FTR-F3AA012E-HA

FTR-K1 SERIES POWER RELAY 1 POLE - 3A/5A Slim Type Relay FTR-F3 Series n FEATURES High density mounting Slim type with 7mm width and 142mm2 mounting space l High insulation Insulation distance: minimum 6mm between coil and contact (conforms to IEC 60065) Dielectric strength: 4KV Surge strength: 10KV l Cadmium free contact for eco-program l Safety standards UL, CSA, VDE, CQC l Plastic sealed relay, RTIII l RoHS compliant Please see page 6 for more information l n PARTNUMBER INFORMATION [Example] FTR-F3 (a) A A (b) (c) 012 (d) E - HA (e) (f) (a) Relay type FTR-F3 : FTR-F3-Series (b) Contact configuration A : 1 form A (SPST-NO) (c) Coil type (power) A : 200mW (d) Coil rated voltage 012 : 5.....24 VDC Coil rating table at page 3 (e) Contact material E : AgNi (f) Contact rating Nil HA KS : 3A type flux free : 5A type sealing confirmed : 3A type sealing confirmed Actual marking does not carry the type name : "FTR" E.g.: Ordering code: FTR-F3AA012E-HA Actual marking: F3AA012E 5A 250V~ 5A 30VDC marked on relay 1 FTR-F3 SERIES FTR-K1 SERIES n SPECIFICATION Item FTR-F3 FTR-F3AA( )E Contact Data Life Coil Data Timing Data Insulation Configuration 1 form A (SPST-NO) Construction Single Material AgNi Resistance (initial) Max. 100mOhm at 1A, 6VDC Contact rating (resistive) 3A, 125VAC, 30VDC Max. carrying current 5A Max. switching voltage 277VAC, 30VDC Max. switching power 750VA, 90W Min. switching load * 10 mA, 5VDC Mechanical Min. 5 x 106 operations Electrical (at rated load) Min. 200 x 103 operations Rated power (20 °C) 200mW Operate power 113mW Operating temperature range -40 °C to +70 °C (no frost) Operate (at nominal voltage) Max. 10ms (without bounce, no diode) Release (at nominal voltage) Max. 10ms (without bounce, no diode) Resistance (initial) Min. 1,000MOhm at 500VDC Dielectric strength Surge strength Open contacts 750VAC (50/60Hz) 1min Contacts to coil 4,000VAC (50/60Hz) 1min Contacts to coil 10,000V / 1.2 x 50µs standard wave Clearance Other Vibration resistance Shock 5A, 250VAC, 30VDC 1,250VA, 150W Min. 100 x 103 operations 6mm Creepage EN61810-1, VDE0435 FTR-F3AA( )E-HA 6mm Voltage 250V Pollution degree 2 Material group III Misoperation 10 to 55 to 10 single amplitude 0.75mm Endurance 10 to 55 to 10 single amplitude 0.75mm Misoperation Min. 100m/s2 (11±1ms) Endurance Min. 1,000m/s2 (6±1ms) Weight Approximately 4g Sealing Plastic sealed RTIII * Minimum switching loads mentioned above are reference values. Please perform the confirmation test with actual load before production since reference values may vary according to switching frequencies, environmental conditions and expected reliability levels. 2 FTR-K1 SERIES FTR-F3 SERIES n COIL RATING 200mW type Coil Code Rated Coil Voltage (VDC) Coil Resistance +/- 10% (Ohm) Must Operate Voltage (VDC) * Must Release Voltage (VDC) * 005 5 125 3.75 0.5 006 6 180 4.5 0.6 009 9 405 6.75 0.9 012 12 720 9 1.2 018 18 1,620 13.5 1.8 024 24 2,880 18 2.4 Rated Power (mW) 200 Note 1: All values given in the coil table(s) are valid at 20°C ambient temperature, at zero contactcurrent, without pre-energizing and are specified at pulse wave voltage. Note 2: When applying a higher than rated coil voltage, please refer to the "coil temperature rise" and "operating range". Reference graphs for the effects on the relay operating behaviour. n SAFETY STANDARDS Type Compliance Contact rating FTR-F3 UL UL 508 E63614 FTR-F3-HA Flammability: UL 94-V0 (plastics) 5A, 30VDC/277VAC 6A, 277VAC 3A, 30 VDC/ 277 VAC (resistive) 1/10 HP, 125VAC 1/8 HP, 277VAC Pilot duty: D300 3A, 30VDC/277VAC 6A, 277VAC 5A, 30 VDC/ 277 VAC (resistive) 1/10 HP, 250VAC (UL only), 1/10HP 125VAC 1/8 HP, 277VAC Pilot duty: D300 5A, 250 VAC, cosφ =1, 100 x 103, 85ºC 5A, 30 VDC, Ʈ=0msec, 100 x 103, 85ºC 4A, 250VAC, cut off 1A, cosφ =0.8, 100 x 103, 70ºC CSA C22.2 No. 14 LR 40304 VDE 0435 40015024 3A, 250 VAC, cosφ =1, 200 x 103, 85ºC 3A, 30 VDC, Ʈ=0msec, 200 x 103, 85ºC 4A, 250VAC, cut off 1A, cosφ =0.8, 200 x 103, 70ºC CQC GB/T21711.1, GB15092.1 1002049449, 04001010925, 03001005455 5A 250VAC/30VDC (except-KS type) 3 FTR-K1 SERIES FTR-F3 SERIES n CHARACTERISTIC DATA (Reference) Operating Range Nominal Voltage Multiplying Factor 2.4 2.2 2.0 5A 3A 0A 形 FTR-F3 FTR-F3 1.8 1.6 1.4 1.2 1.0 0.8 0.6 te Opera e voltag oil) (hot c age te volt Opera (cool coil) 0 10 10 20 20 30 30 40 40 50 50 60 60 70 70 80 80 90 90 100 100 110 110 Ambient Temperature (°C) n REFERENCE DATA 4 FTR-K1 SERIES FTR-F3 SERIES n DIMENSIONS Standard type l Dimensions l Schematics (BOTTOM