MBRF30200CT

Schottky Barrier Rectifier MBRF30200CT, 2x 15A, 200V, ITO-220AB, Common Cathode MBRF30200CT RoHS Pb Description Littelfuse MBR series Schottky Barrier Rectifier is designed to meet the general requirements of commercial applications by providing high temperature, low leakage and low VF products. It is suitable for high frequency switching mode power Supply, free-wheeling diodes and polarity protection diodes. Features • H  igh junction temperature capability Pin out Heat sink on e • H  igh frequency operation • Common  cathode configuration in electrically isolated ITO220AB package • G  uard ring for enhanced ruggedness and long term reliability Common Cathode • Low forward voltage drop 3 ode K e 1 3 2 1 Anode Common Anode Cathode Anode Common Anode Cathode Pinout 2 TO-220AB Common Cathode Maximum Ratings • S  witching mode power supply • DC/DC converters • Polarity protection diodes • Free-wheeling diodes Pinout 3 ITO-220AB Common Cathode Parameters Symbol Peak Inverse Voltage VRWM Average Forward Current 30 (total device) Peak Repetitive Forward Current(per leg) Heat sink Cathode Cathode 3 Applications 3 2 Cathode Peak One 1 Anode Non-Repetitive Cycle Current 2 (per leg) Surge Test Conditions Max Unit - 200 V IF(AV) 50% duty cycle @TC = 109°C, rectangular wave form 15 (per leg) IFRM Rated VR square wave, 20KHz TC = 133°C 20 A IFSM Surge applied at rated load conditions halfwave, single phase,60Hz 150 A A Pinout 5 TO-220AC Electrical Characteristics Parameters Forward Voltage Drop (per leg) * Symbol Test Conditions Max VF1 @ 15A, Pulse, TJ = 25 °C 0.90 VF2 @ 15A, Pulse, TJ = 125 °C 0.75 IR1 @VR = rated VR TJ = 25 °C 1.0 IR2 @VR = rated VR TJ = 125 °C 6.0 Junction Capacitance (per leg) CT @VR = 5V, TC = 25 °C, fSIG = 1MHz Voltage Rate of Change dv/dt Reverse Current (per leg) * RSM Isolation Voltage (t = 1.0 second, R. H. < =30%, TA = 25 °C) VISO Unit V mA 400 pF 10,000 V/μs Clip mounting, the epoxy body away from the heatsink edge by more than 0.110” along the lead direction. 4500 Clip mounting, the epoxy body is inside the heatsink. 3500 Screw mounting, the epoxy body is inside the heatsink. 1500 V * Pulse Width < 300μs, Duty Cycle