SRV05-4SF6

Low Capacitance Steering Diode/ TVS Diode Array SRV05-4 FEATURES • Transient Protection for High Speed Data Lines to IEC 61000-4-2 (ESD) ±15kV (Air), ±8kV (Contact) • Array of Surge Rated Diodes with Internal TVS Diode • Protects Four I/O Lines • Low Operating Voltage: 5V • Low Capacitance • Low Clamping Voltage SOT-23-6 APPLICATIONS • • • • • • • High Speed Communication Line Protection USB 2.0 Power and Data Line Protection Monitors and Flat panel Display Digital Video Interface (DVI) 10/100/1000 Ethernet Notebook Computers IEEE 1394 Firewire Ports ORDERING INFORMATION Device Package SRV05-4SF6 SOT-23-6L DESCRIPTION The SRV05-4 of transient voltage suppressors (TVS) is designed to protect high speed data interfaces which are connected to data and transmission lines from overvoltage caused by electrostatic discharge (ESD), electrical fast transients (EFT), and lightning. The SRV05-4 incorporates eight surge rated, low capacitance steering diodes and a TVS diode in a single package. During transient conditions, the steering diodes direct the transient to either the positive side of the power supply line or to ground. The internal TVD diode prevents over-voltage on the power line, protecting any down-stream components. The low capacitance array configuration allows the user to protect four high-speed data or transmission line. The low inductance construction minimizes voltage overshoot during high current surges. PIN CONFIGURATION AND BLOCK DIAGRAM Jul. 2020 – R1.0 I/O REF I/O 6 5 4 1 2 3 I/O GND I/O 1/4 HTC Low Capacitance Steering Diode/ TVS Diode Array SRV05-4 ORDERING INFORMATION Package Order No. Description SOT-23-6L SRV05-4SF6 Low Capacitance Diode Array Supplied As Status Tape & Reel Active ABSOLUTE MAXIMUM RATINGS (Note 1) CHARACTERISTIC SYMBOL VAULUE UNIT Peak Pulse Power (tp = 8/20 µs) PPK 200 W Peak Pulse Current (tp = 8/20 µs) IPP 10 A VESD 8 (Contact), 15 (Air) kV TJ 125 °C TSTG −55 to +150 °C ESD Immunity Voltage Max Operating Junction Temperature Storage Temperature Note1. Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only and functional operation of the device at these or any other conditions beyond those indicated under Recommended Operating Conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability. ELECTRICAL CHARACTERISTICS Limits are for TA = 25°C unless otherwise noted. PARAMETER Reverse Stand-Off Voltage Breakdown Voltage SYMBOL VRWM TEST CONDITIONS Pin 5 to 2 MIN TYP MAX UNIT - - 5.0 V VBR It = 1mA, Pin 5 to 2 5.8 6.5 - V Reverse Leakage Current IR VR =5 V, Pin 5 to 2 - - 5.0 µA Forward Voltage VF IF = 15mA - - 1.15 V Clamping Voltage VC IPP = 1.0 A, tp = 8/20 µs, Any I/O Pin to Pin 2 - - 10 V IPP = 5.0 A, tp = 8/20 µs, Any I/O Pin to Pin 2 - - 15 V IPP = 10 A, tp = 8/20 µs, Any I/O Pin to Pin 2 - - 20 V VR = 0 V, f = 1 MHz, Any I/O Pin to Pin 2 - 3.3 5.0 pF VR = 0 V, f = 1 MHz, Between I/O Pins - 1.5 - pF Junction Capacitance Jul. 2020 – R1.0 CJ 2/4 HTC Low Capacitance Steering Diode/ TVS Diode Array SRV05-4 TYPICAL OPERATING CHARACTERISTICS T.B.D. Jul. 2020 – R1.0 3/4 HTC Low Capacitance Steering Diode/ TVS Diode Array SRV05-4 REVISION NOTICE The description in this data sheet is subject to change without any notice to describe its electrical characteristics properly. Jul. 2020 – R1.0 4/4 HTC