CLEO-CAM1

CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 Future Technology Devices International Limited Datasheet CleO-Camera Module 1 Introduction 1.1 The CleO-Camera module is a camera accessory for the CleO series – the smart TFT display for Arduino. It consists of an OV5640 sensor module and Flash LEDs. The OV5640 sensor is a low voltage, highperformance, 1/4-inch 5 megapixel CMOS image sensor that provides the full functionality of a single chip 5 megapixel (2592×1944) camera using OmniBSI™ technology in a small footprint package. It is controlled through the standard Serial Camera Control Bus (SCCB) interface.  1.4 µm x 1.4 µm pixel with OmniBSI™ technology for high performance (high sensitivity, low crosstalk, low noise, improved quantum efficiency)    Optical size 1/4" Embedded 1.5V regulator for core power The CleO-camera module is supplied with a standard 24 Pin 0.5mm pitch FFC cable.       Features On-board regulator for VDDA,VDDIO, only 3V3 supply needed Support for output format: RAW RGB, RGB565/555/444, YUV422/420, YCbCr422 and compression Image quality control:color saturation, hue, gamma, sharpness(edge enhancement), lens correction, defective pixel cancelling and noise cancelling Support for anti-shake Standard SCCB interface In built Flash light LED 24 pin 0.5mm pitch FFC cable interface N either the whole nor any part of the information contained in, or the product described in this manual, may be adapted or reproduced in any material or elec tronic form without the prior written c onsent of the c opyright holder. T his product and its doc umentation are s upplied on an as- is basis and no warranty as to their s uitability for any partic ular purpos e is either made or implied. Future T ec hnology Devic es I nternational L td will not accept any claim for damages hows oever arising as a res ult of use or failure of this produc t. Y our statutory rights are not affected. T his produc t or any variant of it is not intended for us e in any medical appliance, device or s ystem in whi c h the failure of the produc t might reasonably be expected to res ult in pers onal injury. T his doc ument provides preliminary information that may be s ubject to c hange without notice. N o freedom to use patents or other intellec tual property rights is implied by the publication of this doc ument. Future Tec hnology D evices I nternational L td, U nit 1 , 2 Seaward P lac e, C enturion Business P ark, G lasgow G 4 1 1HH U nited Kingdom. Sc otland Registered C ompany N umber: SC 136640 Copyright © Future Technology Devices International Limited 1 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 2 Ordering Information Part No. Description CleO-CAM1 CleO-camera module, 5M Pixel HD CMOS camera module with adaptor board and FPC Flex Copyright © Future Technology Devices International Limited 2 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 Table of Contents 1 Introduction ................................................................. 1 1.1 Features ................................................................................ 1 2 Ordering Information .................................................... 2 3 Pin Out and Signal Description ...................................... 4 3.1 Module Description ................................................................ 4 3.2 Module Interface Signal Desciption ......................................... 4 4 Devices Characteristics and Ratings............................... 6 4.1 Electrical Specification ........................................................... 6 4.2 Sensor Key Specification ........................................................ 7 5 Board Schematic ........................................................... 8 6 Mechanical Dimensions ................................................. 9 7 Contact Information .................................................... 10 Appendix A – References ................................................. 11 Document References ...................................................................11 Acronyms and Abbreviations .........................................................11 Appendix B - List of Figures and Tables ............................ 12 List of Tables ................................................................................12 List of Figures ...............................................................................12 Appendix C – Revision History.......................................... 