SE-3A015VC

SOLID STATE RELAY MAXIMUM LOAD CURRENT 1.5 A / 2A SE SERIES n FEATURES l l RoHS compliant Conforms to UL, CSA standards Ultra slim and light weight, SIL terminals type Size: 5.0 (W) × 20.0 (L) × 17.0 (H)mm — Weight: approximately 4.0 g — l High reliability, long life and maintenance free l High isolation (between input and output) Dielectric strength: 2,500 Vrms — l Internal zero cross circuit type available l RoHS compliant since date code: 6522 (May 22nd, 2006) Please see page 5 for more information n ORDERING INFORMATION [Example] (a) (b) (c) (d) (e) (f) SE – 12 A 02 V F (a) (b) (c) (d) (e) (f) SE : SE Series 3: 3 VDC 5: 5 VDC 12: 12 VDC 24: 24 VDC A : AC type 015 : 1.5 A 02 : 2.0 A Nil: No varistor V : Varistor type (2.0A type only) F: No zero cross type C: ero cross type Z Series Name Nominal Voltage (Input side) Load Voltage Load Current Output Protection Zero Cross Circuit 1 SE SERIES n SPECIFICATIONS INPUT side Item Nominal Voltage (DC) Operate Range Must Operate Voltage AC 1.5 A no zero zero cross cross 3 V, 5 V, 12 V, 24 V ± 20% of nominal voltage 80% of nominal voltage 130Ω 180Ω ±10% ±10% ±10% ±10% no zero cross AC 2.0 A zero cross Remarks Must Release Voltage Minimum 1 VDC 3 VDC Type 130Ω 180Ω OUTPUT side 5 VDC Type 330Ω 470Ω 330Ω 470Ω Input Impedance 12 VDC Type 1.0 kΩ 1.5 kΩ 1.0 kΩ 1.5 kΩ 24 VDC Type Load Voltage Range Maximum Load Current Minimum Load Current 1 Cycle Surge Current 2.2 kΩ 3.0 kΩ 2.2 kΩ 3.0 kΩ AC 24 to 265V rns 1.5 Arms 10 mArms 50 A (60 Hz 1 cycle) 0.5 mA rms 1.0 mA rms 1.0 mA rms 2.0 mA rms 1/2 cycle + max.1 ms 2.0 Arms see CHARACTERISTIC DATA Max. Off-State Leakage Current (at 100 V rms 60 Hz) (at 200 V rms 60 Hz) Max. On-State Voltage Drop 1.2 V rms 1 ms 1.3 V rms at maximum load current Maximum Operate Time Maximum Release Time Operating Temperature Range Storage Temperature Range Case Color Weight 1/2 cycle + 1 ms max.1 ms 1/2 cycle +1ms max. –30°C to + 85°C –40°C to +100°C Black Approximately 3.5 g 5.1 g n INSULATION Item Resistance (initial) Surge Voltage AC 1.5A type 2,500V rms 1min. AC 2.0A type Note Input - Output Minimum 1,000 MΩ (500VDC) 2 SE SERIES n BLOCK DIAGRAM LOAD INSULATIONCIRCUITS Input/Output waveform (resistive load) Source voltage of load ON Input signal OFF Load current AC Photo-triac coupler *: only 2A type had varistor n CHARACTERISTIC DATA SE-( )A015 type (1.5 A type) SE-( )A02 type (2.0A type) Ambient Temperature vs. Maximum Load Current Maximum Load Current (A) 2.0 1.8 1.6 1.4 1.2 1.0 0.8 0.6 0.4 0.2 0 -30 -20 -10 0 10 20 40 60 3.5 VDC 12 VDC 24 VDC 0.6A 0.5A 0.4A 80 100 Ambient Temperature (ºC) n REFERENCE DATA Distribution of Operate and Release Voltage 100 SE-5A02VF n=50 80 100 Distribution of ON-State Voltage Drop SE-5A02VF n=50 AC 2.0 A Distribution of OFF-State Leakage Current 100 SE-5A02VF n=50 AC 200 V (60 Hz) Operate Release 80 80 60 Distribution (%) Distribution (%) Distribution(%) 60 60 40 40 40 20 20 20 0 0 10 20 30 40 50 60 70 80 0 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 1.3 1.4 1.5 0 0.3 0.4 0.5 0.6 0.7 0.8 0.9 1.0 1.1 1.2 1.3 Nominal Voltage Multiplying Factor (%) ON State Voltage Drop (Vrms) OFF State Leakage Current (mA mrs) 3 SE SERIES n DIMENSIONS l Dimensions SE- ( ) A015 type l Schematics (BOTTOM VIEW) l PC board mounting hole layout (BOTTOM VIEW) SE- ( ) A02 type Unit: mm n NOTES When large noise and surge are impressed on the load side, there is the possibility of the occurence of malfunction or damage.In such a case, a varistor should be inserted in the circuit. 