FTR-C2GB012G

FTR-K1 SERIES SIGNAL RELAY 2 POLES - 2A High Isolation Wide Contact Gap 2.0mm Contact Gap FTR-C2 Series n FEATURES l l DPDT 2�� C�ntact �ap: m�re t�an 2.0mm l C�nf�rms t� IEC60950 / EN60950 / UL950/ CS�� C22.2 N�.950 N�.950 W�rkin� v�lta�e 250V l INSUL��TION Clearance: 2.0 mm (between �pen c�ntacts, c�il and c�ntacts, c�ntact sets) Creepa�e: 2.5 mm (between �pen c�ntacts,c�il and c�ntacts, c�ntact sets) l HIGH RELI��BILITY Bif�rcated c�ntacts l P�wer c�ns�mpti�n 300 mW l Latc�in� types available l R�HS c�mpliant. Please see pa�e 7 f�r m�re inf�rmati�n n PARTNUMBER INFORMATION FTR-C2 C �� 02 G [Example] (a) (b) (c) (d) (e) (a) (b) (c) (d) (e) Relay type Terminal type C�il type C�il type C�il rated v�lta�e C�ntact material FTR-C2 FTR-C2 Series : C C G �� �� B 02 G : T�r���� ��le : T�r���� ��le : S�rface m��nt : Standard type : Latc�in� type : 3.....24 VDC C�il ratin� table at pa�e 3 : G�ld plated silver all�y N�te: 500 relays per reel f�r SMT versi�ns Remarks: ��ct�al markin� �n relay w��ld n�t carry c�de FTR and be as bel�w: Orderin� c�de: FTR-C2C��02G-B05 ��ct�al markin�: C2C��02G N�te: * Only SMT versi�n  FTR-K1 SERIES FTR-C2 SERIES n SPECIFICATION Item C�ntact Data Configuration C�nstr�cti�n Material Resistance (initial) C�ntact ratin� (resistive) Max. carryin� c�rrent Max. switc�in� v�lta�e Max. switc�in� p�wer Min. switc�in� l�ad * Life Mec�anical Electrical C�il Data Rated P�wer Operate P�wer Operatin� temperat�re ran�e Timin� Data Ins�lati�n Operate (n� b��nce) Release (n� di�de, n� b��nce) Resistance (initial) Open c�ntacts Dielectric stren�t� S�r�e stren�t� Clearance C�ntacts t� c�il C�il t� c�ntacts Open c�ntacts C�il and c�ntacts Creepa�e Ot�er Vibrati�n resistance S��ck Wei��t Open c�ntacts C�il and c�ntacts Mis�perati�n End�rance Mis�perati�n End�rance DC c�ntact ratin� ��C c�ntact ratin� Standard type FTR-C2 ( ) �� 2 f�rm C Bif�rcated c�ntacts G�ld �verlay silver palladi�m (stati�nary c�ntact) Silver palladi�m (m�vable c�ntact) Maximum 150 mΩ at 1 A, 6 VDC 0.3��, 25V��C / ��, 30VDC 2�� 250 V��C / 220VDC 62.5V�� / 30W 0.0��, 0mVDC 0 x 03 �perati�ns minim�m (at 0 Hz) 00 x 03 �perati�ns minim�m 00 x 03 �perati�ns minim�m 300 mW 69 mW -40 °C t� +85 °C (n� fr�st) ≤ 15 ms (at nominal voltage) ≤ 15 ms (at nominal voltage) ≥ 1,000MOhm at 500VDC ,500V��C (50/60Hz) min ,500V��C (50/60Hz) min 2,500V/ 2 x 0µs standard wave 2.0 mm 2.0 mm 2.0 mm 2.5 mm 0 t� 55Hz d��ble amplit�de 3.3mm 0 t� 55Hz d��ble amplit�de 5.0mm 300m/s² ,000m/s² ��ppr�ximately 3.79� 50 mW 85 mW Latc�in� type FTR-C2 ( ) B ��djacent c�ntacts 2,000V��C (50/60Hz) min ��djacent c�ntacts 2.0 mm ��djacent c�ntacts 2.0 mm * Minimum switching loads mentioned above are reference values. Please perform the confirmation test with actual l�ad bef�re pr�d�cti�n since reference val�es may vary acc�rdin� t� switc�in� freq�encies, envir�nmental c�nti�ns and expected reliability levels. 