2435-04

Frontier Electronics Corp. 667 E. COCHRAN STREET, SIMI VALLEY, CA 93065 TEL: (805) 522-9998 FAX: (805) 522-9989 E-mail: frontiersales@frontierusa.com Web: frontierusa.com Insert Molded Coil—2435 series A. Mechanical Drawing: B. Electrical Specification: Part No. 2435-01 2435-02 2435-03 2435-04 2435-05 2435-06 2435-07 C. Features: 1. Plastic molded. 2. High reliability. 3. Low cost. L Min. (uH) 0.0460 0.0620 0.0820 0.1080 0.1370 0.1760 0.2220 L Nom. (uH) 0.0475 0.0700 0.0980 0.1300 0.1650 0.2050 0.2450 L Max. (uH) 0.0485 0.0780 0.1140 0.1540 0.1930 0.2340 0.2680 Q Min. @ L Nom. 80 @ 50MHz 85 @ 50MHz 108 @ 50MHz 114 @ 50MHz 114 @ 50 MHz 112 @ 50 MHz 108 @ 40 MHz Color Brown Red Orange Yellow Green Blue Violet D. Measurement: 1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent ¼” down from stand off at an angle of 90°. 2. L min. measured with core halfway out of the top of the form. 3. Inductance greater than 0.1uH read at recommended Q meter frequency. 4. Inductance below 0.1uH calculated from readings taken at 50MHz. E. Test equipment: Q meter (HP 4342A) IMC 2435 series Mar. 15, 2002 Page 1 of 1