P0304UBLRP

0XOWLSRUW6,'$&WRUŠ'HYLFH RoHS ¨ 1 (R1) 6 (T2) 2 (G1) 5 (G2) 3 (T1) 4 (R2) The multiport line protector is an integrated multichip solution used for protecting multiple twisted pair from overvoltage conditions. Based on a six-pin surface mount SOIC package, it is equivalent to four discrete DO-214AA. This multiport line protector is ideal for densely populated, high-speed line cards that cannot tolerate PCB inefficiencies nor the use of series power resistors. SIDACtor devices enable equipment to comply with various regulatory requirements including GR 1089, ITU K.20, K.21, and K.45, IEC 60950, UL 60950, and TIA-968-A (formerly known as FCC Part 68). Electrical Parameters Part Number * VDRM Volts VS Volts VDRM Volts Pins 1-2, 3-2, 4-5, 6-5 VS Volts Pins 1-3, 4-6 VT Volts IDRM μAmps IS mAmps IT Amps IH mAmps P0084U_L 6 25 12 50 4 5 800 2.2 50 P0304U_L 25 40 50 80 4 5 800 2.2 50 P0644U_L 58 77 116 154 4 5 800 2.2 150 P0724U_L 65 88 130 176 4 5 800 2.2 150 P0904U_L 75 98 150 196 4 5 800 2.2 150 P1104U_L 90 130 180 260 4 5 800 2.2 150 P1304U_L 120 160 240 320 4 5 800 2.2 150 P1504U_L 140 180 280 360 4 5 800 2.2 150 P1804U_L 170 220 340 440 4 5 800 2.2 150 P2304U_L 190 260 380 520 4 5 800 2.2 150 P2604U_L 220 300 440 600 4 5 800 2.2 150 P3104U_L 275 350 550 700 4 5 800 2.2 150 P3504U_L 320 400 640 800 4 5 800 2.2 150 * “L” in part number indicates RoHS compliance. For non-RoHS compliant device, delete “L” from part number. For individual “UA”, “UB”, and “UC” surge ratings, see table below. General Notes: • All measurements are made at an ambient temperature of 25 °C. IPP applies to -40 °C through +85 °C temperature range. • IPP is a repetitive surge rating and is guaranteed for the life of the product. • Listed SIDACtor devices are bi-directional. All electrical parameters and surge ratings apply to forward and reverse polarities. • VDRM is measured at IDRM, and VS is measured at 100 V/μs. Surge Ratings in Amps Series IPP 0.2x310 * 2x10 * 8x20 * 0.5x700 ** 2x10 ** 1.2x50 ** Amps Amps Amps 10x160 * 10x160 ** 10x560 * 10x560 ** 5x320 * 9x720 ** Amps Amps Amps 10x360 * 10x1000 * 5x310 * ITSM 10x360 ** 10x1000 ** 10x700 ** 50 / 60 Hz Amps Amps Amps Amps di/dt Amps/μs A 20 150 150 90 50 75 75 45 75 20 500 B 25 250 250 150 100 100 125 80 100 30 500 C 50 500 400 200 150 200 175 100 200 50 500 * Current waveform in μs ** Voltage waveform in μs www.littelfuse.com 3 - 34 © 2006 Littelfuse, Inc. • Telecom Design Guide 0XOWLSRUW6,'$&WRUŠ'HYLFH Thermal Considerations Package Symbol Modified MS-013 TJ Operating Junction Temperature Range -40 to +150 °C TS Storage Temperature Range -65 to +150 °C 60 °C/W 6 5 4 Parameter Thermal Resistance: Junction to Ambient RθJA 1 Value Unit 2 3 Part Number P0084UAL P0084UBL P0084UCL P0304UAL P0304UBL P0304UCL P0644UAL P0644UBL P0644UCL P0724UAL P0724UBL P0724UCL P0904UAL P0904UBL P0904UCL P1104UAL P1104UBL P1104UCL P1304UAL P1304UBL P1304UCL P1504UAL P1504UBL P1504UCL P1804UAL P1804UBL P1804UCL P2304UAL P2304UBL P2304UCL P2604UAL P2604UBL P2604UCL P3104UAL P3104UBL P3104UCL P3504UAL P3504UBL P3504UCL pF Pin 1-2 / 3-2 (4-5 / 6-5) Tip-Ground, Ring-Ground MIN MAX 25 155 25 155 35 285 15 140 15 140 25 250 40 60 40 155 55 155 35 60 50 145 50 145 35 55 35 55 45 135 30 50 30 115 45 115 25 45 25 105 40 105 25 40 25 95 35 95 25 35 25 90 35 90 25 35 25 85 30 85 20 35 20 85 30 85 20 35 20 80 30 80 20 35 20 75 25 75 pF Pin 1-3 (4-6) Tip-Ring MIN 15 15 20 10 10 10 20 20 30 20 20 25 20 20 25 15 15 25 15 15 20 15 15 20 10 10 15 10 10 15 10 10 15 10 10 15 10 10 15 MAX 90 90 165 90 90 145 35 90 90 35 85 85 30 30 80 30 65 65 25 60 60 25 55 55 20 50 50 20 50 50 20 50 50 20 45 45 20 45 45 Note: Off-state capacitance (CO) is measured at 1 MHz with a 2 V bias. Telecom Design Guide • © 2006 Littelfuse, Inc. 3 - 35 www.littelfuse.com 5+&#%VQT&GXKEGU Capacitance Values 0XOWLSRUW6,'$&WRUŠ'HYLFH IPP – Peak Pulse Current – %IPP +I IT IS IH IDRM -V +V VT VDRM VS Peak Value 100 tr = rise time to peak value td = decay time to half value Waveform = tr x td 50 Half Value 0 0 tr td t – Time (μs) -I 14 12 10 IH 8 6 25 ˚C 4 2 IH (TC = 25 ˚C) tr x td Pulse Waveform Ratio of Percent of VS Change – % V-I Characteristics 0 -4 2.0 1.8 1.6 1.4 25 ˚C 1.2 1.0 0.8 0.6 0.4 -40 -20 0 -6 -8 -40 -20 0 20 40 60 80 100 120 140 160 Case Temperature (TC) – ˚C 20 40 60 80 100 120 140 160 Junction Temperature (TJ) – ˚C Normalized VS Change versus Junction Temperature www.littelfuse.com Normalized DC Holding Current versus Case Temperature 3 - 36 © 2006 Littelfuse, Inc. • Telecom Design Guide