FP-1310-10LRM-LCA

DATA SHEET 1310NM FP LASER FOR 10GBASE-LRM SC AND LC TOSA FP-1310-10LRM-X FEATURES: 1310nm FP laser Very low power dissipation SC and LC optical receptacles 10Gbps direct modulation Impedance matching inside the laser package Differential electrical interface Compatible with all 10GBE MSAs (XFP, X2, XPAK, XENPAK) The HFE6x62-561 is specifically designed for applications based on the IEEE 10GBASE-LRM optical standard. The TOSA is designed to meet the fiber launch conditions specified for the multimode and single mode optical fiber options. Excellent optical performance is achieved by matching the electrical characteristics of the TOSA and laser to the external circuitry. Separate, differential laser bias and modulation pins significantly reduce the amount of electrical power required at the module level, and help to reduce the overall electro-magnetic emissions. The TOSA is designed to be paired with the linear ROSA HFD6x40417 available at www.finisar.com/aoc.php. Part Number FP-1310-10LRM-SCA FP-1310-10LRM-LCA Description 1310nm SC TOSA with FP laser 1310nm LC TOSA with FP laser FP-1310-10LRM-X 1310NM FP LASER FOR 10GBASE-LRM ABSOLUTE MAXIMUM RATINGS Parameter Storage temperature Case Operating temperature Lead solder temperature Continuous Optical Power Laser Diode Reverse Voltage Laser Diode Continuous Forward Current Monitor Photodiode Reverse Current Monitor Photodiode Reverse Voltage Rating -40oC to +90oC -5 to +85oC 260oC, 10 seconds 20 mW 2V 130 mA 2 mA 10V NOTICE: Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time may affect reliability. NOTICE: The inherent design of this component causes it to be sensitive to electrostatic discharge (ESD). To prevent ESD-induced damage and/or degradation to equipment, take normal ESD precautions when handling this product. FP-1310-10LRM-X ELECTRICAL-OPTICAL CHARACTERISTICS TCASE = 25°C, TRANGE, CASE = -5 to 80°C, 10.3125 Gbps, PRBS 231-1 Parameter Threshold current Operating current Test Conditions T=25°C T=TRANGE T=25°C T=TRANGE Modulation current T=25°C T=TRANGE Output Power Slope Efficiency Encircled Flux Extinction Ratio LA (wiggle) Wavelength T=25°C T=TRANGE Spectral Width T=25°C T=TRANGE Relative Intensity Noise Modulation Bandwidth I=IOP I=IOP, T=25°C I=IOP, T=TRANGE Rise / Fall time Transmitter Wavelength Dispersion Penalty Forward Voltage Laser Resistance Monitor Current Tracking Error T=TRANGE, I=IOP T=TRANGE, I=IOP T=25°C, I=IOP, VB=-2.5V T=TMAX T=TMIN Monitor Dark Current Monitor Diode Capacitance Optical Return Loss Tolerance Input Impedance (Diff ) Diff. Return Loss Case to Signal Isolation 0.1