GBU8D

GBU8A THRU GBU8M SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER Voltage: 50 to 1000V 8.0A Current: Features Ideal for printed circuit board Glass passivated chip junction High case dielectric strength High surge overload rating This series is UL listed under Recognized Component Index, file number E185029 GBU Mechanical Data Terminal: Plated leads solderable per MIL-STD 202E, method 208C Case: UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Mounting position: Thru hole for #6 screw Dimensions in millimeters MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Symbol Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum average forward rectified output current at Tc = 100℃ (Note 1) Peak forward surge current single sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage drop per leg at 8.0A Rating for fusing (t < 8.3ms) Maximum DC reverse current at rated DC blocking voltage per leg Typical junction capacitance per leg at 4V,1MHz Maximum thermal resistance per leg Operating junction and storage temperature range (Note3) Ta = 25° C Ta = 125° C Vrrm Vrms Vdc If(av) Ifsm Vf I2t Ir Cj Rth(ja) Rth(jc) Tj, Tstg 211 21 2.2 -55 to +150 GBU 8A 50 35 50 GBU 8B 100 70 100 GBU 8D 200 140 200 GBU 8G 400 280 400 8.0 200 1.0 166 5.0 500 94 GBU 8J 600 420 600 GBU 8K 800 560 800 GBU 8M 1000 700 1000 units V V V A A V A2Sec µA pF ℃/W ℃ Note: 1. Unit case mounted on 3.2 x 3.2 x 0.12” thick (8.2 x8.2 x 0.3cm) Al. Plate heatsink 2. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw 3. Units mounted in free air, no heatsink on P.C.B. with 0.5 x 0.5" (12 x 12mm) copper pads, 0.375" (9.5mm) lead length Rev.A3 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES GBU8A THRU GB8M Rev.A3 www.gulfsemi.com