltage tolerance. The difference between the FSA880 and the FSA881 is that FSA880 JIG output is an open-drain, active-LOW output, while FSA881 JIG is an active-HIGH, CMOS output. Applications   Cellular Phones, Smart Phones MP3 and PMP Related Resources   For samples and questions, please contact: Analog.Switch@fairchildsemi.com. FSA880 / FSA881 Demonstration Board Typical Application USB Data USB CHARGING FACTORY TEST OVT PROTECTION FSA88x FSA9280A Figure 1. Mobile Phone Example © 2010 Fairchild Semiconductor Corporation FSA880 / FSA881 • Rev. 1.0.3 www.fairchildsemi.com FSA880 / FSA881 — USB Port 2:1 Switch with Accessory and Charger Detection Block Diagram FSA880 VBAT Phone Power HS USB or UART HS USB VDDIO DM_HOST DP_HOST DM_HOST1 DP_HOST1 Detection 28V OVT 2:1 MUX USB Port VBUS_IN DM_CON DP_CON ID_CON Interrupt I2C Baseband Processor INTB I2C_SCL I2C_SDA VDDIO 100k W JIG BOOT Charger Detect BC1.1 GND Switch Control and I2C Slave Float Detect ADC ID Detect Figure 2. Block Diagram Pin Configuration ID_CON DP_CON DM_CON VBUS_IN 16 15 14 13 DM_HOST 1 12 GND DP_HOST 2 11 I2C_SDA DM_HOST1 3 10 I2C_SCL DP_HOST1 4 9 INTB 5 VBAT 6 BOOT 7 JIG 8 VDDIO Figure 3. Pin Assignment (Through View) © 2010 Fairchild Semiconductor Corporation FSA880 / FSA881 • Rev. 1.0.3 www.fairchildsemi.com 2 FSA880 / FSA881 — USB Port 2:1 Switch with Accessory and Charger Detection Physical Dimensions 0.10 C 1.80 A B 2.10 0.663 0.563 (15X) 2X 1 2.60 PIN#1 IDENT 0.40 2.90 TOP VIEW 0.10 C 0.10 C 2X 0.225 (16X) 0.55 MAX. 0.152 RECOMMENDED LAND PATTERN TERMINAL SHAPE VARIANTS 0.40 0.60 0.15 0.25 15X 0.15 0.25 NON-PIN 1 0.08 C 0.05 0.00 SEATING C PLANE SIDE VIEW 0.45 0.35 5 0.10 0.10 0.30 15X 0.50 PIN 1 Supplier 1 9 0.40 1 0.15 0.25 PIN 1 16 13 0.30 0.50 0.15 15X 0.25 NON-PIN 1 0.3015X 0.50 PIN#1 IDENT 0.55 0.45 0.25 0.15 0.10 C A B 0.05 C Supplier 2 BOTTOM VIEW NOTES: A. PACKAGE DOES NOT FULLY CONFORM TO JEDEC STANDARD. B. DIMENSIONS ARE IN MILLIMETERS. C. DIMENSIONS AND TOLERANCES PER ASME Y14.5M, 1994. D. LAND PATTERN RECOMMENDATION IS BASED ON FSC DESIGN ONLY. E. DRAWING FILENAME: MKT-UMLP16Arev4. F. TERMINAL SHAPE MAY VARY ACCORDING TO PACKAGE SUPPLIER, SEE TERMINAL SHAPE VARIANTS. R0.20 PACKAGE EDGE LEAD OPTION 1 SCALE : 2X LEAD OPTION 2 SCALE : 2X Figure 24. 16-Lead Ultrathin Molded Leadless Package (UMLP), 1.8mm x 2.6mm x 0.55mm, 0.4mm Pitch Package drawings are provided as a service to customers considering Fairchild components. Drawings may change in any manner without notice. Please note the revision and/or date on the drawing and contact a Fairchild Semiconductor representative to verify or obtain the most recent revision. Package specifications do not expand the terms of Fairchild’s worldwide terms and conditions, specifically the warranty therein, which covers Fairchild products. Always visit Fairchild Semiconductor’s online packaging area for the most recent package drawings: http://www.fairchildsemi.com/packaging/. Part Number FSA880UMX FSA881UMX Operating Temperature Range -40 to +85°C -40 to +85°C Top Mark KU KX Package 16-Lead, Ultrathin Molded Leadless Package (UMLP), 1.8mm x 2.6mm x 0.55mm, 0.4mm Pitch 16-Lead, Ultrathin Molded Leadless Package (UMLP), 1.8mm x 2.6mm x 0.55mm, 0.4mm Pitch © 2010 Fairchild Semiconductor Corporation FSA880 / FSA881 • Rev. 1.0.3 www.fairchildsemi.com 24 FSA880 / FSA881 — USB Port 2:1 Switch with Accessory and Charger Detection © 2010 Fairchild Semiconductor Corporation FSA880 / FSA881 • Rev. 1.0.3 www.fairchildsemi.com 25