HAC250P

H HiTRON UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC HOT-SWAP CompactPCI QUAD OUTPUT 250 WATTS ACTIVE CURRENT SHARING SWITCHING POWER SUPPLIES HAC250P SERIES FEATURES: 250W 3U X 8HP EUROCARD PACKAGE MEET IEC 61000-3-2 HARMONIC CORRECTION INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY HOT-SWAPPABLE THIRD-WIRE CURRENT SHARING EMI MEET EN 55022 / FCC CLASS A CE MARKING COMPLIANCE FULLY COMPLIANT WITH PICMG SPECIFICATION INPUT SPECIFICATION Input Voltage: Typ. 90-264Vac. Power Factor Correction: Meet Harmonic Correction IEC 61000-3-2.Power Factor typ. 0.95-0.97. Input Connector: Positronic 47-pin PCIH47M400A1. Input Frequency: 47-63Hz. Inrush Current: Less than 30A @ 230Vac. Input Current: 2.8A @115Vac/1.4A @230Vac. Dielectric Withstand: Meet IEC 60950-1 regulation. EMI: Meet EN 55022 / FCC Class A. Hold-up Time: 5mS after power fail signal. Earth Leakage: Less than 0.5mA @230Vac. Remote ON/OFF: Available at [INH#] & [EN#] pins. Power Fail Signal: Available at [FAL#] pin. Status LED: means valid input voltage. means a critical fault. Thermal Protection (OTP): Installed NTC and thermostat for thermal sensor at [DEG#] pin. OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: Typ. 250W continuous. Output Connector: Positronic 47-pin PCIH47M400A1. Line Regulation: Typ. 0.1%. Load Regulation: Typ. ±1-2%. Noise & Ripple: Typ. 1% peak to peak or 50mV, whichever is greater. OVP: Built-in at all outputs. Adjustability: Available at VO1,2 & 3. Output Trim: Electrical trim available at VO1/VO2.[ADJ #] Remote Sensing: Available at VO1,VO2 & VO3. Hot-Swap: Available. N+1 Redundancy: Installed with internal OR-ing diodes at all outputs for N+1 redundancy operation. Current Sharing: Third-wire current sharing at VO1,2 &3. Power OK Signal: Available for all output. Over Current Protection (OCP): Installed at each rail. Overload Protection (OLP): Fully protected against output overload or short circuit. Typical 120% max. load. Consult the factory for special OLP setting. GENERAL SPECIFICATION Efficiency: Typ. 78-79 %. Switching Frequency: 120K Hz. Circuit Topology: Forward circuit. Transient Response: Peak transient less than 100mV and recovers within 2mS after 25% load-change. Safety Standard: IEC 60950-1 Class I. Construction: Eurocard 3U X 8HP X 160mm CompactPCI format. Front Panel with either Ordinary handle or Extractor handle. Operating Temperature: 0 to +50 °C at full load with specified air flow. Derates linearly to 50% at +70 °C. Storage Temperature: -40 to +85 °C. Temperature Coefficient: Typ. ±0.02% / °C. Cooling: At least 20 cfm(600 lfm) moving air is required to achieve full rating power 250W in a confined area. Power Density: 4.58 Watts/ Cubic Inch. Note: Due to requests in market and advances in technology, specifications subject to change without notification. For the details of safety approval, please consult the factory. -5- OUTPUT VOLTAGE / CURRENT RATINGS CHART QUAD OUTPUT MAIN +VO1 @★#≡⊙ MODEL NO. Min. HAC250P-490(E) HAC250P-490(O) 0A 0A Typ. 25.0A 25.0A Volt. +5V +5V Max. 33.0A 33.0A Min. 0A 0A Typ. Volt. Max. Min. Typ. Volt. Max. Pk. Min. Typ. Volt. Max. Pk. 0A 0A 5A +12V 5.5A 6A 5A +12V 5.5A 6A 0A 0.5A -12V 1A 1.5A 0A 0.5A -12V 1A 1.5A AUX. +VO2 ▲@★#≡⊙ AUX. +VO3 ▲≡#⊙★@ AUX. –VO4 ●⊙★■= 18A +3.3V 33A 18A +3.3V 33A Symbol: "★" OVP built-in. "@" Adjustable. "#" Remote sensing. "≡" 3rd-wire Load Sharing. "=" Droop Current Sharing. "⊙" Installed with Or-ing diode. "▲" Magnetic Amplifier. "●" Installed with Post-regulator. "■" Common Choke. Remark: Peak load less than 60sec. with duty cycle