2 FTR-C2 SERIES FTR-K1 SERIES n COIL RATING Standard type C�il C�de 003 005 02 024 Rated C�il C�il Resistance V�lta�e +/- 0% (O�m) (VDC) 3 5 2 24 30 83.3 480 ,920 M�st Operate M�st ReleaseMax. C�il V�lta�e V�lta�e V�lta�e (VDC) (VDC) * (VDC) * 2.25 3.75 9 8 0.3 0.5 .2 2.4 7.2 2 28.8 57.6 300 Rated P�wer (mW) Latc�in� type ( c�il) C�il C�de 003 005 02 024 Rated C�il C�il Resistance V�lta�e +/- 0% (O�m) (VDC) 3 5 2 24 60 67 960 3,840 M�st Operate M�st ReleaseMax. C�il V�lta�e V�lta�e V�lta�e (VDC) (VDC) * (VDC) * +2.25 +3.75 +9 +8 2.25 3.75 9 8 7.2 2 28.8 57.6 50 Rated P�wer (mW) N�te: ��ll val�es in t�e table are valid f�r 20°C and zer� c�ntact c�rrent. * Specified operate values are valid for pulse wave voltage. n SAFETY STANDARDS Type UL C�mpliance UL 508 E 6365 CS�� C22.2 N�. 4 LR 40304 C�ntact ratin� Flammability: UL 94-V0 (plastics) 0.3��, 25V��C (resistive) ��, 30VDC 0.3��, 0VDC 3 FTR-C2 SERIES FTR-K1 SERIES n REFERENCE DATA 4 FTR-K1 SERIES FTR-C2 SERIES n DIMENSIONS AND SCHEMATICS n TERMINAL DESIGNATIONS n RECOMMENDED MOUNTING PAD Single Coil Latching Type Unit: mm 5 FTR-K1 SERIES FTR-C2 SERIES n DIMENSIONS AND SCHEMATICS Unit: mm n TERMINAL DESIGNATIONS n RECOMMENDED MOUNTING PAD Single Coil Latching Type Unit: mm 6 FTR-K1 SERIES FTR-C2 SERIES RoHS Compliance and Lead Free Information 1. General Information ��ll si�nal and p�wer relays pr�d�ced by F�jits� C�mp�nents are c�mpliant wit� R�HS directive 2002/95EC incl�din� amendments. l Cadmi�m as �sed in electrical c�ntacts is exempted fr�m t�e R�HS directives �n Oct�ber 2st, 2005. (��mendment t� Directive 2002/95/EC) l ��ll �f ��r si�nal and p�wer relays are lead-free. Please refer t� Lead-Free Stat�s Inf� f�r �lder date c�des at: �ttp://www.f�jits�.c�m/�s/d�wnl�ads/MICRO/fcai/relays/lead-free-letter.pdf l Lead free solder plating on relay terminals is Sn-3.0Ag-0.5Cu, unless otherwise specified. This material has been verified to be compatible with PbSn assembly process. l 2. Recommended Lead Free Solder Profile l Rec�mmended s�lder Sn-3.0���-0.5C�. Flow Solder condition: Pre-heating: S�lderin�: maximum 120˚C dip wit�in 5 sec. at 260˚C solder bath Solder by Soldering Iron: S�lderin� Ir�n Temperature: maximum 360˚C D�rati�n: maxim�m 3 sec. REFLOW N�te: 1.Temperature profiles show the temperat�re �f PC b�ard s�rface. 2. Please perf�rm s�lderin� test wit� y��r act�al PC b�ard bef�re mass pr�d�cti�n, since t�e temperat�res �f PC b�ard s�rfaces can vary, dependin� �n t�e size �f PC b�ard, stat�s �f parts m��ntin� and �eatin� met��d. