736913-000

SPECIFICATION CONTROL DRAWING MATERIALS 1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene fluoride. Recovered I.D.: 1.27 (0.050) max. 2. SOLDER PREFORM WITH FLUX: SOLDER: TYPE Sn63 per ANSI J-STD-006. FLUX: TYPE ROL1 per ANSI J-STD-004. 3. SPACER SLEEVE: Radiation cross-linked modified polyvinylidene fluoride. 4. PRE-INSTALLED PIN: 21 AWG (0.74 (0.029) dia., Solder (Sn63) plated phosphor bronze. APPLICATION 1. This sleeve is designed to splice wires to the per-installed pin. Part will accept 1 or 2 wires having a cross-sectional area (CMA) between 750 and 1250 (range may be extended to 2500 if conductors are pre-tinned). 2. Wires are to be stripped 6.35 – 7.92 (0.250 – 0.312), pre-tinned if necessary, and inserted to the shoulder in the sleeve. The part is then heated, using a Raychem approved infrared or convection heat source and reflector until the solder perform melts, flows and forms a fillet between the conductors and the pre-installed lead. 307 Constitution Drive, Menlo Park, CA 94025, USA Wire and Harnessing Products Unless otherwise specified dimensions are in millimeters. Inches dimensions are in between brackets. Tyco Electronics reserves the right to ANGLES: N/A TOLERANCES: amend this drawing at any time. Users 0.00 N/A should evaluate the suitability of the ROUGHNESS IN 0.0 N/A product for their application. MICRON 0 N/A DRAWN BY: DATE: PROD. REV. M. FORONDA 13-July-01 A TITLE : SOLDERSLEEVE TERMINATOR WITH PIN DOCUMENT NO.: D-141-0171 DCR NUMBER: REPLACES: D010435 DOC ISSUE: 1 If this document is printed it becomes uncontrolled. Checkfor the latest revision. SCALE: None N/A SIZE: A SHEET: 1 of 1