VIEW) l PC board mounting hole layout (BOTTOM VIEW) Unit: mm 5 FTR-K1 SERIES FTR-F3 SERIES RoHS Compliance and Lead Free Information 1. General Information All relays produced by Fujitsu Components are compliant with RoHS directive 2011/65/EU including amendments. l Cadmium as used in electrical contacts is exempted from the RoHS directives. As per Annex III of directive 2011/65/EU. l All relays are lead-free. Please refer to Lead-Free Status Info for older date codes at: http://www.fujitsu.com/downloads/MICRO/fcai/relays/lead-free-letter.pdf l Lead free solder plating on relay terminals is Sn-3.0Ag-0.5Cu, unless otherwise specified. This material has been verified to be compatible with PbSn assembly process. l 2. Recommended Lead Free Solder Condition l Recommended solder Sn-3.0Ag-0.5Cu. Flow Solder Condition: Pre-heating: maximum 120˚C within 90 sec. Soldering: dip within 5 sec. at 255˚C ± 5˚C solder bath Relay must be cooled by air immediately after soldering Solder by Soldering Iron: Soldering Iron 30-60W Temperature: maximum 350-360˚C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity l Moisture Sensitivity Level standard is not applicable to electromechanical relays, unless otherwise indicated. 4. Tin Whiskers l Dipped SnAgCu solder is known as presenting a low risk to tin whisker development. No considerable length whisker was found by our in house test. 6 FTR-K1 SERIES FTR-F3 SERIES Fujitsu Components International Headquarter Offices Japan FUJITSU COMPONENT LIMITED Shinagawa Seaside Park Tower 19F, 12-4, Higashi-shinagawa 4-chome, Shinagawa-ku, Tokyo,140-0002, Japan Tel: (81-3) 3450-1682 Fax: (81-3) 3474-2385 Email: fcl-contact@cs.jp.fujitsu.com Web: www.fujitsu.com/jp/fcl/ Asia Pacific FUJITSU COMPONENTS ASIA, LTD. 102E Pasir Panjang Road #01-01 Citilink Warehouse Complex Singapore 118529 Tel: (65) 6375-8560 Fax: (65) 6273-3021 Email: fcal@sg.fujitsu.com Web: www.fujitsu.com/sg/products/devices/components North and South America FUJITSU COMPONENTS AMERICA, INC 2290 North First Street, Suite 212 San Jose, CA 95131, USA Tel: (1-408) 745-4900 Fax: (1-408) 745-4970 Email: components@us.fujitsu.com Web: us.fujitsu.com/components China FUJITSU ELECTRONIC COMPONENTS (SHANGHAI) CO., LTD. Unit 4306, InterContinental Center 100 Yu Tong Road, Shanghai 200070, China Tel: (86-21) 3253 0998 Fax: (86-21) 3253 0997 Email: fcal@sg.fujitsu.com Web: www.fujitsu.com/sg/products/devices/components Europe FUJITSU COMPONENTS EUROPE B.V. Diamantlaan 25 2132 WV Hoofddorp Netherlands Tel: (31-23) 5560910 Fax: (31-23) 5560950 Email: info@fceu.fujitsu.com Web: www.fujitsu.com/uk/components Hong Kong FUJITSU COMPONENTS HONG KONG CO., LTD Unit 506, Inter-Continental Plaza No.94 Granville Road, Tsim Sha Tsui, Kowloon, Hong Kong Tel: (852) 2881-8495 Tex: (852) 2894-9512 Email: fcal@sg.fujitsu.com Web: www.fujitsu.com/sg/products/devices/components/ Korea FUJITSU COMPONENTS KOREA LIMITED Alpha Tower #403, 645 Sampyeong-dong, Bundang-gu, Seongnam-si, Gyeonggi-do, 13524 Korea Tel: (82) 31-708-7108 Fax: (82) 31-709-7108 Email: fcal@sg.fujitsu.com www.fujitsu.com/sg/products/devices/components/ ©2016 Fujitsu Components Europe B.V. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. The contents, data and information in this datasheet are provided by Fujitsu Component Ltd. as a service only to its user and only for general information purposes. The use of the contents, data and information provided in this datasheet is at the users’ own risk. Fujitsu has assembled this datasheet with care and will endeavor to keep the contents, data and information correct, accurate, comprehensive, complete and up to date. Fujitsu Components Europe B.V. and affiliated companies do however not accept any responsibility or liability on their behalf, nor on behalf of its employees, for any loss or damage, direct, indirect or consequential, with respect to this datasheet, its contents, data, and information and related graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof. Nor do Fujitsu Components Europe B.V. and affiliated companies accept on their behalf, nor on behalf of its employees, any responsibility or liability for any representation or warrant of any kind, express or implied, including warranties of any kind for merchantability or fitness for particular use, with respect to these datasheets, its contents, data, information and related graphics and the correctness, reliability, accuracy, comprehensiveness, usefulness, availability and completeness thereof. Rev. February 01st, 2017 7