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity l M�ist�re Sensitivity Level standard is n�t applicable t� electr�mec�anical relays, �nless �t�erwise indicated. 4. Tin Whiskers Dipped Sn���C� s�lder is kn�wn as presentin� a l�w risk t� tin w�isker devel�pment. N� c�nsiderable len�t� w�isker was f��nd by ��r in ���se test. l 7 FTR-K1 SERIES FTR-C2 SERIES Fujitsu Components International Headquarter Offices Japan F�jits� C�mp�nent Limited G�tanda-C��� B�ildin� 3-5, Hi�as�i��tanda 2-c��me, S�ina�awa-k� T�ky� 4, Japan Tel: (8-3) 5449-700 Fax: (8-3) 5449-2626 Email: pr�m�t�q@ft.ed.f�jits�.c�m Web: www.fcl.f�jits�.c�m North and South America F�jits� C�mp�nents ��merica, Inc. 250 E. Caribbean Drive S�nnyvale, C�� 94089 U.S.��. Tel: (-408) 745-4900 Fax: (-408) 745-4970 Email: c�mp�nents@�s.f�jits�.c�m Web: �ttp://�s.f�jits�.c�m/c�mp�nents Europe F�jits� C�mp�nents E�r�pe B.V. Diamantlaan 25 232 WV H��fdd�rp Net�erlands Tel: (3-23) 556090 Fax: (3-23) 5560950 Email: inf�@fce�.f�jits�.c�m Web: emea.f�jits�.c�m/c�mp�nents/ Asia Pacific F�jits� C�mp�nents ��sia Ltd. 02E Pasir Panjan� R�ad #0-0 Citilink Ware���se C�mplex Sin�ap�re 8529 Tel: (65) 6375-8560 Fax: (65) 6273-302 Email: fcal@fcal.f�jits�.c�m Web: �ttp://www.f�jits�.c�m/s�/services/micr�/c�mp�nents/ ©200 F�jits� C�mp�nents E�r�pe B.V. ��ll ri��ts reserved. ��ll trademarks �r re�istered trademarks are t�e pr�perty �f t�eir respective �wners. T�e c�ntents, data and inf�rmati�n in t�is datas�eet are pr�vided by F�jits� C�mp�nent Ltd. as a service �nly t� its �ser and �nly f�r �eneral inf�rmati�n p�rp�ses. T�e �se �f t�e c�ntents, data and inf�rmati�n pr�vided in t�is datas�eet is at t�e �sers’ �wn risk. F�jits� �as assembled t�is datas�eet wit� care and will endeav�r t� keep t�e c�ntents, data and inf�rmati�n c�rrect, acc�rate, c�mpre�ensive, c�mplete and �p t� date. Fujitsu Components Europe B.V. and affiliated companies do however not accept any responsibility or liability on their behalf, nor on behalf �f its empl�yees, f�r any l�ss �r dama�e, direct, indirect �r c�nseq�ential, wit� respect t� t�is datas�eet, its c�ntents, data, and inf�rmati�n and related �rap�ics and t�e c�rrectness, reliability, acc�racy, c�mpre�ensiveness, �sef�lness, availability and c�mpleteness t�ere�f. Nor do Fujitsu Components Europe B.V. and affiliated companies accept on their behalf, nor on behalf of its employees, any responsibility or liability for any representation or warrant of any kind, express or implied, including warranties of any kind for merchantability or fitness for partic�lar �se, wit� respect t� t�ese datas�eets, its c�ntents, data, inf�rmati�n and related �rap�ics and t�e c�rrectness, reliability, acc�racy, c�mpre�ensiveness, �sef�lness, availability and c�mpleteness t�ere�f. Rev. Marc� 5, 200 8