G2SBA480-E

G2SBA480-E SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER Voltage: 800V Current:4.0A Features Plastic package has Underwriters Laboratory Flammability Classification 94V-0 Glass passivated chip junction High case dielectric strength Typical IR less than 0.1μA High surge current capability Ideal for printed circuit board High temperature soldering guaranteed: 260 ℃ /10 seconds, 0.375”(9.5mm) lead length, 5lbs.(2.3kg) tension GBL Mechanical Data Terminal: Plated leads solderable per MIL-STD 750, Method 2026 Case: Molded plastic body over passivated junctions Polarity: Polarity symbol marked on body Mounting position: any Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Symbol Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum average forward Tc = 50℃(Note1) rectified output current Ta = 40℃(Note2) Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage drop per leg at 2.0A Rating for fusing (t < 8.3ms) Maximum DC reverse current at rated DC blocking voltage per leg Maximum thermal resistance per leg Operating junction and storage temperature range Ta = 25° C Ta = 125° C Vrrm Vrms Vdc If(av) Ifsm Vf I2t Ir Rth(ja) Rth(jc) Tj, Tstg G2SBA480-E 800 560 800 4.0 3.0 120 1.0 60 5.0 500 47.0 10.0 -55 to +150 units V V V A A V A2Sec µA ℃/W ℃ Note: 1. Unit mounted on P.C.B. with 3.0 x 3.0 x 0.11" thick (7.5 x 7.5 x 0.3 cm) Aluminum plate 2. Unit mounted on P.C.B. at 0.375" (9.5mm) lead length and 0.5 x 0.5"(12 x 12mm) copper pads 3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw Rev.A1 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES G2SBA480-E Rev.A1 www.gulfsemi.com