MB9BF105NPMC

FUJITSU SEMICONDUCTOR FACT SHEET NP706-00004-1v0-E 32-bit Microcontrollers FM3 Family MB9B100 Series MB9B100 series are highly integrated 32-bit microcontrollers that target for high-performance and cost-sensitive embedded control applications. MB9B100 series are based on the ARM Cortex-M3 Processor and on-chip Flash memory and SRAM, and peripheral functions, including Motor Control timers, ADCs and Communication interfaces. ■ FEATURES • ARM Cortex-M3 CPU Processor version：r2p0 ■PRODUCT LINEUP Part number Parameter MB9BF 104N MB9BF 105N MB9BF 106N MB9BF 104R MB9BF 105R MB9BF 106R • Clock • • Maximum clock frequency：80MHz Base Timer：8 chennels Multi-function Timer：2 units 16-bit free-run timer ×3channels/unit Input capture ×4channels/unit Output compare ×6channels/unit A/D activating compare ×3channels/unit Waveform generator 3channels/unit 16-bit PPG timer ×3channels/unit QPRC：2 channels Dual timer：1 unit Watch dog timer：2 channels Multi-function Serial Interface：8 channels Selectable from UART/CSIO/LIN/I2C Type ROM (Byte) RAM (Byte) 256K 32K Flash memory product 384K 48K 512K 64K 256K 32K 384K 48K 512K 64K Plastic・LQFP,100-pins (FPT-100P-M20*/M23) Package Plastic・BGA,112-pins (BGA-112P-M04) *: ES product only Plastic・LQFP,120-pins (FPT-120P-M21) • • • • ■ORDERING INFORMATION Part number MB9BF104NPMC MB9BF105NPMC MB9BF106NPMC MB9BF104RPMC MB9BF105RPMC MB9BF106RPMC MB9BF104NBGL MB9BF105NBGL MB9BF106NBGL Package Plastic・LQFP(0.5mm pitch),100-pin (FPT-100P-M20*/M23) Plastic・LQFP(0.5mm pitch),120-pin (FPT-120P-M21) Plastic・PFBGA(0.8mm pitch),112-pin (BGA-112P-M04) • External bus interface • DMA Controller：8 channels • External interrupt Controller Unit - Up to 16 external vectors - Include one non-maskable interrupt(NMI) • 12-bit A/D converter：16 channels • Low power consumption mode Sleep mode Timer mode Stop mode • I/O port MB9BF104N/F105N/F106N：80(Max.) MB9BF104R/F105R/F106R：100(Max.) ■PACKAGE EXAMPLE OF REFERENCE • • • • On-chip debug Low-voltage detection reset circuit Clock supervisor counter Power supply：2.7～5.5V *The range of the power supply voltage is different according to the operating frequency and the operating temperature. Plastic ・ LQFP、100-pins (FPT-100P-M23) ARM is the registered trademark of ARM Limited in the EU and other countries. Cortex-M3 is trademark of ARM Limited in the EU and other countries. February, 2011 1/2 Copyright©2010-2011 FUJITSU SEMICONDUCTOR LIMITED All rights reserved MB9B100 Series ■ BLOCK DIAGRAM MB9BF104/105/106 TRSTX,TCK TDI,TMS TDO TRACED[3:0], TRACECLK SWJ-DP TPIU ETM ROM Table Code RAM 16/24/32 Kbyte Flash I/F Multi-layer AHB (Max.80MHz) Cortex-M3 Core I @80MHz(Max.) D MPU NVIC Dual-Timer WatchDog Timer (Software) Security On-Chip Flash 256/384/512 Kbyte On-Chip SRAM 16/24/32 Kbyte Sys INITX Clock Reset Generator WatchDog Timer (Hardware) AHB-APB Bridge: APB0(Max.40MHz) CSV CLK X0 X1 X0A X1A AVCC, AVSS,AVRH AN[15:0] ADTG[8:0] DMAC 8ch RST AHB-AHB Bridge Main Osc Sub. Osc PLL CR 4MHz CR 100KHz MAD[24:0] A/D Converter x3 12bit A/D Converter 12bit A/D Converter 12bit A/D Converter Base Timer 16-bit 8ch /32-bit 4ch AHB-APB Bridge : APB1 (Max.40MHz) External Bus IF MDATA[15:0] MCSX[7:0], MOEX,MWEX, MNALE, MNCLE MNWEX, MNREX, MDQM[1:0] Regurator Ctrl TIOA[7:0] TIOB[7:0] AIN[1:0] BIN[1:0] ZIN[1:0] Power On Reset AHB-APB Bridge : APB2 ( Max.40MHz) IRQ-Monitor CRC Accelerator Watch Counter External Interrupt Controller 16-pin + NMI MODE-Ctrl Regurator + LVD Regurator + LVD VCC,VSS C QPRC 2ch A/D Activation Compare 3ch IC0[3:0] IC1[3:0] 16-bit Input Capture 4ch 16-bit FreeRun Timer 3ch 16-bit Output Compare 6ch Waveform Generator 3ch 16-bit PPG 3ch Multi Function Timer x2 INT[15:0] NMIX FRCK[1:0] MD[1:0] P0[F:0], P1[F:0], DTTI[1:0]X RTO0[5:0] RTO1[5:0] GPIO PIN-Function-Ctrl ・ ・ Px[x:0], *HW flow control(ch.4) Multi Serial IF 8ch (with FIFO ch.4∼7) SCK[7:0] SIN[7:0] SOT[7:0] CTS4 RTS4 ■ STARTER KIT A starter kit for FM3 Family manufactured by IAR Systems and KEIL will be on market. A high performance board (made by IAR Systems) or a simple board (made by KEIL) can be selected by the usage. • IAR Systems By using IAR Systems made starter kit, evaluation by high performance board is possible. (Expected release date: April 2011) • KEIL By using KEIL made starter kit, evaluation by simple board is possible. (Expected release date: April 2011) NP706-00004-1v0-E February, 2011 2/2 Copyright©2010-2011 FUJITSU SEMICONDUCTOR LIMITED All rights reserved