20.0+0.2 4 SE SERIES RoHS Compliance and Lead Free Relay Information 1. General Information Relays produced after the specific date code that is indicated on each data sheet are lead-free now. Most of our signal and power relays are lead-free. Please refer to Lead-Free Status Info. (http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf) l Lead free solder paste currently used in relays is Sn-3.0Ag-0.5Cu. l All signal and most power relays also comply with RoHS. Please refer to individual data sheets. Relays that are RoHS compliant do not contain the 5 hazardous materials that are restricted by RoHS directive (lead, mercury, chromium IV, PBB, PBDE). l It has been verified that using lead-free relays in leaded assembly process will not cause any problems (compatible). l “LF” is marked on each outer and inner carton. (No marking on individual relays). l To avoid leaded relays (for lead-free sample, etc.) please consult with area sales office. l We will ship leaded relays as long as the leaded relay inventory exists. Note: Cadmium was exempted from RoHS on October 21, 2005. (Amendment to Directive 2002/95/EC) l 2. Recommended Lead Free Solder Profile l Recommended solder paste Sn-3.0Ag-0.5Cu. Reflow Solder condition Flow Solder condition: Pre-heating: Soldering: maximum 120˚C dip within 5 sec. at 260˚C soler bath Solder by Soldering Iron: Soldering Iron Temperature: maximum 360˚C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity l Moisture Sensitivity Level standard is not applicable to electromechanical realys. Dipped SnAgCu solder is known as low risk tin whisker. No considerable length whisker was found by our in house test. 4. Tin Whisker l 5 SE SERIES Fujitsu Components International Headquarter Offices Japan Fujitsu Component Limited Gotanda-Chuo Building 3-5, Higashigotanda 2-chome, Shinagawa-ku Tokyo 141, Japan Tel: (81-3) 5449-7010 Fax: (81-3) 5449-2626 Email: promothq@ft.ed.fujitsu.com Web: www.fcl.fujitsu.com North and South America Fujitsu Components America, Inc. 250 E. Caribbean Drive Sunnyvale, CA 94089 U.S.A. Tel: (1-408) 745-4900 Fax: (1-408) 745-4970 Email: components@us.fujitsu.com Web: http://www.fujitsu.com/us/services/edevices/components/ Europe Fujitsu Components Europe B.V. Diamantlaan 25 2132 WV Hoofddorp Netherlands Tel: (31-23) 5560910 Fax: (31-23) 5560950 Email: info@fceu.fujitsu.com Web: emea.fujitsu.com/components/ Asia Pacific Fujitsu Components Asia Ltd. 102E Pasir Panjang Road #01-01 Citilink Warehouse Complex Singapore 118529 Tel: (65) 6375-8560 Fax: (65) 6273-3021 Email: fcal@fcal.fujitsu.com Web: http://www.fujitsu.com/sg/services/micro/components/ ©2008 Fujitsu Components America, Inc. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. Fujitsu Components America or its affiliates do not warrant that the content of datasheet is error free. In a continuing effort to improve our products Fujitsu Components America, Inc. or its affiliates reserve the right to change specifications/datasheets without prior notice. Rev. January 18, 2008. 6