2432-16

Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: frontiersales@frontierusa.com Web: frontierusa.com Insert Molded Coil—2432 series A. Mechanical Drawing: B. Electrical Specification: Part No. 2432-09 2432-10 2432-11 2432-12 2432-13 2432-14 2432-15 2432-16 2432-17 2432-18 2432-19 2432-20 L Min. (uH) 0.315 0.355 0.396 0.433 0.475 0.515 0.583 0.638 0.693 0.754 0.792 0.847 L Nom. (uH) 0.369 0.416 0.468 0.509 0.556 0.604 0.660 0.720 0.770 0.814 0.846 0.896 L Max. (uH) 0.423 0.477 0.540 0.585 0.637 0.693 0.738 0.801 0.846 0.874 0.900 0.945 Q Min. @ L Nom. 80 @ 40 MHz 82 @ 40 MHz 78 @ 40 MHz 80 @ 40 MHz 80 @ 40 MHz 78 @ 40 MHz 80 @ 40 MHz 76 @ 40 MHz 76 @ 40 MHz 82 @ 40 MHz 80 @ 40 MHz 74 @ 40 MHz Color White Black Brown Red Orange Yellow Green Blue Violet Gray White Black C. Features: 1. Plastic molded. 2. High reliability. 3. Low cost. D. Measurement: 1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent ¼” down from stand off at an angle of 90°. 2. L min. measured with core halfway out of the top of the form. 3. Inductance greater than 0.1uH read at recommended Q meter frequency. 4. Inductance below 0.1uH calculated from readings taken at 50MHz. E. Test equipment: Q meter (HP 4342A) IMC 2432 series Mar. 01, 2002 Page 1 of 1