13 Copyright © Future Technology Devices International Limited 3 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 3 Pin Out and Signal Description 3.1 Module Description Figure 1 – Camera Module Features No Feature 1 2 3 4 5 2.8V fixed voltage LDO LED driver 24pin 0.5 mm pitch FFC connector interface to OV5640 module 24pin 0.5 mm pitch FFC connector interface to CleO White LED 6 OV5640 camera module Reference Designator U7 U16 CN13 CN3 LED5, LED6, LED7, LED8 - Table 1 - Camera Module Features & Description 3.2 Module Interface Signal Desciption The pin description of CN3 is given in Table 2. Pin No Pin Name Type Description 1 PWM0 Input Pulse Width Modulation to control LED brightness 2 CAM_5V Power 5V Supply 3 CAM_D2 Output Pixel Data Output 2 4 CAM_D1 Output Pixel Data Output 1 5 CAM_D3 Output Pixel Data Output 3 Copyright © Future Technology Devices International Limited 4 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 Pin No Pin Name Type Description 6 CAM_D0 Output Pixel Data Output 0 7 CAM_D4 Output Pixel Data Output 4 8 CAM_PCLK Output Pixel Clock Output from Sensor 9 CAM_D5 Output Pixel Data Output 5 10 GND Ground Power Ground 11 CAM_D6 Output Pixel Data Output 6 12 CAM_XCLK Input Master Clock into Sensor 13 CAM_D7 Output Pixel Data Output 7 14 CAM_3V3 Power 3V3 Supply 15 CAM_3V3 Power 3V3 Supply 16 CAM_HD Output Active High: Line/Data Valid; indicates active pixels 17 CAM PWDN Input Camera Power Down, active High  Always pull low enable the sensor 18 CAM_VD Output Active High: Frame Valid; indicates active frame 19 RESETn Input Camera Reset, Active low 20 I2C0_SCL Input Two-Wire Serial Interface Clock 21 CAM_5V Power 5V Supply 22 I2C0_SDA Bi-Directional Two-Wire Serial Interface Data I/O 23 GND Ground Power Ground 24 GND Ground Power Ground Table 2 - CN3 Pin Description Copyright © Future Technology Devices International Limited 5 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 4 Devices Characteristics and Ratings 4.1 Electrical Specification Parameter Value Unit Storage Temperature -40°C to 95°C Degrees C Conditions Ambient Operating Temperature (Power -30°C to 70°C Degrees C Applied) Table 3 - Temperature Parameter DC Characteristics (Ambient Temperature = -30°C to +70°C) Parameter Description Minimum Typical Maximum Units 5.25 V 3.6 V V dc 5V DC input 4.75 V dc 3V3 DC input 3.0 Vih Input high voltage 1.26 Vil Input low voltage Voh output high voltage Vol output low voltage 0.18 Table 4 - Operating Voltage and Current 3.3 Conditions V 0.54 1.62 Copyright © Future Technology Devices International Limited V V V 6 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 4.2 C learance N o.: FT DI# 4 9 4 Sensor Key Specification Figure 2- Sensor Key Specifications Copyright © Future Technology Devices International Limited 7 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 5 Board Schematic Figure 3 - Camera Schematic Copyright © Future Technology Devices International Limited 8 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 6 Mechanical Dimensions Figure 4 - CleO - Camera Module Dimensions Copyright © Future Technology Devices International Limited 9 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 7 Contact Information Head Office – Glasgow, UK Branch Office – Tigard, Oregon, USA Future Technology Devices International Limited Unit 1, 2 Seaward Place, Centurion Business Park Glasgow G41 1HH United Kingdom Tel: +44 (0) 141 429 2777 Fax: +44 (0) 141 429 2758 Future Technology Devices International Limited (USA) 7130 SW Fir Loop Tigard, OR 97223-8160 USA Tel: +1 (503) 547 0988 Fax: +1 (503) 547 0987 E-mail (Sales) E-mail (Support) E-mail (General Enquiries) E-mail (Sales) E-mail (Support) E-mail (General Enquiries) sales1@ftdichip.com support1@ftdichip.com admin1@ftdichip.com us.sales@ftdichip.com us.support@ftdichip.com us.admin@ftdichip.com Branch Office – Taipei, Taiwan Branch Office – Shanghai, China Future Technology Devices International Limited (Taiwan) 2F, No. 516, Sec. 1, NeiHu Road Taipei 114 Taiwan , R.O.C. Tel: +886 (0) 2 8797 1330 Fax: +886 (0) 2 8751 9737 Future Technology Devices International Limited (China) Room 1103, No. 666 West Huaihai Road, Shanghai, 200052 C hina Tel: +86 21 62351596 Fax: +86 21 62351595 