3-1617804-1

SERIES FCAV-210 RELAY-NONLATCH 5 Ampere/ 230VAC-400 Hz, 2PDT *Contacts rated at 230 VAC for higher voltage systems on more electric aircraft. PRODUCT FACTS: o Non latching Hermetically Sealed Relay o Balanced force design. o Permanent Magnet drive. Polarized single side stable design. o All welded construction o Coils Available : DC: 6, 12 and 28VDC. AC: 28,115 VAC (50/400Hz). o Contacts: Silver Cadmium Oxide with Gold plating. o Designed and built in accordance with MIL- PRF-83536. o Weight 45.4 grams (1.6 ounces) Max. PRODUCTION DATA SHEET 11JUN10 Rev PH. 828-338-1087 FAX 828-338-1103 1396 CHARLOTTE HIGHWAY, FAIRVIEW, NC 28730 , CARPINTERIA, CA 93013 Dimensions shown for reference Only. Specifications subject to change. SERIES FCAV-210 CAGE CODE SHEET SCALE NONE REV 11/06/10 1 of 6 GENERAL CHARACTERISTICS Temperature range -70° C to +125° C Altitude 300,000 feet Dielectric strength at sea level - All circuits to ground and circuit to circuit. 1250 Vrms - Coil to ground 1000 Vrms Dielectric strength at altitude 80,000 FEET 350Vrms Insulation resistance: Initial at 500 Vdc 100 MΩ min. After life or environmental test 50 MΩ min. Vibration Sinusoidal:* Z,Y & X Enclosures 30G for 33 to 3000 Hz W & M Enclosures (STUD MTG.) Vibration, Random:* 20G for 33 to 3000 Hz 2 Z, Y & X Enclosures 0.4 g /Hz 50-2000Hz 2 W & M Enclosures (STUD MTG.) Shock:* 0.2 g /Hz 50-2000Hz Z, Y & X Enclosures 200g For 6 ms W & M Enclosures (STUD MTG.) 100g For 6 ms Operate time at nominal voltage : DC Relays 10 ms Max. : AC Relays 15 ms Max. Release time at nominal voltage : DC Relays 10 ms Max. : AC Relays 50 ms Max. *Max.contact opening under vibration or shock 10 microseconds. COIL DATA: Coil Code Nominal Voltages Freq. Hz DC Res. AC AMPS(B) 1 2 3 4(A) 5 6 7 8 9 6 12 28 28 48 28 VAC 28 VAC 115 VAC 115 VAC DC DC DC DC DC 400 Hz 50/400 Hz 400 Hz 50/400 Hz 20Ω 80Ω 320Ω 320Ω 920Ω 180 mA 100 mA 40 mA 30 mA Over Temperature Range Pick up or Below Volts 4.5 9.0 18.0 18.0 32.0 22.0 22.0 90.0 95.0 Dropout or above Volts 0.3 0.75 1.5 1.5 2.5 1.25 1.25 5.0 5.0 Must Hold voltage(C) 2.5 4.5 7.0 7.0 14.0 10.0 10.0 40.0 40.0 PRODUCTION DATA SHEET 11JUN10 Rev PH. 828-338-1087 FAX 828-338-1103 1396 CHARLOTTE HIGHWAY, FAIRVIEW, NC 28730 , CARPINTERIA, CA 93013 Dimensions shown for reference Only. Specifications subject to change. SERIES FCAV-210 CAGE CODE SHEET SCALE NONE REV 11/06/10 2 of 6 A. Code 4 coils have back EMF suppression to 42 Volts max. B. DC Coil Resistance ± 10% at 25 degree C. C.Relay will stay in picked-up state down to Must Hold Voltages shown. D. Max Overvoltage: 6 & 12 VDC Coils 120% of Nominal; All others 110% of nominal. E.Coils available for other voltages and for AC 50/60 Hz. CONTACT ELECTRICAL CHARACTERISTICS Type of Load Resistive Inductive Motor Lamp Life(Min.) Cycles X103 28VDC 115VAC 400 Hz 230VAC 400Hz 100 10 