HAM16S-480035

H HiTRON ON-BOARD UNIVERSAL INPUT AC-DC ENCAPSULATED MODULAR POWER SUPPLIES 16 WATTS SINGLE & DUAL OUTPUT HAM16S & HAM16D SERIES FEATURES: ON-BOARD AC/DC MODULAR POWER SUPPLIES UNIVERSAL AC INPUT RANGE COMPACT IN SIZE MEET UNIVERSAL SAFETY STANDARDS EMI MEET CISPR PUB.22/ FCC CLASS B CE MARKING COMPLIANCE SPECIFICATION INPUT SPECIFICATION Input Voltage: 90-264Vac. Input Frequency: 47-63 Hz. (50/60 Hz. Nom.). Input Current: 0.33A @115Vac/0.16A @230Vac typical. Inrush Current: 32.5A typical peak @ 230Vac. Input Fuse: Use external fuse. 1.0A/250Vac. for the primary fuse is suggested. Dielectric Withstand: Meet IEC950. 3,000Vac-Output/Input. 1,500Vac-Input/GND. 500Vac-Output/GND. EMI: Meet CISPR PUB.22 / FCC Class B. Hold-up time: 20mS @115Vac, 120mS @230Vac typical. Earth Leakage: Less than 3.5mA @230Vac typical. Remote On/Off: TTL/CMOS-Compatible Output Control. Positive Logic version for Standard set up: ON(Enable)=Open(or 2.5-5.0Vdc above Com) OFF(Disable)=Short(or 0-0.8Vdc above Com) Negative Logic version option available by adding a “N”suffix to the end of Model #. OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Wattage: 12-17 Watts typical. Output Indicator: LED. Line Regulation: Various with output voltage. HAM16S ±0.1% typical. HAM16D ±0.5% typical. Load Regulation: Various with output voltage. HAM16S ±1.0% typical. HAM16D ±2.0-4.0% typical. Noise & ripple: 1.0% typical peak to peak. OVP: Built-in on main output. Adjustability: From -10% of main output till OVP. Overload Protection (OLP): Fully protected against output overload and short circuit. OLP set at about 125-150% rating output wattage. Consult the factory for OLP setting. Operating Temperature: -10 to +70°C range. -10°C to +50°C full load without derating. From +50°C, derating linearly to half load @+70°C. (Refer to Derating Chart.) GENERAL SPECIFICATION Efficiency: 70-82% typical. (Various with output voltage). Switching Frequency: 83K Hz. Circuit Topology: Fixed Frequency Flyback circuit. Transient Response: Typical peak deviation 250mV, Recovery time < 3mS for a 25% load change. Case: Impact resistant thermo-plastic enclosure. Power Density: 3.10Watts. / Cubic inch. Safety Standard: EN60950/ UL1950 Class I. MTBF: 110,000 hours. Mil Std 217, 25°C. Storage Temperature: -20°C to +85°C. Temperature Coefficient: 0.02% /°C. Humidity: Up to 95%RH, Non-condensing. Cooling: Convection cooling for +50°C @ full load. At least 100LFM moving air is recommended for full load >+50°C in a confined area. Commercial Grade only. NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified. (2) Load Regulation measured from Full-Load (F-L) to Half-Load (H-L) at nominal input and others loaded at half load. Due to requests in market and advances in technology, specifications subject to change without notice. -7- OUTPUT VOLTAGE/ CURRENT RATINGS CHART SINGLE OUTPUT MODEL NO. HAM16S-033370 HAM16S-050300 HAM16S-090170 HAM16S-120135 HAM16S-150110 HAM16S-240070 HAM16S-480035 VO1 ★ @ TYP. 3.70A 3.00A 1.70A 1.35A 1.10A 0.70A 0.35A VOLT. 3.3V 5.0V 9.0V 12.0V 15.0V 24.0V 48.0V PEAK 4.44A 3.60A 2.04A 1.62A 1.32A 0.84A 0.42A DUAL OUTPUT MODEL NO. HAM16D-033180 HAM16D-050150 HAM16D-120068 HAM16D-150055 +VO1 ★ @ TYP. VOLT. MAX. 1.80A +3.3V 2.07A 1.50A +5.0V 1.72A 0.68A +12.0V 0.78A 0.55A +15.0V 0.63A TYP 1.80A 1.50A 0.68A 0.55A -VO2 ‖ VOLT. -3.3V -5.0V -12.0V -15.0V MAX. 2.07A 1.72A 0.78A 0.63A Symbols: "★" OVP built-in. "@" Adjustable. "‖" Double Feedback. Note: (1) Max. (maximum load) is the continuous operating load of each rail, but the max. load of each rail can not be drawn from all outputs at the same time. (2) Peak output, less than 60 Sec. with duty cycle