JLINK-ARM-AD
Users Manual
Copyright ©2011, Future Designs, Inc., All Rights Reserved
The JLINK-ARM-AD is designed to work with FDI’s products that utilize a mini-JTAG
connector. Products include the following:
uEZGUI-xxx-43WQS
uEZGUI-xxx-70WVE
SOMDIMM-LPCxxxx
This product is intended for users who currently own a standard 20-pin JTAG debugger that is
compatible with ARM based processor like the SEGGER J-Link, no debugger is included with
this product. FDI products with a JTAG interface use a reduced size JTAG connector based on a
2mm header. This smaller connector provides 100% of the functionality of the standard 20-pin
JTAG connector, but utilizes 70% less board space.
J-Link Lite with Adapter Board
Schematic:
J-Link Ribbon Cable and Adapter Board
Signal
VCC Supply
TRST
TDI
TMS
TCK
RTCK
TDO
RESET
GND
No Connect
Standard JTAG pin out
1, 2
3
5
7
9
11
13
15
4, 6, 8, 10, 12, 14, 16, 18, 20
17, 19
mini-JTAG pin out
9
10
7
8
5
6
3
4
1
2
Information in this document is provided solely to enable the use of Future Designs products. FDI assumes no liability whatsoever, including
infringement of any patent or copyright. FDI reserves the right to make changes to these specifications at any time, without notice. No part of this
document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written
permission of Future Designs, Inc. 2702 Triana Blvd, Huntsville, AL 35805.
For more information on FDI or our products please visit www.teamfdi.com.
NOTE: The inclusion of vendor software products in this kit does not imply an endorsement of the product by Future Designs, Inc.
2011 Future Designs, Inc. All rights reserved.
FDI PN: JLINK-ARM-AD
Revision:1.0, 3/28/2011
Printed in the United States of America
很抱歉,暂时无法提供与“JLINK-ARM-AD”相匹配的价格&库存,您可以联系我们找货
免费人工找货