2430-04

Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: frontiersales@frontierusa.com Web: frontierusa.com Insert Molded Coil—2430 series A. Mechanical Drawing: B. Electrical Specification: Part No. 2430-01 2430-02 2430-03 2430-04 2430-05 2430-06 2430-07 2430-08 2430-09 2430-10 C. Features: 1. Plastic molded. 2. High reliability. 3. Low cost. L Min. (uH) 0.042 0.064 0.115 0.147 0.182 0.220 0.259 0.299 0.338 0.382 L Nom. (uH) 0.044 0.070 0.117 0.156 0.197 0.240 0.280 0.322 0.363 0.410 L Max. (uH) 0.045 0.074 0.120 0.160 0.205 0.248 0.290 0.337 0.377 0.422 Q Min. @ L Nom. ---88 @ 40 MHz 86 @ 40 MHz 85 @ 40 MHz 80 @ 40 MHz 77 @ 40 MHz 80 @ 40 MHz 82 @ 40 MHz Color Brown Red Orange Yellow Green Blue Violet Gray White Black D. Measurement: 1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent ¼” down from stand off at an angle of 90°. 2. L min. measured with core halfway out of the top of the form. 3. Inductance greater than 0.1uH read at recommended Q meter frequency. 4. Inductance below 0.1uH calculated from readings taken at 50MHz. E. Test equipment: Q meter (HP 4342A) IMC 2430 series Mar. 01, 2002 Page 1 of 1