55PC0233-12-9/93/96

SCD SPECIFICATION CONTROL DRAWING Title 55PC0233 Date THREE CONDUCTOR CABLE, UNSHIELDED, UNJACKETED, GENERAL PURPOSE, 600 VOLT Revision 6-10-16 E This specification sheet forms a part of the latest issue of Raychem Specification 55PC. COMPONENT WIRES – 55PC0213 CONSTRUCTION DETAILS PART NUMBER 1/ 55PC0233-26-* 55PC0233-24-* 55PC0233-22-* 55PC0233-20-* 55PC0233-18-* 55PC0233-16-* 55PC0233-14-* 55PC0233-12-* 55PC0233-10-* 55PC0233-8-* 55PC0233-6-* 55PC0233-4-* 55PC0233-2-* 55PC0233-0-* CONDUCTOR SIZE (AWG) 26 24 22 20 18 16 14 12 10 8 6 4 2 0 DIAMETER (inch) LOWER SPEC LIMIT .070 .081 .094 .112 .132 .148 .180 .219 .269 .408 .504 .648 .799 .970 TARGET VALUE .074 .085 .098 .116 .137 .153 .185 .226 .278 .423 .523 .672 .827 1.01 WEIGHT (lbs/1000 ft) UPPER SPEC LIMIT .078 .089 .102 .121 .142 .158 .191 .232 .287 .438 .542 .696 .858 1.04 TARGET VALUE 4.18 6.02 8.82 13.32 20.04 25.46 39.17 60.01 94.65 173. 273. 444. 695. 1043. UPPER SPEC LIMIT 4.60 6.30 9.13 13.68 20.66 26.13 40.06 61.19 96.77 181. 286. 464. 724. 1103. CABLE RATINGS AND ADDITIONAL REQUIREMENTS TEMPERATURE RATING: 200°C Maximum continuous conductor temperature VOLTAGE RATING: 600 volts (rms) at sea level INSULATION FLAWS: Spark Test, 3.0 kV (rms) Impulse Dielectric Test, 8.0 kV (peak) 1/ PART NUMBER: The “*” in the part numbers above shall be replaced by color code designators with a slash separating the component wire colors. Colors shown do not necessarily reflect the sequence of manufacturing. Example: AWG 16, red, yellow and blue component wires; 55PC0233-16-2/4/6 Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice. Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer. 1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER, AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: "901/902..." MAY BE REPLACED BY "Axxx".) OTHER CODES AND SUFFIXES MAY BE ADDED TO THE PART NUMBER, AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER. Raychem, TE Connectivity, TE connectivity (logo), and TE (logo are trademarks. Page 1 of 1 DIMENSIONS ARE IN INCHES AND, UNLESS OTHERWISE DESIGNATED, ARE NOMINAL. THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN. REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID. Raychem Wire & Cable 501 Oakside Avenue Redwood City, CA 94063-3800 Phone: 1-800-227-8816 Fax: 1-650-361-6297 © 2007–2016 Tyco Electronics Corporation. All rights reserved.