HAC175P-490

H HiTRON UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 175 WATTS CURRENT SHARING SWITCHING POWER SUPPLIES HAC175P & HAC175D SERIES FEATURES: 175W IN 3U X 8HP EUROCARD PACKAGE UNIVERSAL AC INPUT WITH PFC INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE DROOP CURRENT SHARING EMI MEET EN 55022 / FCC CLASS A CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG SPECIFICATION INPUT SPECIFICATION Input Voltage: Typ. 90-264Vac with PFC. Power Factor Correction: Meet Harmonic Correction IEC 61000-3-2. Power Factor typ. 0.98. Input Connector: PCIH47M400A1 for HAC175P. DIN41612 M24/8 for HAC175D. Input Frequency: 47-63Hz. Inrush Current: < 30A @ 230Vac by adding thermistor. Input Current: 2.2A @115Vac/1.1A @230Vac for HAC175D. 2.4A @115Vac/1.2A @230Vac for HAC175P. Dielectric Withstand: Meet IEC 60950-1 regulation. EMI: Meet EN 55022 / FCC Class A. Hold-up Time: 5mS @115V & 230Vac after power fail signal. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection: Installed NTC for thermal sensor at [DEG#] pin. Earth Leakage: Less than 0.5mA @230Vac. OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 175W continuous. Output Connector: PCIH47M400A1 for HAC175P. DIN41612 M24/8 for HAC175D. Line Regulation: Typ. 0.5%. Load Regulation: VO1 & VO2 typ. ±1.0%. VO3 & VO4 typ. ±2.0%. Noise & Ripple: Typ. 1% peak-peak or 50mV, whichever is greater. OVP: Built-in at VO1 & VO2. Adjustability: Available at VO1 & VO2. VO3 factory set. Remote Sensing: Available at VO1 & VO2. Hot-Swap: Available. N+1 Redundancy: Installed with OR-ing diodes for N+1 redundancy operation. Current Sharing: Droop current sharing at all output. Power OK Signal: Available for VO1 & VO2. Over Current Protection (OCP): Installed in all outputs. Overload Protection (OLP): Fully protected against output overload and short circuit. Consult factory for special OLP setting. Operating Temperature: 0 to +50°C at full load with specified air flow. Derates linearly to 50% at +70°C. Storage Temperature: -40°C to +85°C. Temperature Coefficient: Typ. ±0.02% /°C. Cooling: At least 20cfm (600lfm) airflow is required to deliver full rating load. Power Density: 3.2 Watts /Cubic Inch. GENERAL SPECIFICATION Efficiency: Typ. 75-78%. Switching Frequency: 100 KHz. Circuit Topology: Half-bridge circuit. Transient Response: Typ. 1.0mS for a 25% load change. Safety Standard: IEC 60950-1/UL 60950-1 Class I. Construction: Eurocard 3U x 8HP x 160mm CompactPCI format. Front Panel with either Ordinary handle or Extractor handle. Note: Due to requests in market and advances in technology, specifications subject to change without notification. For the details of safety approval, please consult the factory. -1- OUTPUT VOLTAGE / CURRENT RATINGS CHART QUAD OUTPUT MAIN +VO1 @ Min. Typ. Volt. HAC175P-490(E) 0.0A 20A +5V HAC175P-490(O) 0.0A 20A +5V HAC175D-490(O) 0.0A 20A +5V MODEL NO. #=⊙ Max. 35A 35A 35A AUX. +VO2 ▲ #=⊙@ Typ. Max. Volt. 10A +3.3V 20A 10A +3.3V 20A 10A +3.3V 20A AUX. +VO3▲=⊙ (@) Typ. Volt. Max. Peak 3.0A +12V # 5.0A 6A 3.0A +12V # 5.0A 6A 3.0A +12V 5.0A 6A AUX. -VO4 ● =⊙ Typ. Volt. Max. Peak 0.5A -12V 1.0A 1.0A 0.5A -12V 1.0A 1.0A 0.5A -12V 1.0A 1.0A Symbol: " " OVP built-in. "@" Adjustable. "(@)" Adjustable factory set.. "#" Remote sensing. "=" Droop Load Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post Regulator. Remark: Peak load less than 60sec. with duty cycle