H7710-12

Compact Side-on PMT Photosensor Modules H7710/H8567 Series The H7710/H8567 series photosensor modules contain a high-voltage power supply circuit and a 13-mm (1/2") diameter side-on photomultiplier tube in a compact aluminum housing. The 13-mm (1/2") side-on photomultiplier tube has a reflection mode photocathode that delivers high quantum efficiency at wavelengths above 600 nm, an adequate gain of up to 107 and fast time response. A high S/N ratio can be obtained even when measuring extremely low level light at high speeds. The H7710 series uses a Cockcroft-Walton circuit with low power consumption, while the H8567 series has a high-voltage power supply circuit comprised of a Cockcroft-Walton circuit and an active divider circuit to shorten the settling time. Select the desired type that meets your application. Five types are available according to the required spectral response range. Flexible cables are used for easy installation in equipment. Product Variations Type No. H8567-01 H7710-11 H8567-02 H7710-12 H8567-03 H7710-13 H8567-04 H7710-14 H8567-05 H7710-15 Spectral Response 185 nm to 750 nm 185 nm to 900 nm 185 nm to 900 nm 185 nm to 830 nm 185 nm to 650 nm Features High sensitivity in UV to visible range For general applications in UV to near IR range High sensitivity in UV to near IR range Low dark current in UV to near IR range For general applications in UV to visible range Specifications Suffix Parameter H7710 Series H8567 Series H7710 / H8567 Series -13 -14 -15 -03 -04 -05 +11.5 to +15.5 +18 7 25 10 +1.2 (Input impedance H7710 Series: 1 MΩ, H8567 Series: 100 kΩ) +0.25 to +1.0 3.7 × 13.0 1: 104 340 420 450 400 530 80 20 350 200 140 120 40 500 300 200 10 5 — — — — — 0.4 0.3 0.15 48 90 105 77 70 100 50 1000 400 300 700 300 2000 2000 700 5.2 × 105 3.6 × 105 4.2 × 105 5.2 × 105 2.5 × 105 1 1 2 0.1 0.5 10 10 10 1 5 1.4 H7710 Series H8567 Series 0.6 0.6 10 0.2 +5 to +50 +5 to +45 -20 to +50 100 -11 -01 -12 -02 Unit — V V mA µA V V mm — nm µA/lm — — mA/W A/lm A/W nA ns mV s °C °C g Input Voltage Max. Input Voltage Max. Input Current H7710 Series H8567 Series Max. Output Signal Current Max. Control Voltage Recommended Control Voltage Adjustment Range Effective Area Sensitivity Adjustment Range Peak Sensitivity Wavelength Min. Luminous Sensitivity Typ. Blue Sensitivity Index (CS 5-58) Red/White Ratio Radiant Sensitivity *1 Min. Luminous Sensitivity *2 Typ. Radiant Sensitivity *1 *2 Typ. Dark Current *2 *3 Max. Rise Time *2 Ripple Noise *2 *4 (peak to peak) Max. Settling Time *5 Operating Ambient Temperature Storage Temperature Weight Anode Cathode 22 *1: Measured at the peak sensitivity wavelength *2: Control voltage = +1.0 V *3: After 30 minute storage in darkness *4: Cable RG-174/U, Cable length 450 mm, Load resistance = 1 MΩ, Load capacitance = 22 pF *5: The time required for the output to reach a stable level following a change in the control voltage from +1.0 V to +0.5 V. Current Output Type Photosensor Modules Characteristics (Cathode radiant sensitivity, PMT gain) 1000 TPMOB0138EB TPMOB0139EB TPMOB0140EB 1000 H7710-13 H8567-03 Type H7710-12 H8567-02 Type 108 CATHODE RADIANT SENSITIVITY (mA/W) CATHODE RADIANT SENSITIVITY (mA/W) 100 H7710-11 H8567-01 Type 107 100 106 H7710-15 H8567-05 Type 10 H7710-15 H8567-05 Type 10 PMT GAIN H7710-14 H8567-04 Type 105 H7710-11 H8567-01 Type 104 1 103 1 0.1 100 200 300 400 500 600 700 800 900 0.1 100 200 300 400 500 600 700 800 900 102 0.25 0.3 0.5 0.7 1.0 1.5 2.0 WAVELENGTH (nm) WAVELENGTH (nm) CONTROL VOLTAGE (V) Sensitivity Adjustment Method Voltage Programming PHOTOSENSOR MODULE COAXIAL CABLE RED (LOW VOLTAGE INPUT) BLACK (GND) BLUE (Vref OUTPUT) WHITE (Vcontrol INPUT) POWER SUPPLY SIGNAL OUTPUT Resistance Programming PHOTOSENSOR MODULE COAXIAL CABLE RED (LOW VOLTAGE INPUT) BLACK (GND) BLUE (Vref OUTPUT) WHITE (Vcontrol INPUT) MONITOR POTENTIOMETER (10 kΩ) When using a potentiometer, adjust sensitivity while monitoring the control voltage. POWER SUPPLY SIGNAL OUTPUT +15 V GND +15 V GND CW • Electrically insulate the reference voltage output. • Adjust the control voltage to adjust the sensitivity. +0.25 V to +1.0 V GND TPMOC0146EB Dimensional Outlines (Unit: mm) 19.0 ± 0.5 9.5 2.1 8.8 PHOTOCATHODE WINDOW Details of input window 9 7 3.7 19.7 49.0 ± 0.5 20.5 18 16 EFFECTIVE AREA (3.7 × 13.0) MOUNTING THREADED HOLE (4-M2 DEPTH: 4) 12.0 ± 0.2 3.5 50.8 ± 0.5 450 ± 20 FRONT VIEW SIDE VIEW 8.8 TPMOA0013ED 6.0 1.5 7 WINDOW 9 TOP VIEW PHOTOCATHODE FRONT VIEW TPMOA0018ED 13 WINDOW (7 × 16) 53.2 ± 0.5 COAX CABLE : RG-174/U OTHER WIRES: AWG 26 EFFECTIVE AREA (3.7 × 13.0) 23