S8201-46R

Customer Information Sheet IF IN DOUBT - ASK DRAWING No.: S8201-46R 16.00 TYP NOT TO SCALE C THIRD ANGLE PROJECTION 2.00 TYP 1.75 4.00 TYP 1.50 +0.10 TYP 0 ALL DIMENSIONS IN mm 330 3.50 3.25 REEL DIMENSIONS 100 MIN 20.20 0.15 13.0 RECOMMENDED PAD LAYOUT (TOLERANCE +0.5 -0.2 0.05) 40.40 19.00 19.80 4.00 4.00 SQUARE 44.00 0.30 3.60 3.50 NEGATIVE CONTACT PAD FULL RAD SECTION X-X 0.20 0.05 1.50 16.10 SINGLE COMPONENT DIMENSIONS SEE DETAIL 13.20 A DETAIL A SCALE 7 +0.10 0 FINISHED REELING DIRECTION DETAIL B SCALE 6 6.9 3.20 ROUND HOLES THIS SIDE DIM 'B' SEE NOTE 4 SPECIFICATION: MATERIAL = PHOSPHOR BRONZE FINISH: 46 = 3µm 100% TIN, OVER NICKEL (DIM 'A') 3.20 0.10 12.70 0.10 4 12.04.22 31470 NAME ISS. DATE CN/CO APPROVED: R.ALEXANDER RA 4.9 CHECKED: M.RUDKIN DRAWN: R.ADDE CUSTOMER REF.: ASSEMBLY DRG: SEE DETAIL B +0.35 19.00 -0.10 NOTES: 1. QUANTITY PER REEL = 1000. 2. THIS PRODUCT IS TAPED AND REELED IN ACCORDANCE WITH EIA-481-2 (ELECTRONIC INDUSTRIES ASSOCIATION). 3. THIS PRODUCT IS SUITABLE FOR THE FOLLOWING BATTERIES: BR1220, BR1225, CR1220 AND CR1225. 4. DIM 'B' IS EQUAL OR UP TO 0.25mm LESS THAN MEASURED VALUE OF DIM 'A'. www.harwin.com technical @harwin.com THIS DRAWING AND ANY INFORMATION OR DESCRIPTIVE MATTER SET OUT HEREON ARE CONFIDENTIAL AND COPYRIGHT PROPERTY OF THE HARWIN GROUP AND MUST NOT BE DISCLOSED, LOANED, COPIED OR USED FOR MANUFACTURING, TENDERING OR FOR ANY OTHER PURPOSE WITHOUT THEIR WRITTEN PERMISSION. TOLERANCES X. X.X X.XX X.XXX = = = = 1mm 0.50mm 0.20mm 0.01mm ANGLES = MATERIAL: TITLE: COIN CELL RETAINER (12mm) (TAPE & REELED) SEE ABOVE FINISH: DRAWING NUMBER: SEE ABOVE 5 UNLESS STATED S/AREA: mm² S8201-46R SHT 2 OF 2