1-1617088-4

CII Low Signal Relays Double Pole, Magnetic Latching, 2 Amps and Less (Continued) Magnetic Latching, Grid-space, Relays Type 3SAM (2PDT) n Special shock designs up to 700 G, 1 ms n Suitable for pulse operation n No hang up feature on low power pulses n Qualified to MIL-R-39016/32 n Special wiring is available This relay has “memory” in that the contact positions do not change when coil power is removed. Switching is accomplished by applying power to the applicable coil (dual coil) or with the applicable polarity (single coil). The low switching power requirements are further enhanced by its ability to operate from capacitor discharge or other pulses or through its own contacts for batteries or similarly limited supplies. † Applicable over the operating temperature range in circulating air. ‡ Initial or inspection value. Allow 20% increase in value of maximum pickup during rated life. Ordering Instructions Example: The relay selected in this example is a 2PDT magnetic latching relay, current calibrated, fourhole end bracket mounting, solder hook header, 1500 ohms coil resistance, and 75 mW sensitivity. By choosing the proper code for each Operating Characteristics Contact Ratings — DC resistive — 2 amps at 28 volts DC inductive — 0.5 amps at 28 volts, 200 mH AC resistive — 1 amp at 115 volts (single coil), case not grounded AC resistive — 0.25 amps at 115 volts (dual coil), case not grounded Low-level — 50 µA at 50 mV Peak AC or DC Contact Resistance — 0.050 ohms initial; 0.100 ohms after life test Life — 100,000 operations at rated load; 1,000,000 at low-level Operate Time — 4 ms Release Time — 4 ms Contact Bounce — 2 ms Dielectric Strength — 1,000 volts rms at sea level; 700 volts rms across contact gap Insulation Resistance — 1,000 megohm min. 1 CII Low Signal Relays Product Facts Electrical Characteristics Environmental Characteristics Vibration — 30 G, to 3,000 Hz Shock — 150 G at 11 ms Temperature — -65°C to +125°C See page 1-52 for Mounting Forms, Terminals and Circuit Diagrams. † Applicable over the operating temperature range in circulating air. ‡ Initial or inspection value. Allow 20% increase in value of maximum pickup during rated life. of these relay characteristics, the catalog number is identified as 3SAM6014N2. The letter R following sensitivity code indicates relay received 5000 operation miss-test. Ex. 3SAM6014N2R. * The part number example shown on this page is for catalog items. For a list of specific QPL part numbers, please see the index in Section 15. 1-51 Catalog 5-1773450-5 Revised 3-13 www.te.com Dimensions are shown for reference purposes only. Specifications subject to change. Dimensions are in millimeters unless otherwise specified. USA: +1 800 522 6752 Asia Pacific: +86 0 400 820 6015 UK: +44 800 267 666 For additional support numbers please visit www.te.com CII Low Signal Relays Double Pole, Magnetic Latching, 2 Amps and Less (Continued) Mounting Forms (3SAM) (Vibration note with each form is acceleration from 55 to 3000 Hz) Header and Connection Diagrams Header Types 1-52 Catalog 5-1773450-5 Revised 3-13 www.te.com Dimensions are shown for reference purposes only. Specifications subject to change. Dimensions are in millimeters unless otherwise specified. USA: +1 800 522 6752 Asia Pacific: +86 0 400 820 6015 UK: +44 800 267 666 For additional support numbers please visit www.te.com