SG-12A03

SOLID STATE RELAY MAXIMUM LOAD CURRENT 3 A SG Series n FEATURES l l RoHS compliant Conforms to UL, CSA Standards Slim, SIL Terminal Type —Size: 9.0 (W) × 40.0 (L) × 20.0(H) mm —Weight: approximately 13g l High reliability, long life and maintenance free l High isolation (between input and output) —Dielectric stength: 2,500 Vrms l Internal zero cross circuit type available l Internal output surge absorber (varistor) type available. l RoHS compliant since date code: 6703 (July 3rd, 2006) Please see page 5 for more information [Example] n ORDERING INFORMATION SG – 12 A 03 C V L (a) (b) (c) (d) (e) (f) (g) (a) (b) (c) (d) (e) (f) (g) Series Name Nominal Voltage (Input side) Load Voltage Load Current Zero Cross Circuit Varistor Input Terminal Distance SG: SG Series 3 : 3 VDC 5: 5 VDC 12: 12 VDC 24: 24 VDC A: AC type : 03 3 A rms Nil: No zero cross tyoe C: Zero cross type Nil: No varistor type V : Internal varistor type Nil: 7.62 mm L: 5.08 mm 1 SG SERIES ■ SPECIFICATIONS Item AC TYPE 3 A 3 V, 5 V, 12 V, 24 V ± 20% of nominal voltage 80% of nominal voltage Minimum 1 V 130Ω ±10% 330Ω ±10% 1.0 kΩ ±10% 2.2 kΩ ±10% 75 to 265 Vrms 3.0 Arms 10 mArms CHARACTERISTIC DATA Remarks INPUT side Nominal Voltage (DC) Operate Range Must Operate Voltage Must Release Voltage 3 VDC Type 5 VDC Type Input Impedance 12 VDC Type 24 VDC Type OUTPUT side Load Voltage Range Maximum Load Current Minimum Load Current 1 Cycle Surge Current 132 A (60 Hz) 2.5 mArms (at 100 Vrms 60 Hz) 5.0 mArms (at 200 Vrms 60 Hz) 1.5 Vrms at max. load current Max. Off-state Leakage Current Max. Off-state Voltage Drop at no zero cross type Max. Operate Time at zero cross type Max. Release Time Insulation Resistance Dielectric Strength Operating Temperature Range Storage Temperature Range Case Color Weight 1 ms 1/2 cycle + 1 ms 1/2 cycle + 1 ms for input-output M inimum 1,000 MΩ (at 500 VDC) –30°C to + 85°C –40°C to + 100°C Black Approximately 13g ,500 Vrms for 1 minute for input-output 2 n INSULATION Item Resistance (initial) Surge Voltage AC 3.0A type Minimum 1,000 MΩ (500VDC) 2,500V rms 1 min. Note Input-output ■ BLOCK DIAGRAM LOAD INSULATION 2+ CIRCUITS Trigger circuit Photo-triac coupler Input circuit ~3 Snubber circuit Varistor Output terminal ~4 Input/Output waveform (resistive load) Source voltage of load Input signal ON OFF Load current AC Photo-triac coupler Input terminal 1– 2 SG SERIES ■ CHARACTERISTIC DATA SG-A03 (3.0A type) Ambient Temperature vs. Maximum Load Current 3.5 Maximum Load Current (A) 3.0 2.5 2.0 1.5 1.0 0.5 0 -20 0 20 40 60 80 100 Ambient Temperature (ºC) ■ DIMENSIONS ● Dimensions SG-( ) A03 Type 40.0+0 9.0+0 ● Schematics (BOTTOM VIEW) ● PC board mounting hole layout (BOTTOM VIEW) 7.62 20.0+0 12.7 10.16 5.84 1 2 3 ~ 4 ~ OUTPUT 2.8 + INPUT 0.7 7.62 12.7 10.16 5.84 2.8 4.0 4-ø1.2 0.5 SG-( ) A03L Type 40.0+0 9.0+0 5.08 12.7 10.16 5.84 1 2 3 ~ 4 ~ OUTPUT 2.8 0.7 5.08 12.7 10.16 5.84 2.8 0.5 4.0 20.0+0 -+ INPUT 4-ø1.2 Unit: mm 3 SG SERIES ■ NOTES 1. Polarity of terminals are pre-determined. Please design accordingly. 2. If using non-Varistor enclosure type please use Varistor type as in Figure 1. 2 SSR 1 3 Load Varistor 4 Load power source 4 SG SERIES RoHS Compliance and Lead Free Relay Information 1. General Information Relays produced after the specific date code that is indicated on each data sheet are lead-free now. Most of our signal and power relays are lead-free. Please refer to Lead-Free Status Info. (http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf) l Lead free solder paste currently used in relays is Sn-3.0Ag-0.5Cu. l All signal and most power relays also comply with RoHS. Please refer to individual data sheets. Relays that are RoHS compliant do not contain the 5 hazardous materials that are restricted by RoHS directive (lead, mercury, chromium IV, PBB, PBDE). l It has been verified that using lead-free relays in leaded assembly process will not cause any problems (compatible). l “LF” is marked on each outer and inner carton. (No marking on individual relays). l To avoid leaded relays (for lead-free sample, etc.) please consult with area sales office. l We will ship leaded relays as long as the leaded relay inventory exists. Note: Cadmium was exempted from RoHS on October 21, 2005. (Amendment to Directive 2002/95/EC) l 2. Recommended Lead Free Solder Profile l Recommended solder paste Sn-3.0Ag-0.5Cu. Reflow Solder condition Flow Solder condition: Pre-heating: Soldering: maximum 120˚C dip within 5 sec. at 260˚C soler bath Solder by Soldering Iron: Soldering Iron Temperature: maximum 360˚C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity l Moisture Sensitivity Level standard is not applicable to electromechanical realys. Dipped SnAgCu solder is known as low risk tin whisker. No considerable length whisker was found by our in house test. 4. Tin Whisker l 5 SG SERIES Fujitsu Components International Headquarter Offices Japan Fujitsu Component Limited Gotanda-Chuo Building 3-5, Higashigotanda 2-chome, Shinagawa-ku Tokyo 141, Japan Tel: (81-3) 5449-7010 Fax: (81-3) 5449-2626 Email: promothq@ft.ed.fujitsu.com Web: www.fcl.fujitsu.com North and South America Fujitsu Components America, Inc. 250 E. Caribbean Drive Sunnyvale, CA 94089 U.S.A. Tel: (1-408) 745-4900 Fax: (1-408) 745-4970 Email: components@us.fujitsu.com Web: http://www.fujitsu.com/us/services/edevices/components/ Europe Fujitsu Components Europe B.V. Diamantlaan 25 2132 WV Hoofddorp Netherlands Tel: (31-23) 5560910 Fax: (31-23) 5560950 Email: info@fceu.fujitsu.com Web: emea.fujitsu.com/components/ Asia Pacific Fujitsu Components Asia Ltd. 102E Pasir Panjang Road #01-01 Citilink Warehouse Complex Singapore 118529 Tel: (65) 6375-8560 Fax: (65) 6273-3021 Email: fcal@fcal.fujitsu.com Web: http://www.fujitsu.com/sg/services/micro/components/ ©2008 Fujitsu Components America, Inc. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. Fujitsu Components America or its affiliates do not warrant that the content of datasheet is error free. In a continuing effort to improve our products Fujitsu Components America, Inc. or its affiliates reserve the right to change specifications/datasheets without prior notice. Rev. January 18, 2008. 6