E-mail (Sales) E-mail (Support) E-mail (General Enquiries) E-mail (Sales) E-mail (Support) E-mail (General Enquiries) tw .sales1@ftdichip.com tw .support1@ftdichip.com tw .admin1@ftdichip.com cn.sales@ftdichip.com cn.support@ftdichip.com cn.admin@ftdichip.com Web Site http://ftdichip.com Distributor and Sales Representatives Please visit the Sales Network page of the FTDI Web site for the contact details of our distributor(s) and sales representative(s) in your country. System and equipment manufac turers and des igners are res ponsible to ens ure that their s ys tems , and any Future T ec hno logy D evices I nternational L td (FTDI ) devices incorporated in their sys tems , meet all applic able safety, regulatory and sys tem -level performance requirements . All application- related information in this document (including applic ation desc riptions , s uggest ed FTDI devic es and other materials ) is provided for referenc e only. While FTDI has taken care to ass ure it is acc urate, this information is s ubject to c ustomer confirmation, and FTDI disclaims all liability for s ys tem des igns and for any applic ations ass istance provided by FTDI . Use of FTDI devic es in life s upport and/or s afety applic ations is entirely at the user’s risk, and the us er agrees to defend, indemnify and hold harmless FTDI from any and all damages , claims , s uits or expense res ulting from s uch us e. T his doc ument is s ubject to c hange without notice. N o freedom to us e patents or other intellec tual property rights is implied by the public ation of this doc ument. N either the whole nor any part of the information c ontained in, or the produc t d esc ribed in this doc ument, may be adapted or reproduc ed in any material or elec tronic form without the prior written c onsent of the c opyright holder. Future Tec hnology Devices I nternational L td, U nit 1 , 2 Seaward P lac e, Centurion Business Park, Glas gow G41 1HH , U ni ted Kingdom. Scotland Registered C ompany N umber: SC136640 Copyright © Future Technology Devices International Limited 10 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 Appendix A – References Document References For module documentations, please refer to URL below: OV5640 datasheet: OV5640 Datasheet LDO 2.8V Fixed Voltage datasheet: FT531GA Datasheet Acronyms and Abbreviations Terms Description DC Direct Current LED Light-emitting diode PWM Pulse Width Modulation SCCB Serial Camera Control Bus TFT FFC/FPC Thin Film Translator Flexible Flat Cable/Flexible Printed Circuit Copyright © Future Technology Devices International Limited 11 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 Appendix B - List of Figures and Tables List of Tables Table 1 - Camera Module Features & Description .................................................................................... 4 Table 2 - CN3 Pin Description ................................................................................................................. 5 Table 3 - Temperature Parameter........................................................................................................... 6 Table 4 - Operating Voltage and Current................................................................................................. 6 List of Figures Figure 1 – Camera Module Features........................................................................................................ 4 Figure 2- Sensor Key Specifications ........................................................................................................ 7 Figure 3 - Camera Schematic ................................................................................................................. 8 Figure 4 - CleO - Camera Module Dimensions ......................................................................................... 9 Copyright © Future Technology Devices International Limited 12 CleO-Camera Module Datasheet Version 1.0 D oc ument Reference N o.: FT _001308 C learance N o.: FT DI# 4 9 4 Appendix C – Revision History Document Title: CleO-Camera Module Datasheet Document Reference No.: FT_001308 Clearance No.: FTDI# 494 Product Page: http://www.ftdichip.com/Products/Modules/CleO.htm Document Feedback: Send Feedback Revision Changes Date Version 1.0 Initial Release 2016-04-20 Copyright © Future Technology Devices International Limited 13