2434-04

Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: frontiersales@frontierusa.com Web: frontierusa.com Insert Molded Coil—2434 series A. Mechanical Drawing: B. Electrical Specification: Part No. 2434-01 2434-02 2434-03 2434-04 2434-05 2434-06 2434-07 2434-08 2434-09 2434-10 C. Features: 1. Plastic molded. 2. High reliability. 3. Low cost. L Min. (uH) 0.037 0.054 0.080 0.100 0.120 0.142 0.172 0.200 0.234 0.260 L Nom. (uH) 0.038 0.058 0.085 0.110 0.135 0.163 0.194 0.224 0.260 0.288 L Max. (uH) 0.039 0.063 0.090 0.120 0.150 0.184 0.216 0.248 0.284 0.315 Q Min. @ L Nom. 76 @ 50 MHz 78 @ 50 MHz 78 @ 50 MHz 78 @ 50 MHz 76 @ 50 MHz 72 @ 50 MHz 68 @ 50 MHz 66 @ 50 MHz 60 @ 50 MHz 56 @ 50 MHz Color Brown Red Orange Yellow Green Blue Violet Gray White Black D. Measurement: 1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent ¼” down from stand off at an angle of 90°. 2. L min. measured with core halfway out of the top of the form. 3. Inductance greater than 0.1uH read at recommended Q meter frequency. 4. Inductance below 0.1uH calculated from readings taken at 50MHz. E. Test equipment: Q meter (HP 4342A) IMC 2434 series Mar. 15, 2002 Page 1 of 1