91019-3

Instruction Sheet  Extraction Tool 91019-3 for Type XII Contacts 408-7276 23 JAN 12 Rev C Wire Lead Tool Tip Male Contact Tip Handle Housing Tip Offsets in Cavity Figure 1 Figure 3 1. INTRODUCTION This tool (see Figure 1) is used to extract Type XlI (male and female) Contacts from their housings. A list of the contacts is shown in the table in Figure 2. Read these instructions carefully before using the tool. MALE CONTACT 66258 (66252 LP) 1. Insert the tool tips into the offsets in the cavity. See  Figure 4 . cavity. 66261 (66255 LP) NOTE 66262 (66256 LP) i 66329 (66330 LP) 66259 (66253 LP) 66257 66251 LP) 3.2. Extraction of Female Contact 2. Push the tool into the housing until it bottoms in the CONTACT NUMBER FEMALE CONTACT 5. Remove the contact by pulling it out of the rear of cavity. 66260 (66254 LP) 66326 (66327 LP) Figure 2 The rear section of the handle will back out of the tool. 3. Keeping the tool bottomed in the cavity, push the rear section of thehandle toward thehousing. 4. Remove the contact by pulling it out of rear of the cavity. Wire Lead 2. DESCRITION The tool consists of a sectionalized handle (see  Figure 1) and two tooling tips. 3. EXTRACTION Cavity Housing 3.1. Exraction of Male Contact Tool Tips 1. Pull the rear section of handle back. 2. Keeping sections of handle separated, slide tool tips over male contact and into offsets in cavity. See Figure 3. 3. Push the tips of the tool into the housing until they bottom in the cavity. 4. Keeping the tool bottomed in the cavity, push the rear section of the handle toward the housing. © 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company All Rights Reserved *Trademark Figure 4 4. REVISION SUMMARY Revisions to this instruction sheet include: • Changed company name and logo • Revised title error TOOLING ASSISTANCE CENTER 1-800-722-1111 PRODUCT INFORMATION 1-800-522-6752 This controlled document is subject to change. For latest revision and Regional Customer Service, visit our website at www.te.com TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners. 1 of 1 LOC B