5028D5312-9

5028D5312 SPECIFICATION CONTROL DRAWING CHEMINAX 50 OHM, AWG 28, 7 STRANDS OF AWG 36, TRIAXIAL CABLE Date 7-15-13 Revision E THIS SPECIFICATION SHEET FORMS A PART OF THE LATEST ISSUE OF RAYCHEM SPECIFICATION 1200. CONSTRUCTION DETAILS DIMENSIONS ARE NOMINAL VALUES IN INCHES UNLESS OTHERWISE DESIGNATED. .0150 .039 ± .003 CONDUCTOR AWG 28, 7 Strands of AWG 36, Silver-Coated Copper DIELECTRIC Rayfoam L Color - Natural 1 SHIELD AWG 40, Silver-Coated Copper st .052 .072 1st JACKET Thermorad F Color - White ELECTRICAL CHARACTERISTICS CHARACTERISTIC IMPEDANCE 50 ± 2 ohms, Method A CAPACITANCE 27.8 pF/ft. (nominal) 28.3 pF/ft. (maximum) VELOCITY OF PROPAGATION 73% (nominal) ATTENUATION 92.0 dB/100 ft. (maximum) at 4 GHz ADDITIONAL REQUIREMENTS ELECTRICAL CONDUCTOR RESISTANCE 62.0 ohms/1000 ft. (nominal) INSULATION RESISTANCE CONDUCTOR TO SHIELD 10,000 megohms (minimum) for 1000 ft. JACKET FLAWS SPARK TEST IMPULSE TEST 1.0 kV (rms) 6.0 kV (peak) VOLTAGE WITHSTAND CONDUCTOR TO SHIELD SHIELD TO SHIELD 750 volts (rms) (minimum) 500 volts (rms) (minimum) ENVIRONMENTAL .085 2nd SHIELD AWG 40, Silver-Coated Copper FLAMMABILITY Method C HEAT SHOCK 225°C LOW TEMPERATURE-COLD BEND -55°C/3.00 inch mandrel VOLTAGE WITHSTAND (Post Environmental) 1000 volts (rms), 1 minute PHYSICAL .105 (nominal) .110 (maximum) 2nd JACKET Thermorad F INSULATION (DIELECTRIC) ELONGATION TENSILE STRENGTH 50% (minimum) 1000 lbf/in2 (minimum) JACKET (EACH) ELONGATION TENSILE STRENGTH 100% (minimum) 2000 lbf/in2 (minimum) JACKET THICKNESS (EACH) .008 inch (minimum) .010 inch (nominal) SHIELD COVERAGE (EACH) 90% (minimum) WEIGHT 8.8 lbs/1000 ft. (nominal) Outer jacket color will be white (designated by a “-9)" appended to the part number, e.g. 5028D5312-9) unless otherwise specified. Designate outer jacket color with a dash number in accordance with MIL-STD-681. Other codes and suffixes may be added to the part number, as necessary, to capture any additional requirements imposed by the purchase order. Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics Corporation also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. Page 1 of 1 Rayfoam, Thermorad, Cheminax, Raychem, TE Connectivity, TE connectivity (logo) and TE (logo) are trademarks. Raychem Wire & Cable 501 Oakside Avenue Redwood City, California 94063-3800 1-800-227-8816 Fax: 1-650-361-6297 THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. © 2013 Tyco Electronics Corporation, All rights reserved.