1055251-1

Instruction Sheet  Installation Tool 1055251-1 for  SMA Hermetic Plug Connectors 408-8864 26 MAR 12 Rev A Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available. Threaded Cap Handle (Torque Driver) TOOL TE CONNECTIVITY PART NUMBER PREVIOUS PART NUMBER 1055251-1 2098-0248-54 Installation Tool 1055803-1 2098-5071-53 Replacement Head Assembly DESCRIPTION CONNECTOR TYPE PRESET TORQUE SMA Hemetic Plug Connector ± 2 Inch-Pounds Figure 1 1. INTRODUCTION Installation Tool 1055251-1 (Figure 1) is used to install and remove SMA Hermetic Plug Connectors. Figure 1 also lists the available replacement head that may be purchased from TE Connectivity separately. NOTE i Dimensions in this document are in metric units [with U.S. customary units in brackets], unless otherwise indicated. 2. Once the connector is in place, rotate the threaded cap to hold the connector in the tool. 3. Holding the handle, turn the tool clockwise to thread the plug connector together. 4. Continue turning the handle (and connector) until the drive handle makes a “clicking” sound. This clicking sound is an indication that the proper torque has been reached. 5. Rotate the tool counterclockwise to release the connector. 2. DESCRIPTION Installation Tool 1055251-1 contains an adjustable handle that allows for torque settings between  6 in.-lbs. and 30 in.-lbs. This tool also contains a connector-specific head assembly. A threaded cap at the end of the assembly, holds the connector. 3.2. Removal 1. Thread the hermetic plug connector in the threaded cap. 2. Once the connector is in place, rotate the threaded cap to hold the connector in the tool. 3. Holding the handle, turn the tool counterclockwise to unthread the plug connector. 3. INSTALLATION AND REMOVAL 3.1. Installation 1. Thread the hermetic plug connector in the threaded cap. © 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company All Rights Reserved *Trademark TOOLING ASSISTANCE CENTER 1-800-722-1111 PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.te.com TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. 1 of 2 ORIGINAL INSTRUCTIONS PROPER USE GUIDELINES 408-8864 4. REPLACEMENT 5. REVISION SUMMARY The torque driver contains a 6.35 [.250] square  drive which accepts the replacement head (shown in Figure 1). Since the previous version of this document, the following changes were made: 1. Pull the head off the standard 6.35 [.250] square drive. 2. Snap the replacement head (Figure 1) onto the square drive. • Changed “six” to “6” in Section 2. • Added “ORIGINAL INSTRUCTIONS”. • Updated document to corporate requirements. 3. Order replacements from your TE representative, or call 1-800-526-5142, or send a facsimile of your purchase order to 1-717-986-7605, or write to: CUSTOMER SERVICE (038-035) TYCO ELECTRONICS CORPORATION PO BOX 3608 HARRISBURG PA 17105-3608 For customer repair service, call 1-800-526-5136. Rev A 2 of 2