FS14

FS12 thru FS1CH Surface Mount Schottky Rectifier Reverse Voltage 20~200V Forward Current 1A Features • • • • • • • • Low VF Schottky barrier diodes Very low profile - typical height of 1.0 mm Low forward voltage drop Low leakage current Moisture sensitivity: level 1, per J-STD-020 AEC-Q101 qualified High temperature soldering guaranteed: 260℃/10 seconds Halogen-free according to IEC 61249-2-21 definition eSGA (SOD-123FL) Typical Applications For use of fast swiching in RF module, lighting, cellular phone, portable device, power supplies and other consumer applications. Maximum Ratings (TA = 25 °C unless otherwise noted) Parameter Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum average forward rectified current Peak forward surge current 8.3 ms single half sinewave superimposed on rated load Operating junction temperature range Storage temperature range Electrical Characteristics Parameter Test Conditions Maximum instantaneous forward voltage IF=0.5A,TA=25℃ IF=1 A,TA=25℃ Maximum DC reverse current at TA=25℃ rated DC blocking voltage TA=125℃ juntion to ambient juntion to case Typical thermal resistance1) juntion to mount Symbol FS12 FS13 FS14 FS16 FS1B VRRM VRMS VDC IF(AV) 20 30 40 60 100 150 200 V 14 21 28 42 70 105 140 V 20 30 40 60 1.0 100 150 200 V FS1B5H FS1CH A 30.0 IFSM A - 55 to + 150 - 55 to + 150 TJ TSTG Unit - 55 to + 175 °C °C Unit (TA = 25 °C unless otherwise noted) Symbol VF IR FS12 FS13 FS14 0.45 0.40 0.50 200 200 10 30 FS16 FS1B FS1B5H FS1CH 0.55 0.75 0.80 0.70 0.81 0.90 200 150 200 20 RθJA RθJC 90 RθJM 20 60 Volts uA mA ℃/W Note:1),The thermal resistance from junction to ambient,case or mount,mounted on P.C.B with 5×5mm copper pads,2 OZ,FR4 PCB www.goodark.com 1/4 2013.12-Rev.A FS12 thru FS1CH Surface Mount Schottky Rectifier Reverse Voltage 20~200V Forward Current 1A Ratings and Characteristics Curves (TA = 25℃ unless otherwise noted) Average Forward Rectified Current, （A） 1 0.8 0.6 0.4 FS12 thru FS1B 0.2 FS1B5H thru FS1CH 0 0 25 50 75 100 125 150 Mount temperature（℃） Figure 2.Maximum Non-Repetitive Peak Forward Surge Current Figure 1.Forward Current Derating Curve Figure 3. Typical Instantaneous Reverse Characteristics Figure 4. Typical Junction Capacitance Figure 5. Typical Instantaneous Forward Characteristics www.goodark.com 2/4 2013.12-Rev.A FS12 thru FS1CH Surface Mount Schottky Rectifier Reverse Voltage 20~200V Forward Current 1A Package Outline Dimensions DIM Unit: mm Unit: inch MIN MAX MIN MAX A 0.9 1.08 0.035 0.043 A1 0 0.1 0.000 0.004 B 0.85 1.05 0.033 0.041 C 0.1 0.25 0.004 0.010 D 1.7 2 0.067 0.079 E 2.9 3.1 0.114 0.122 L 0.43 0.83 0.017 0.033 HE 3.5 3.9 0.138 0.154 Soldering footprint Packing Information Packing quantities: 3000 pcs/Reel, 40 Reels/Box; 8mm Tape, 7" Reel Tape & Reel Specification www.goodark.com 3/4 2013.12-Rev.A FS12 thru FS1CH Surface Mount Schottky Rectifier Reverse Voltage 20~200V Forward Current 1A Disclaimers These materials are intended as a reference to assist our customers in the selection of the Suzhou GoodArk product best suited to the customer’s application; they do not convey any license under any intellectual property rights, or any other rights, belonging to Suzhou Good-Ark Electronics Co., Ltd.or a third party. Suzhou Good-Ark Electronics Co., Ltd. assumes no responsibility for any damage, or infringement of any third-party ’ s rights, originating in the use of any product data, diagrams, charts, programs, algorithms, or circuit application examples contained in these materials. All information contained in these materials, including product data, diagrams, charts, programs and algorithms represents information on products at the time of publication of these materials, and are subject to change by Suzhou Good-Ark Electronics Co., Ltd. without notice due to product improvements or other reasons. It is therefore recommended that customers contact Suzhou Good-Ark Electronics Co., Ltd. or an authorized Suzhou Good-Ark Electronics Co., Ltd. for the latest product information before purchasing a product listed herein. The information described here may contain technical inaccuracies or typographical errors. Suzhou Good-Ark Electronics Co., Ltd. assumes no responsibility for any damage, liability, or other loss rising from these inaccuracies or errors. Please also pay attention to information published by Suzhou Good-Ark Electronics Co., Ltd. by various means, including our website home page. (http://www.goodark.com) When using any or all of the information contained in these materials, including product data, diagrams, charts, programs, and algorithms, Please be sure to evaluate all information as a total system before making a final decision on the applicability of the information and products. Suzhou Good-Ark Electronics Co., Ltd. assumes no responsibility for any damage, liability or other loss resulting from the information contained herein. The prior written approval of Suzhou Good-Ark Electronics Co., Ltd. is necessary to reprint or reproduce in whole or in part these materials. Please contact Suzhou Good-Ark Electronics Co., Ltd. or an authorized distributor for further details on these materials or the products contained herein. www.goodark.com 4/4 2013.12-Rev.A