HT506DC

High Temperature Analog Multiplexers 16-Channel Single-Ended / 8-Channel Differential HT506 / HT507 The High Temperature HT506/HT507 monolithic multiplexers consist of sixteen analog switches, 4-bit decode for channel selection, reference for logic switching thresholds, and enable pin for device deactivation where applications require. These multiplexers are fabricated with Honeywell’s dielectrically isolated latch-up free high temperature (HTMOS™) linear process. Performance is specified over the full -55 to +225ºC temperature range. Typically, parts will operate up to +300ºC for a year, with derated performance. All parts are burned in at 250ºC. The input buffers are designed to operate from either TTL or CMOS levels while providing a break-before-make action. The HT506 switches one of the sixteen single-ended inputs to a common output, while the HT507 switches one of the eight differential inputs to a differential output. These parts are available in standard pinout 28-pin DIP Ceramic Packages. Applications  Down-Hole Oil, Gas, and Geothermal Well  Avionics  Turbine Engine Control  Industrial Process Control  Electric Power Conversion  Heavy Duty Internal Combustion Engine FEATURES AND BENEFITS  Specified over -55 to +225 C  Designed to continuously operate for at least 5 years at 225 C  16:1 Single-Ended or 8:1 Differential Configuration  Enable and address inputs compatible with TTL and/or 5V CMOS logic  No latch-up  10V analog input/output range (±5V or 0 to 10V)  On resistance 400Ω at 225ºC  Split and single supply capability  Output leakage less than 2.5µA at 225ºC  Break-Before-Make Switching HT506/HT507 PACKAGE PINOUTS ELECTRICAL CHARACTERISTICS (Split Supply) Temperature range -55 to +225 C, typical @ +25 C, V+ = +5V, V- = -5V, GND=0V, VIL=0.8, VIH = 2.4V, unless otherwise specified Symbol Parameters Test Conditions Typical (1) Analog Switch VANALOG Analog Signal Range rDS(ON) Drain-Source On-Resistance ∆rDS(ON) rDS(ON) Matching between Channels IS(OFF) Source Off Leakage Current ID(OFF) Drain Off Leakage Current ID(ON) Drain On Leakage Current Digital Control VIH Logic High Input Voltage VIL Logic Low Input Voltage IIH Logic High Input Current IIL Logic Low Input Current CIN Logic Input Capacitance Dynamic Characteristics tON Address/Enable Turn-On Time tOFF Address/Enable Turn-Off Time Q Charge Injection OIS Off Isolation Power Supplies I+ Positive Supply Current INegative Supply Current Worst Case (2) MIN MAX -5 VD ±5V, IS = -10mA Sequence Each Switch On VD = ±5V VEN = 0V VD= ±5V, VEN = 0V, VS = ±5V Sequence Each Switch On 5 V 100 400 Ω 2 0.01 0.04 0.04 200 2500 2500 % nA nA nA -2500 -2500 2.4 0.8 VA = 2.4V, 10V VEN = 0V, 2.4V, VA =0V f=1MHz trise/tfall