5414-10-130408

CUSTOMER DRAWING KIT COMPONENTS: A standard kit shall contain 1 piece each: Adapter, Boot, SolderShield® Splice, Atum tubing (Kit description ends in "A” only) 1. ADAPTER (STRAIGHT, 45 OR 95 DEGREE). Refer to TXR (XX) Adapter drawings for details where (XX) = Adapter Code. Available Adapter Codes (XX): 15, 18, 21, 30, 32, 40, 41, 54, 61 2. MOLDED BOOTS. Available Sizes: 13, 23, 34, 44, 56, 67. : 3. SolderShield® SPLICES. Available Sizes: 00, 04, 05, 06, 07, 08, 09, 10, 11, 12, 13, 14, 16. Use code 00 when a non-pre-braided adapter is used. (Pre-Braided Code - 0). 4. SHIM TUBING. (KIT DESCRIPTIONS END WITH LETTER “A” ONLY) EXPANDED AS SUPPLIED FULLY RECOVERED AFTER HEATING TITLE: T-FIT ADAPTER AND MOLDED BOOT KITS Unless otherwise specified dimensions are in inches. [Metric dimensions are shown in brackets] TOLERANCES: ANGLES: ± 0°30’ 0.00 ± 0.02 MM 0.0 ± 0.2 MM 0 ± 0.5 MM ROUGHNESS IN MICRON PREPARED BY: CAGE CODE: Raychem Devices Tyco Electronics Corporation reserves the right to amend this drawing at any time. Users should evaluate the suitability of the product for their application. ECO NUMBER: DOCUMENT NO.: T-FIT-2-12X REV: REV DATE: January 18, 2018 AN SCALE: YNGUYEN 06090 ECO-18-000887 © 2007-2018 TE Connectivity Corp. All Rights Reserved. If this document is printed it becomes uncontrolled. Check for the latest revision. SIZE: NTS A SHEET: 1 of 2 CUSTOMER DRAWING ADAPTER PART NUMBER KEY 40 08 - 1 0 - 23 06 10 A Adapter Code A = Shim included Blank = Shim not included Adapter Shell Size Order Number Adapter entry size Connector Manufacturer Code (Code 18 Only) "-" = Not Applicable Device size designator "00" for non-prebraided adapter, Code "0" 1 = with pre-braid adapter and a device 0 = Non-pre-braided adapter and no device Boot size designator Adapter Angle: 0 = straight 1 = 45 degree 2 = 90 degree Field Separator Unless otherwise specified dimensions are in millimeters. (Inches dimensions are shown in brackets) DOCUMENT NO.: REV: T-FIT-2-12X AN ECO NUMBER: ECO-18-000887 If this document is printed it becomes uncontrolled. Check for the latest revision. DATE: 18-Jan-2018 SHEET: 2 of 2