2119700-1

Instruction Sheet 408-10465 LightKnack Portable Magnetic L.E.D. Light 2119700-1 ORIGINAL INSTRUCTIONS 21 SEP 11 Rev A Figure 1 Figure 2 1. INTRODUCTION 3. Remove the old batteries. The LightKnack Portable Magnetic L.E.D. Light (see Figure 1) is designed to provide light where it is needed. The light affixes to any magnetic surface via two powerful rare earth magnets, and the housing is made from rugged, glass-filled plastic. 4. Check that the switch and L.E.D. are in place. The light’s housing is contoured specifically to fit on the TE Connectivity CERTI-CRIMP* II hand tool heads as shown in Figure 1. 2. BATTERY REPLACEMENT (Figure 2) The LightKnack L.E.D. Light runs on two CR1216 batteries (included). These batteries can be replaced by performing the following procedure: NOTE TE does not sell the batteries, but they are commonly available. i 1. Remove the four screws at the bottom of the light. 2. Remove the bottom cover. ©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company All Rights Reserved *Trademark 5. Place the new batteries in the light with the positive side toward the bottom cover. 6. Replace the bottom cover and the four screws. 3. ORDERING INFORMATION/REPLACEMENT PARTS The LightKnack L.E.D. Light can be ordered in packages of three using part number 2119700-1. To order this part, contact your TE Representative, or call 1-800-526-5142, or send a facsimile of your purchase order to 1-717-986-7605, or write to: CUSTOMER SERVICE (038-035) TYCO ELECTRONICS CORPORATION PO BOX 3608 HARRISBURG PA 17105-3608 4. REVISION SUMMARY • Initial release of document TOOLING ASSISTANCE CENTER 1-800-722-1111 PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.te.com TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. 1 of 1 LOC B