10 20 8 8 4 100 4 100 2 2 * 60 Hz Loads rated for 10000 operations 5 - 115/200 VAC 3φ 400Hz 60Hz* 10 2.5 8 2.5 4 2.0 2 1 A. Overload Current 40 Amps DC, 60 Amps 400 Hz. B. Rupture Current 50 Amps DC, 80 Amps 400 Hz. C. Contact Make Bounce 1 Millisecond at Nominal Voltage. D. Max. Contact drop at 10 Amps: initial 0.100 Volts. E. End of Life 0.125 Volts. All endurance ratings are subject to validation - consult factory PART NUMBERING SYSTEM How to order-: (Example) FCAV- 210- A Y 4 RELAY TYPE TERMINALS (Socket Pins, DC Coil) ENCLOSURE (With Flanges) COIL (28 VDC with transient Suppression) PRODUCTION DATA SHEET 11JUN10 Rev PH. 828-338-1087 FAX 828-338-1103 1396 CHARLOTTE HIGHWAY, FAIRVIEW, NC 28730 , CARPINTERIA, CA 93013 Dimensions shown for reference Only. Specifications subject to change. SERIES FCAV-210 CAGE CODE SHEET SCALE NONE REV 11/06/10 3 of 6 CODE “D” Socket Pins – 115 VAC TERMINALS CODE “A” Socket Pins, Gold Plated – All DC Coils. CODE “B” Circuit Board Pins, Tin/Lead Plated CODE “E” Socket Pins – 28 VAC Coils Same as Code “D” except polarizing Pin turned 90° t o this plane. CODE “F” Circuit Board Pins 115 VAC Coils CODE “C” Solder Hook Terminals (Hook TERMINALS TIN/LEAD PLATED). Dimensions are shown in inches ± .010 and (Millimeters ± .25). PRODUCTION DATA SHEET 11JUN10 Rev PH. 828-338-1087 FAX 828-338-1103 1396 CHARLOTTE HIGHWAY, FAIRVIEW, NC 28730 , CARPINTERIA, CA 93013 Dimensions shown for reference Only. Specifications subject to change. SERIES FCAV-210 CAGE CODE SHEET SCALE NONE REV 11/06/10 4 of 6 CODE “H” 90°Solder Pins All pins Bright Acid Tin/lead CODE “G” Circuit Board Pins 28 VAC Coils Same as Code “F” except polarizing Pin turned 90° To this plane. ENCLOSURES CODE “Y” CODE “Z” CODE “X” CODE “W” DC COILS **Dim. “A” -AC Coils 1.125 in. (28.57) Max. -DC Coils 1.010 in. (25.65) Max. PRODUCTION DATA SHEET 11JUN10 Rev PH. 828-338-1087 FAX 828-338-1103 1396 CHARLOTTE HIGHWAY, FAIRVIEW, NC 28730 , CARPINTERIA, CA 93013 Dimensions shown for reference Only. Specifications subject to change. SERIES FCAV-210 CAGE CODE SHEET SCALE NONE REV 11/06/10 5 of 6 TERMINAL WIRING DIAGRAM DC COILS WITH TRANSIENT SUPPRESSION AC COILS 115 VAC DC COILS AC COILS 28 VAC TERMINAL LAYOUT NOTES: 1. POLARITY MUST BE OBSERVED WITH DC COIL SUPPLY.RELAY IS POLARIZED AND WILL NOT OPERATE OR BE DAMAGED BY REVERSE POLARITY. 2. DIODES USED IN TRANSIENT SUPPRESSION AND IN AC RECTIFIER CIRCUITS HAVE PEAK INVERSE VOLTAGE RATING OF 600 VDC MIN. ZENER DIODES HAVE MIN. RATING OF 1 WATT. 3. TERMINAL DESIGNATIONS ARE FOR REFERENCE ONLY & DO NOT APPEAR ON THE HEADER. PRODUCTION DATA SHEET 11JUN10 Rev PH. 828-338-1087 FAX 828-338-1103 1396 CHARLOTTE HIGHWAY, FAIRVIEW, NC 28730 , CARPINTERIA, CA 93013 Dimensions shown for reference Only. Specifications subject to change. SERIES FCAV-210 CAGE CODE SHEET SCALE NONE REV 11/06/10 6 of 6