FW4560

SDH Transport FLASHWAVE 4560 Multiservice Provisioning Platform The Challenge We Face Telecom carriers and network operators today are constantly looking for ways to expand their network and customer services in order to increase revenue with minimum cost and time. This is the challenge most vendors face, too. Flexibility, reliability, scalability, and cost-effectiveness — these are just a few of the capabilities that telecom carriers expect of next-generation network systems. support these user demands with a shorter lead-time and minimum investment is one of the most critical issues for every service provider to survive in today’s highly competitive market. Here too, FLASHWAVE 4560 is the solution for you. Simply fit the Ethernet units into FLASHWAVE 4560 shelf and you can turn your traditional voice network into an advanced, data and voice converged network. With two different operational modes of Gigabit Ethernet transport, point-to-point and bandwidth sharing, operators can support end-user demands either way — with full wire-speed transport, or with cost-effective best-effort type of service over the selected number of VC-4 pipes. Furthermore, its virtual concatenation capability enables operators to use their limited network bandwidth without any loss. The FLASHWAVE 4560 gives you everything you need to build next generation networks today. The Solution We Provide FLASHWAVE 4560 provides all the many qualities to meet every telecom carrier’s needs. Its universal interface slot structure and flexible VC-4/VC-12 cross-connect capability allow you to tailor its shelf as your network demands, from a traditional STM-16 or STM-64 ADM to an extensive hub with a number of optical subtending rings. With the flexibility of “any card in any slot” shelf architecture, and various network application capabilities (ring, linear, and hub) in both the metro and the backbone network, spare inventory and training costs can be significantly reduced. In addition, the hub application with numerous subtending rings reduces the cabling work that would otherwise be required between each ring node, thereby slashing installation time and costs. It also leads to less miswiring and unintentional disconnection, for a more reliable network. Future-Proof Your Network Now With the increasing growth in data traffic, the Internet and enterprise Intranets, the capability to Features and Specifications Advanced Features Twenty universal service interface module slots Direct E1 drop from STM-64 aggregate Wire-speed or bandwidth-shared Ethernet transport 288 × 288 VC-4 and 2016 × 2016 VC-12 cross-connect Power Consumption Single shelf: 600W (maximum) Protection Switch matrix, synchronization E1/STM-1e STM-1o/STM-4: STM-16/STM-64: Ethernet 1:1 1:1 1+1 MSP, SNCP 2F-MS-SPRing,1+1 MSP, SNCP unprotected Architectures Terminal Linear add/drop 2F-MS-SPRing SNCP ring Optical hub (STM-1, STM-4, and STM-16) Optics STM-1 STM-4 STM-16 STM-64 Gigabit Ethernet 1,310nm with SC or LC connectors 1,310nm with LC connectors 1,310nm /1,550nm with SC connectors 1,550nm with SC connectors SC connector Time-Slot Interchange 288 × 288 VC-4 switch fabric 2,016 × 2,016 VC-12 switch fabric Any-port-to-any-port TSI Virtual concatenation (VC-4-nV, n=1 to 8) Operations Support TL1 protocol over OSI/LCN, or IP/LCN TCP/IP gateway functionality FLEXR craft interface and FLEXR-EM/NM network management support Ring Interfaces Maximum number of rings per shelf: STM-64 1 MS-SPRing/SNCP ring STM-16 Up to 4 MS-SPRings or 8 SNCP rings STM-4 Up to 32 SNCP rings STM-1 Up to 40 SNCP rings Synchronization Internal Stratum-3 timing source Synchronization status message (ITU-T standard) 2Mbps/2MHz primary and secondary clock output/input Line timing Service Interface Modules Maximum number of interfaces per shelf: E1 (42 per card) 504 STM-1e (2 per card) 32 STM-1o (2 or 4 per card) 80 STM-4 (4 per card) 64 STM-16 (1 per card) 16 STM-64 (1 per card) 2 10/100-Base T (8 per card) 80 Gigabit Ethernet P-P type (2 per card) 32 Gigabit Ethernet Bandwidth Shared type (2 per card) 8 Operating Environment Temperature: Humidity: 0°C to 45°C (–5°C to 50°C: short-term) 5% to 85% (Non-condensing) Physical Characteristics Shelf: Rack: 575(H)× 500(W)× 503(D)mm 2,200(H)× 600(W)× 600(D)mm w/cable management spaces Acquire Extensive Port-to-Port Connectivity FLASHWAVE 4560 Service Module 1 SDH VC-12 Switch Fabric 2,016 X 2,016 SDH Service Module 20 Router Data Switch Fabric Service Module 20 SDH VC-4 Switch Fabric 288 X 288 Service Module 1 SDH Router Specifications are subject to change without notice. For the latest detailed information, contact your local representative. All brand names and product names are trademarks and registered trademarks of their respective holders. Third Edition, September 2003 FUJITSU LIMITED For further information please contact: Network Systems Group 4-1-1, Kamikodanaka, Nakahara-ku, Kawasaki, 211-8588 Japan http://telecom.fujitsu.com/ ©2001 FUJITSU LIMITED Printed in Japan BH1059-3C