SBL1030

SBL10xx, SBLF10xx & SBLB10xx Series Reverse Voltage 30 to 40 Volts Schottky Barrier Rectifiers Forward Current 10.0 Amperes Features Plastic package has Underwriters Laboratory Flammability Classification 94V-0 Dual rectifier construction, positive center tap Metal silicon junction, majority carrier conduction Low power loss, high efficiency Guardring for overvoltage protection For use in low voltage, high frequency inverters, free wheeling, and polarity protection applications High temperature soldering guaranteed: 250°C/10 seconds, 0.25" (6.35mm) from case Mechanical Data Case: JEDEC TO-220AC, ITO-220AC & TO-263AB molded plastic body Terminals: Plated leads, solderable per MIL-STD-750, Method 2026 Polarity: As marked Mounting Position: Any Mounting Torque: 10 in-lbs maximum Weight: 0.08 ounce, 2.24 grams TO-220AC ITO-220AC TO-263AB(D2PAK) Mounting Pad Layout TO-263AB Dimensions in inches and (millimeters) 347 Maximum Ratings and Electrical Characteristics ( TC = 25oC unless otherwise noted ) Parameter Maximum repetitive peak reverse voltage Working peak reverse voltage Maximum DC blocking voltage Maximum average forward rectified current (See Fig. 1) Peak forward surge current 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage at 10A (Note 4) Maximum instantaneous reverse current at DC blocking voltage (Note 4) TC=25 C TC=100oC o Symbol VRRM VRWM V DC IF(AV) IFSM VF IR S B L 1030 30 30 30 10 250 0.60 1.0 S B L 1040 40 40 40 Unit Volts Volts Volts Amps Amps Volts mA 50.0 Typical thermal resistance from junction to case RMS Isolation voltage (SBLF type only) from terminals to heatsink with t = 1.0 second, RH < 30% Operating junction temperature range Storage temperature range Notes: RθJC VISOL TJ TSTG SBL 2.0 / SBLF 5.0 / SBLB 2.0 4500 (Note 1) 3500 (Note 2) 1500 (Note 3) -55 to +125 -55 to +150 o C/W Volts o C C o 1. Clip mounting (on case), where lead does not overlap heatsink with 0.110" offset 2. Clip mounting (on case), where leads do overlap heatsink 3. Screw mounting with 4-40 screw, where washer diameter is < 4.9 mm (0.19") 4. Pulse test: 300us pulse width, 1% duty cycle 348 RATINGS AND CHARACTERISTIC CURVES ( TA = 25oC unless otherwise noted ) 349