1051156-1

Instruction Sheet   SMA Right-Angle Cable Plugs 408-4831 30 AUG 11 Rev B 2. DESCRIPTION The plug connector consists of a housing subassembly and disc. See Figure 1. 3. ASSEMBLY PROCEDURE Housing Subassembly Disc DESCRIPTION PART NUMBER 1311055-1 1051156-1 1311563-1 1056931-1 1313729-1 SMA Right-Angle Cable Plugs 1088312-1 1051157-1 DANGER Follow safety precautions included with the tools used for assembly. STOP  1. Strip the cable to the dimensions shown in  Figure 2. 2. Secure the threaded end of the housing subassembly onto the locator tool. Secure the assembly in a small bench vise. 3. Tin the cable center conductor. CAUTION If using microporous cable, do not allow flux or solvent on or near the cable dielectric. !  1223286-1 1313559-1 1313278-1 1082030-1 Figure 1 5. Place the soldering iron on the tip of the contact, and solder. 1. INTRODUCTION The SMA Right-Angle Cable Plugs listed in Figure 1 were designed to be soldered onto .141 or .085 semirigid coaxial cable, or .141 semi-rigid microporous cable using the following tool: TE CONNECTIVITY M/A-COM Locator Tool 1055451-1 2098-5218-0217 (T-2367) i 6. Solder the housing subassembly to the cable. Refer to Figure 4, Detail A. 1.27 [.05] Dielectric PART NUMBER TOOL DESCRIPTION NOTE 4. Insert the center conductor into the housing subassembly. See Figure 3, Detail A. Make sure that the conductor is positioned in the slot of the contact inside the housing and the cable dielectric is against the contact. See Figure 3, Detail B. Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Figures are not drawn to scale. Reasons for reissue of this instruction sheet are provided in Section 4, REVISION SUMMARY. 90° 1.27 / 1.524 [.05 / .06] Center Conductor Jacket Note: Not to Scale Figure 2 7. Refer to Figure 4, Detail B, and install the disk onto the housing subassembly according to the following preferred option: Option 1 - Press the disk into the opening in the housing subassembly, and secure with epoxy. Do not allow epoxy to enter the housing subassembly. Option 2 - Tin the perimeter of the opening in the housing subassembly. Do not allow solder to enter the housing subassembly. Press the disk into the opening, then apply heat to the disk. 8. Remove the locator tool. © 2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company All Rights Reserved *Trademark TOOLING ASSISTANCE CENTER 1-800-722-1111 PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.te.com TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. 1 of 2 LOC B 408-4831 Dielectric Detail A Solder Here Detail A Housing Subassembly Center Conductor Locator Tool Center Conductor in Slot of Contact and Dielectric Against Contact Detail B Press Disc Here Detail B Figure 4 Figure 3 4. REVISION SUMMARY Updated document to corporate requirements. Rev B 2 of 2